Résumé du contenu de la page N° 1
2-320-060-11 (1)
R
LCD Colour TV
GB
Operating Instructions
Before operating the TV, please read the “Safety Information”
section of this manual. Retain this manual for future reference.
RU
Инструкция по эксплуатации
Перед тем как включить телевизор, просим Вас ознакомиться
с разделом "Общие правила техники безопасности"
настоящей инструкции. Сохраняйте настоящую инструкцию
на будущее.
PL
Instrukcja obsługi
Przed przystąpieniem do eksploatacji telewizora należy
zapoznać się z rozdziałem "Inf
Résumé du contenu de la page N° 2
Introduction • Thank you for choosing this Sony product. • Before operating the TV, please read this manual thoroughly and retain it for future reference. • Symbols used in the manual: • Important information. • Buttons shaded white on the remote control show you the buttons you have to press to follow the sequence of the • Information on a feature. instructions. • 1,2... Sequence of instructions. • Informs you of the result of the instructions. Table of Contents Introduction ......
Résumé du contenu de la page N° 3
Safety Information Mains lead Medical institution Unplug the mains lead when Do not place this TV set in a moving the TV. Do not move place where medical the set with the mains lead equipment is in use. It may plugged in. It may damage the cause malfunction of medical mains lead and result in fire or instruments. electric shock. If the set has been dropped or damaged, have it checked immediately by qualified service personal. Damage requiring service Carrying If the surface of the displ
Résumé du contenu de la page N° 4
Power Sources Overloading Mains lead protection This TV set is designed to operate Pull out the mains lead by the on a 220-240V AC supply only. plug. Do not pull on the mains Take care not to connect too lead itself. many appliances to the same mains socket as this could result Wiring in fire or electric shock. Unplug the mains lead when wiring cables. Be sure to Mains unplug the mains lead for your safety, when hooking up. Do not use a poor fitting mains socket. Insert the plug fully in
Résumé du contenu de la page N° 5
Installation and moving Ventilation Outdoor use Never cover the ventilation holes in the Do not install this TV set cabinet. It may cause overheating and outdoors. If the TV set is exposed result in fire. Unless proper ventilation is to rain, it may result in fire or provided, the TV set may gather dust and electric shock. If the TV set is get dirty. For proper ventilation, observe exposed to direct sunlight, the TV the following: set may heat up and it may • Do not install the TV set turn
Résumé du contenu de la page N° 6
Precautions On viewing the TV comfortably • To view the TV comfortably, the recommended viewing position is from four to seven times of the screen’s vertical length away from the TV set. • View the TV in a moderate light room, as viewing the TV in poor light taxes your eyes. Watching the screen continuously for long periods of time can also tax your eyes. On installing the TV set • Do not install the TV in places subject to extreme temperature, for example in direct sunlight, or near a radiat
Résumé du contenu de la page N° 7
Overview & Installation Checking the Accessories supplied 1 Remote 1 Mains Lead (Type C-6): 2 Batteries (AA size): control (RM-Y1108): 8 Overview & Installation
Résumé du contenu de la page N° 8
Overview of Remote Control Buttons 1 Muting the Sound: Press this button to mute the sound from the TV. Press it again to cancel. 2 1 2 TV I/ - Switching the TV to the standby mode: 4 Press this button to temporarily turn off the TV and switch it to standby mode (the 3 5 (Standby/Sleep) indicator on the TV lights up in red). Press again to switch on the TV from standby mode. 6 • To save energy, we recommend switching the TV off completely when the TV is not in use. 7 8 • If no signal is r
Résumé du contenu de la page N° 9
2 qs V / v / B / b / OK Buttons: 1 a) When the menu is displayed: use these buttons to operate the menu 4 system. For more details, refer to "Introducing and Using the Menu 3 5 System" on page 17. b) When the menu is turned off: press OK to show an overview of all TV 6 Channels. Then press V or v to select the channel and press OK to watch the selected channel. 7 8 qd Selecting the TV mode: Press this button to switch off Teletext or video 9 input. qa q; qf Selecting Teletext: Press this b
Résumé du contenu de la page N° 10
Overview of the TV Buttons and side Connectors Overview of the TV Buttons Picture Freeze press this button to Volume control Power On / Off (+/-) freeze the picture. For more details GB refer to “Picture Freeze” on page 27. Auto Start Up press and hold this Selecting Input Source Programme Up or button for three seconds to start the for more details refer to Down (selects TV “Viewing pictures from channels) Auto Start Up sequence. For more equipment connected to details refer to “Switching
Résumé du contenu de la page N° 11
