Instruction d'utilisation Audiovox AS-PASS II

Résumé du contenu de la page N° 1

INSTALLATION GUIDE FOR:
ADAPTOR FOR GM
PASS LOCK
AS-PASS II
The AS-PASS II adaptor is an adjustable circuit designed to allow the interface of a remote car starter into a GM vehicle equipped
with a Pass Lock theft deterrent system. The unit has on board an adjustable resistor with a range of 2.2 ohms to 17.9 K ohms.
INSTALLATION:
MOUNTING THE MODULE:
It is necessary to remove the top and bottom halves of the steering column shrouds to gain access to the Pass Lock wiring, and the
(cranklow) bulb

Résumé du contenu de la page N° 2

vehicles Pass Lock resistance. To do this: Temporarily connect the Grey wire to chassis ground. Connect the Red test lead of your Ohm Meter to the Red wire of the control module. Connect the Black test lead of your Ohm Meter to chassis ground. Turn the ignition switch to the "on" position. Confirm that the resistance reading is the same as measured in Step 3. Adjust the potentiometer as necessary to match the factory resistance reading taken earlier. Turn the ignition switch to the off positio

Résumé du contenu de la page N° 3

PASSLOCK PASSLOCK II NOTE: Because in the Pass Lock II application, requires the Red/White and Yellow 14 AWG wires be used to control the on board relays of the Pass Lock module, if the remote start unit you are using does not have two true ignition circuits, (Wires that provide an output during the on and start sequences) it will be necessary in certain applications to add a second ignition circuit. For these applications two relays can be connected as shown below: Pass Lock and Pass Key ar