Instruction d'utilisation Edelbrock 68573

Résumé du contenu de la page N° 1

TUBULAR EXHAUST SYSTEM
Vehicle Applications: See Below
®
Catalog #68572, #68573
#68582, #68583
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Tubular Exhaust System (TES). If you have any
questions, please contact our Technical Hotline at : 1-800-416-8628 from 7 am - 5pm, Monday-Friday, Pacific
Standard Time or e-mail us at Edelbrock@Edelbrock.com.
TUBULAR EXHAUST SYSTEM: These components are designed as a system to improve the exhaust efficiency

Résumé du contenu de la page N° 2

INSTALLATION INSTRUCTIONS DISASSEMBLY 4. Re-install rear power steering support bracket. Do 1. Disconnect battery negative cable from battery. not tighten at this time. 2. Raise vehicle and support with jackstands. 5. Re-install rear A/C support bracket with bolts, lock 3. Use penetrating oil on all nuts and bolts to be washers, and spacers supplied. removed. This will prevent the possibility of broken 6. Align all parts and tighten left side bolts and nuts at or stripped nuts and bolts. this ti

Résumé du contenu de la page N° 3

3. Install U-clamps and tighten all nuts and bolts. NOTE: If shifting rod hits the left manifold when shifting into low gear, remove the rod and straighten the bent section about 5° as required for clearance. This will also lengthen the shifting rod, and it will be necessary to cut off about 3/4" from the end of the Straighten bend about rod to prevent interference with the exhaust system. 5° in two places See Figure 1. 4. Check to be sure that all brake and fuel lines have adequate clearance. 5