Résumé du contenu de la page N° 1
Register your product and get support at
www.philips.com/support
22PFL4505D
19PFL4505D
EN: For further assistance, call the customer support service in your country.
• To obtain assistance in the U.S.A., Canada, Puerto Rico, or the U.S. Virgin Islands, contact Philips
EN User Manual Customer Care Center at 1-866-309-0841
• To obtain assistance in Mexico, contact Philips Customer Care Center at 01 800 504 62 00
Enter below the model and serial numbers located on the back and right side of the TV
Résumé du contenu de la page N° 2
Contents 9 Connect devices 27 1 Notice 4 Connection overview 27 Selecting your connection quality 28 2 Important 5 Connecting your devices 29 Product information 5 Screen care 5 10 Troubleshooting 31 Environmental care 5 Downloading an electronic copy 31 Regulatory notices 5 Contact us 31 3 Your TV 6 11 Notes for the use of USB devices 32 Side controls and indicators 6 Remote control 6 12 Specifi cations 33 4 Get started 8 Supplied accessories 8 13 Warranty 34 Mounting stand
Résumé du contenu de la page N° 3
Return your Product Registration Card or register online at www.philips.com/support today to get the very most from your purchase. Registering your model with PHILIPS makes you eligible for all of the valuable benefits listed below, so don't miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/support to ensure: *Proof of Purchase *Product Safety *Additional Benefits Notification Returning the enclosed card guarantees By registering your
Résumé du contenu de la page N° 4
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. C. The appliance has been exposed to rain; or 2. Keep these instructions. D. The appliance does not appear to operate normally or exhibits a 3. Heed all warnings. marked change in performance; or 4. Follow all instructions. E. The appliance has been dropped, or the enclosure damaged. 5. Do not use this apparatus near water. 17. Tilt/Stability - All televisions must comply with recommended 6.
Résumé du contenu de la page N° 5
Modifi cations 1 Notice The FCC requires the user to be notifi ed that any changes or modifi cations made to this device that are not expressly approved by Philips Consumer Electronics may void the user’s authority to operate the equipment. Specifi cations are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective Cables owners. P&F USA reserves the right to change products at any time Connections to this device must be made w
Résumé du contenu de la page N° 6
Environmental care 2 Important Registering your model with Philips makes you eligible for all of the valuable benefi ts listed below, so don’t miss out. Complete and return your Product Registration Card at once, or register online at www.philips.com/support to ensure: • Proof of Purchase Returning the enclosed card guarantees that your date of purchase is on fi le, so no additional paperwork is required from you to obtain warranty service. The packaging of this product is intended to be
Résumé du contenu de la page N° 7
Remote control 3 Your TV Congratulations on your purchase, and welcome to Philips! To fully benefi t from the support that Philips offers, register your product at a www.philips.com/support b Side controls and indicators s c * r d q f p e e f g d o h c b a a Standby indicator / remote control sensor n i b Ambient light sensor When in [Home] mode, this TV will automatically adjust the brightness based on the ambient light. If there is a sudden change j in TV brightness, it may be due to ch
Résumé du contenu de la page N° 8
c FORMAT Selects a picture format (see ‘Changing picture format’ on page 16). d SAP ( ) Digital Mode DTV • Press to select the audio language. Analog Mode (TV) • Press to select the audio mode. e FREEZE Press to pause screen image. f OK Activates a selection or accesses the menu. g Î ï Í Æ (Navigation buttons) Navigates through the menus. h INFO Displays information about the TV channel or accessory device. The quality and accuracy of the information depends on the broadcaster. You might see
Résumé du contenu de la page N° 9
Tilt stand 4 Get started You can adjust the stand to change the angle of the unit (-2° to 10°). -2° 10° Supplied accessories • Remote Control • 2 x AAA, 1.5V Batteries • M4 x 10 double sems screw x 2 • AC Power cord • Cable management tie • User Manual • Quick Start Guide Mounting stand onto TV P ositioning the TV Applicable to TVs without mounted stands. 1 Warning • Do not insert the AC power cord into the power socket outlet before all the connections are made. • Large screen TVs
Résumé du contenu de la page N° 10
If you connect a set-top box through RF IN / OUT Connecting the antenna or cable If the TV is connected to a cable box or satellite set-top box via a coaxial connection, set the TV to channel 3 or 4, or to the channel specifi ed by the service provider. Cable If you connect to an antenna Any DTV programs that are broadcast in your area can be received for If you connect a set-top box through HDMI free through an antenna connection. If the TV is connected to a cable box or satellite set-top
Résumé du contenu de la page N° 11
