Instruction d'utilisation Faria Instruments Suzuki

Résumé du contenu de la page N° 1

A
7
1
1


-


0
Description: Part Number:
Tachometer 99105-80000/80100
Applications: Installation Time:
Suzuki Marine Boats 1 HRS
NOTE: Weight:
Mounts in standard 3 3/8" hole. 1 lbs
Ref. Part Number Description QTY
Contents
1. 99105-80000/80100 Tachometer 1
2. BC0146 Mounting Bracket 1
3. Mounting Hardware 1
1
30 40
20 50
10 60
RPM
x 100
0 70
1
3
If so equiped
2
YELLOW
BLACK
GRAY
Ref. Tools Description
Tools
1. 3/8" Nut Driver
2. Suzuki Terminal Kit 09900-28701
Required
Please read this m

Résumé du contenu de la page N° 2

Disconnect battery during installation. Tighten nuts on backclamp only slightly more than you can tighten with your fingers. Six inch-pounds of torque is sufficient. Over tightening may result in damage to the instrument and may void your warranty. Gasket cement or other adhesive is not required to secure tubing to fittings. 1. Location: The tachometer should be located at least Mounting Hardware Kit Installation 18” from a magnetic compass. Some interference (erratic operation) may be noti

Résumé du contenu de la page N° 3

Harness Diagram HN0412 rev A ecr 5609 8/05 Green/Orange Green/Orange Green/Orange Yellow Black Yellow Black Black Gray Gray Gray Yellow Heat shrink tubing Black Gray T r ouble Inspection Diagnosis Action T rouble Gauge Sticks A. Backclamp may 1. Slightly loosen nuts 1. If gauge works and is be too tight. holding backclamp. not loose in panel, continue Shooting Check operation. using gauge. 2. If gauge continues to stick, replace gauge. Gauge A. 1. Is power applied

Résumé du contenu de la page N° 4

ouble T r Inspection Diagnosis Action T rouble Gauge A. 1. Fix connection. Inspect the connection 1. Check for insulation is Erratic between the wire and that may have been Shooting the ring connector. pushed into connection. B. 1. 1. Relocate offensive Check for excessive Check wires by appliance. Please electrical noise caused connecting one wire refer to installation by an electrical at a time to the instructions. appliance set to close tachometer directly to the gauge. i