Instruction d'utilisation Edelbrock 36011

Résumé du contenu de la page N° 1

EDELBROCK PRO-TUNER EFI PRESSURE SENSORS
®
Catalog #36011, 36020
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before beginning this installation. Most installations can be accomplished with common tools and
procedures. However, you should be familiar with and comfortable working on your vehicle. If you do not feel comfortable performing this installation,
it is recommended to have the installation completed by a qualified mechanic. If you have any questions, please call ou

Résumé du contenu de la page N° 2

B A C 6.0" Close-Up of Connector Pins (Connector Side) Pig-Tail Harness Pro-Tuner Harness A - Ground (Black) Ground (Black/Orange) B - Supply Voltage (Gray) Supply Voltage (Purple/Yellow) C - Output Signal (Light Blue) Output Signal (Yellow) Figure 1 - Pig-Tail Wire Harness and Wire Color-Coding SENSOR SPECIFICATIONS GENERAL SPECIFICATIONS: Input Voltage: 4.9 to 5.1 volts DC Overvoltage: 16 volts DC (maximum) Reverse Polarity: 16 volts DC (maximum) Supply Current: 5 mA (maximum) Response T

Résumé du contenu de la page N° 3

SENSOR CALIBRATION: Edelbrock Pressure Sensors are pre-calibrated for use with Edelbrock Pro-Tuner software. If you are using another aftermarket ECU system, you will need to calibrate the sensors using your software. Refer to the following charts and enter the values required by your software to calibrate the sensors to your software. 36011 - 0-100 PSI Pressure Sensor 36020 - 2-BAR Manifold Absolute Pressure Sensor Output Volts kPa PSIg Output Volts kPa PSIa PSIg in/Hg 0.50 101.3 0.00 0.50 0 0.

Résumé du contenu de la page N° 4

® Edelbrock Corporation • 2700 California St. � Torrance, CA 90503 Tech-Line: 1-800-416-8628 � E-Mail: Edelbrock@Edelbrock.com Catalog #36011, 36020 ©2006 Edelbrock Corporation Rev. 5/06 - RS/mc 4 of 4 Brochure #63-36020