Instruction d'utilisation Edelbrock Performer D16Z6

Résumé du contenu de la page N° 1

PERFORMER X INTAKE MANIFOLD
®
For 1992-1995 Honda Civic EX/Si with D16Z6 Engine
Catalog #4754
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mechanic. If you have

Résumé du contenu de la page N° 2

Disconnect the Throttle Position Sensor and Idle Air Control Motor Install the vacuum fittings into the top of the Performer X intake connectors. Disconnect the PCVvalve hose from the intake manifold (See Fig. 2-B). manifold. Disconnect the fuel return line from the steel chassis fuel line. Disconnect the fuel line from the fuel filter. Disconnect the coolant lines from the throttle body and manifold flange. NOTE: Some coolant will drain from the coolant lines leading into the intake manifold wh

Résumé du contenu de la page N° 3

PERFORMER X INTAKE MANIFOLD INSTALLATION 3. Re-connect all factory sensors and vacuum hoses. Re-connect the 1. Trim the upper edge of the supplied intake manifold gasket (See factory fuel injector wiring harness to the stock fuel injectors, and Fig. 4). re-attach the harness to the fuel rail bracket. Re-connect the stock throttle cable to the bracket and following the factory service manual, adjust the throttle cable for proper operation. 4. Connect the Fuel Filter to the fuel rail and reconnect

Résumé du contenu de la page N° 4

® Edelbrock Corporation • 2700 California St. � Torrance, CA 90503 Tech-Line: 1-800-416-8628 � E-Mail: Edelbrock@Edelbrock.com Catalog #4754 ©2006 Edelbrock Corporation Rev. 10/06 - RS/mc Page 4 of 4 Brochure #63-0255