Managing cables Plugging in the AC power cord Route your antenna cable and all other cables through the cable holder W arning at the back of the TV. The holder helps keep your cables tidy and easily manageable. • V erify that your power voltage corresponds with the voltage printed at the back of the TV. Do not insert the AC power cord if the voltage is different. 1 Attach the cable holder as illustrated below. 1 Locate the power connector at the back of the TV. The location of the power con
Résumé du contenu de la page N° 12
Press Í or Æ 5 times to select the side of the pictures that is the most Switching on and initial setup pleasing to you. then press OK. Before you switch on the TV, check that the AC power cord is properly . . connected. Press POWER at the right side of the TV, or press on Left side Right side the remote control. The TV normally takes 25-30 seconds to start up and the following screen appears the fi rst time you turn on the TV. Initial Setup Initial Setup English Select your menu languag
Résumé du contenu de la page N° 13
Switching channels 5 Use your TV This section helps you perform basic TV operations. Switching on your TV and putting it in stand-by mode Press CHANNEL + / − on the side of the TV. For digital channels, press a number (1 to 135) followed by a dot “ ” and then the corresponding • sub channel number (1 to 135). e.g. 108.30. • Press CH + / − or enter a number on the remote control. • Press PREV CH to return to the previously viewed channel. To switch on • Press . POWER at the side of the TV o
Résumé du contenu de la page N° 14
Adjusting v olume Still mode You can pause the image shown on the TV screen. Press FREEZE to pause the image shown on the TV screen. FREEZE Freeze • The sound output will not be paused. • If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted. • The still function will be released after 5 minutes. To cancel still mode, press any button except . (Standby-On). Watching channels from a set-top box To watch channel
Résumé du contenu de la page N° 15
Watching a Blu-ray disc Switching audio mode To watch a Blu-ray Disc This section describes how to switch the audio language in the digital mode and how to switch the audio in the analog mode. 1 Insert a Blu-ray Disc into your player. 2 Press ► (play) on the remote control of the Blu-ray Disc player. DTV » The Blu-ray Disc might automatically play on the TV. If the picture does not appear 1 Press SAP to display the currently selected language and the number of available languages. 11.1 11.1
Résumé du contenu de la page N° 16
PC settings 6 Use more of your TV This function lets you adjust the PC screen position, clock and phase during PC input. 1 Press MENU on the remote control and select [Features] > Changing pictur e and sound settings [PC Settings]. Y ou must set [Home] in [Location] (refer to page 21). 2 Adjust the setting. Otherwise, personalized picture and sound settings will not be [Auto Adjustment] memorized after the unit goes to stand-by mode. Î ï Press or to select [Adjust], then press OK. • The
Résumé du contenu de la page N° 17
For 4:3 video signal Changing pictur e format 1 Press FORMAT on the remote control. [][ ] Normal 16:9 Î ï 2 Press or to select a picture format and press OK to confi rm your choice. [ ] Movie Expand Summar y of picture formats 5 types of display modes can be selected when the broadcasting station is sending 16:9 or 4:3 video signal. And 3 types of display modes can be selected for PC input signal. For 16:9 video signal [ ] [ ] Wide Zoom Normal Display a 4:3 picture at its original size. Sid
Résumé du contenu de la page N° 18
[ ] TV Speakers Using y our TV as a PC monitor This option will allow you to select the audio output from the Use a VGA connector to connect a PC to your TV. For sound, add an unit’s speakers. If you have an amplifi er which is compatible with audio cable with a stereo mini jack. the HDMI CEC function connected to this unit using an HDMI cable, some sound operations such as volume up can be used with Caution this unit’s remote control. Press Î or ï to select the desired option, then press
Résumé du contenu de la page N° 19
Sleeptimer You can always put your TV in stand-by mode earlier or reset the Picture sleeptimer during the countdown. Video Sound Component Press SLEEP to set the sleep timer. Setup HDMI 1 Features Sleep Off HDMI 2 Language Sleep timer display appears on the TV screen. PC USB 40.1 DTV Press SLEEP repeatedly to change the amount of time (in increments of 30 minutes up to 120 minutes). BACK OK Back Select View / Block Sleep 120min. 3 Press Î or ï and then press OK repeatedly to switch betwee
Résumé du contenu de la page N° 20
Summary of TV ratings Summary of US movie ratings Rating Description Age rating Content rating TV -Y : Appropriate for children of all ages None NR Not rated. with themes and elements suitable for G Movies with a mild content, suitable for all ages. children aged 2-6. PG Movies for which parental guidance is recommended. TV -Y7 : Programs designed for children age 7 [FV] (Fantasy Violence) They may contain a few racy or violent scenes or and older. maybe some bad language. T