SONY CORPORATION JAPAN/4 Overview of the TV indicators Lights up in green when the TV is switched on. • Lights up in red when the TV is in standby mode. • Flashes red when a button is pressed on the remote control. • Lights up in red when the sleep timer is set. For more details, refer to “Sleep Timer” on To operate the remote page 27. control, point it towards this receiver. Inserting Batteries into the Remote Control Make sure you insert the supplied batteries using the correct po
Résumé du contenu de la page N° 12
Removing the Rear Cover When you connect the cables, remove the rear cover of the TV set. Be sure to attach the rear cover back on the TV set after you finish connecting the cables. Removing the rear cover Hold the rear cover as illustrated below and pull off one side of the lower part of the cover towards you first. Then, detach the upper part of the cover from the TV set. GB Attaching the rear cover Hold the rear cover as illustrated below, fitting the four detents on the rear cover into the
Résumé du contenu de la page N° 13
Connecting the Aerial and VCR or VCR Make sure to connect the aerial before the Scart. For more details regarding VCR connection, refer to “Connecting Equipment to the TV” on page 29. 14 Overview & Installation
Résumé du contenu de la page N° 14
First Time Operation Switching On the TV and Automatically Tuning The first time you switch on your TV, a sequence of menu screens appear on the TV enabling you to: 1) choose the language of the menu screen 2) choose the country in which you are going to operate the TV, 3) search and store all available channels (TV Broadcast) and 4) change the order in which the channels (TV Broadcast) appear on the screen. However, if you need to change any of these settings at a later date, you can do tha
Résumé du contenu de la page N° 15
5 The Auto Tuning menu appears on the screen. Press the OK Do you want to start automatic tuning? button to select Yes. Yes No 6 The TV starts to automatically search and store all Auto tuning available broadcast channels for you. Programmes found: This procedure could take some minutes. Please be patient and do not press any buttons, otherwise automatic tuning will not be completed. If no channels were found during the auto tune process, a No channel found. message appears automatically
Résumé du contenu de la page N° 16
TV Functions Introducing and Using the Menu System Your TV set uses an On-Screen menu system to guide you through the operations. Use the following buttons on the Remote Control to operate the menu system: Picture Adjustment 1 To switch on the menu screens: Picture Mode Personal Contrast 80 Press the MENU button to switch the first level menu on. Brightness 50 Colour 50 Sharpness 50 Backlight 70 Reset Noise Reduction Auto Colour Tone Normal Select: Set: OK End: MENU GB 2 To navigate through th
Résumé du contenu de la page N° 17
The Picture Adjustment Menu The “Picture Adjustment” menu allows you to alter the picture settings. To do this: Picture Adjustment Picture Adjustment Press the MENU button and then press OK to Personal Picture Mode Personal Picture Mode enter this menu. Next, press v or V to select the 80 Contrast 80 Contrast Brightness 50 Brightness 50 50 Colour 50 Colour desired option and press OK. Finally, read below 50 Sharpness 50 Sharpness Backlight 70 , Backlight 70 how to operate into each option.
Résumé du contenu de la page N° 18
Reset Press OK to reset the picture to the factory preset levels. Noise This option is set to Auto to automatically reduce the snowy picture visible in the weak broadcast Reduction signal. However, it can be modified. After selecting this option press b. Next, press v or V to select Off. Finally, press OK to store. Colour Tone This option allows you to alter the tint of the picture. After selecting this option press b. Next, press repeatedly v or V to select: Warm (gives the white colours a re
Résumé du contenu de la page N° 19
The Sound Adjustment Menu The “Sound Adjustment” menu allows you to Picture Adjustment Picture Mode Personal alter the sound settings. Contrast 80 Brightness 50 Colour 50 Sharpness 50 To do this: Backlight 70 Reset Noise Reduction Auto Press the MENU button and press v to select Colour Tone Normal , then press OK to enter this menu. Next, press v or V to select the desired option and Select: Set: OK End: MENU press OK. Finally, read below how to operate m into each option. Sound Adjustmen
Résumé du contenu de la page N° 20
The Features Menu The “Features” menu allows you to alter Picture Adjustment various settings of the TV. Picture Mode Personal Contrast 80 Brightness 50 Colour 50 Sharpness 50 To do this: Backlight 70 Reset Noise Reduction Auto Press the MENU button and press v twice to Colour Tone Normal select , then press OK to enter this menu. Next, press v or V to select the desired option Select: Set: OK End: MENU and press OK. Finally, read below how to m operate into each option. Features Features
