Instruction d'utilisation Edelbrock 17934

Résumé du contenu de la page N° 1

255 Liter/Hr, In Tank Fuel Pump
For 1984-1990 Chrysler Front Wheel Drive Vehicles
Catalog # 17934
INSTALLATION INSTRUCTIONS
PLEASE study these instructions carefully before installing your new In-Tank Fuel Pump for 1984-1990 Chrysler Corporation,
Front Wheel Drive vehicles. If you have any questions or problems, do not hesitate to contact our Technical Hotline at:
1-800-416-8628, from 7am-5pm PST, Mon-Fri, or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail your
warranty car

Résumé du contenu de la page N° 2

INSTALLATION PROCEDURE • Note: Steps shown in these instructions are intended as FUEL TANK REMOVAL a general guideline only. If you are not an experienced (Caution: The fuel tank can be quite awkward to mechanic, you should have a copy of your service remove due to its size and weight. Obtain help manual on hand. The installation procedure for replacing during its removal). your factory fuel pump is covered in full detail in your (Note: The following instructions may not be specific factor

Résumé du contenu de la page N° 3

FUEL TANK REMOVAL (continuation) PUMP REMOVAL 4. Disconnect the electrical connector at the fuel tank to main harness connector. Disconnect the fuel lines • Note: See Fig. 2 and 3 for reference during the leading to the tank. Support and partially lower the removal and installation procedure. tank, if needed. 5. Remove the fuel filler neck, if necessary. 1. Remove the filter. The filter may be attached with a 6. Support the fuel tank and remove the retaining straps to clamp. If so, cut and

Résumé du contenu de la page N° 4

PUMP INSTALLATION PUMP INSTALLATION (Continuation) 1. Connect the electrical connections using the supplied • Note: Your pump may be mounted in one of two ways, wire harness and butt splice connectors, making sure if mounted as shown in Fig. 2, read “Type A Installation” proper polarity is maintained. below. If mounted as shown in Fig. 3, continue to “Type 2. Install the proper fuel filter for your application. Type A B Installation further down. units press onto the bottom of the fuel pump.

Résumé du contenu de la page N° 5

WRAP UP TROUBLESHOOTING 1. Using only equipment approved for use with gasoline, refill the fuel tank with gasoline. (Note: Always clean Should the fuel pump fail to operate: any gasoline spills immediately). 2. Inspect the fuel system for leaks. Repair any leaks 1. Check the fuel pump fuse and fuel pump relay as before proceeding. outlined in the factory service manual. 3. With the ignition switch off, reconnect the fuel injector 2. If the pump has power and proper polarity, check the wiring h