Résumé du contenu de la page N° 1
Ultra Na vGPS
INSTALLATION AND OPERATION
INSTRUCTIONS
F:1
TM
LITHO IN U.S.A. 988O1 06-61
EAGI
PDF compression, OCR, web-optimization with CVISION's PdfCompressor
Résumé du contenu de la page N° 2
NOTES: © Electronics. All reserved. Copyright 1991, Eagle rights WARNING! A USE THIS GPS RECEIVER ONLY AS AN AID TO NAVIGATION. CAREFUL NAVIGATOR NEVER RELIES ON ONLY ONE METHOD TO OBTAIN POSITION INFORMATION. CAUTION This all GPS will show the GPS receiver, (like navigation equipment) most direct to a It data to the shortest, path waypoint. provides navigation of obstructions. the Therefore, waypoint regardless prudent navigatorwill not take of all available tools when to only
Résumé du contenu de la page N° 3
NOTES: SONAR TABLE OF CONTENTS INTRODUCTION . MOUNTING . POWER CONNECTIONS .2 GPS MODULE INSTALLATION 3 SURFACE MOUNT-w/REAR ACCESS 4 SURFACE MOUNT /o REAR ACCESS 4 POLE MOUNT 5 TRANSDUCER CONNECTIONS 6 KEYBOARD BASICS 6 DISPLAY 8 SONAR OPERATION 9 AUTOMATIC 9 SENSITIVITY 9 GRAYLINBTh 11 RANGE 12 AUTOMATIC 12 MANUAL 12 ZOOM 13 AUTOMATIC 13 MANUAL 14 MENUS 14 SONAR MENU-PAGE 1 15 CI-IARTSPEEO 15 FISHID 16 ALARMS 17 FISH ALARM 17 ZONEALARM ID DEPTH ALARMS 19 A
Résumé du contenu de la page N° 4
NOTES: PDF compression, OCR, web-optimization with CVISION's PdfCompressor
Résumé du contenu de la page N° 5
NOTES: INTRODUCTION The in UltraNavGPS one of the best values sonar represents sportlishing It rivals other sonar units much more in features and today. costing With its the UltraNavGPS offers menus, performance. easy-to-use atthetouch of a button. The screen shows the underwaterworld operation with resolution and detail. The UltraNavGPS also high displays digital boat surface water and distance travelled depth, speed, temperature, if the sensor is (distance optional (model lo
Résumé du contenu de la page N° 6
NOTES: After the cables have been fill the hole with a marine routed, good sealing Offset the bracket to cover the hole. Route the cable power compound. in the bracket for the the slot and break out one of the other slots through transducer cable. o o 0 0 NOTCHES SLOT POWER CONNECTIONS For the The tJltraNavGPS works from a twelve-volt battery system only. best attach the cable the You can attach results, power directlyto battery. the cable to an or however have buss, you
Résumé du contenu de la page N° 7
NOTES: TO OPTIONAL SPEED/TEMP SENSOR FUSE TO OPS MODULE TO AUTOPILOT OR OTHER MARINE EQUIPMENTS NMEA INTERFACE Attach the GPS module's cable to the UltraNavGPS's cable. Tags power on the cables both the GPS and the identify optional speed/temperature sensors connector. See the GPS section in this manual for GPS module installation. GPS MODULE INSTALLATION The GPS module can be installed on a flat surface or the (with supplied on a Mount the module in an area that a adapter
Résumé du contenu de la page N° 8
NOTES: - Surface With Access Mounting the use the If have access underneath surface, mounting gasket you module as a Mark and drill four furnished with the GPS template. screws and one 14 mm 5.5mm holes for the mounting (9/16") (7/32") Attach the cable to the module and it hole for the module's cable. pass in and the surface. Use down the hole the gasket mounting through lock washers to fasten the OPS four 5 mm flat and screws, washers, the surface. Route the 25' GPS ca
Résumé du contenu de la page N° 9
ULTRANAVGPS SONAR SPECIFICATIONS UItraNavGPS Dimensions 5.875"H x 7.75"W x 3.875"D 10-15 vDO Input Voltage Current 500 ma (lights off) 650 ma (lights on) fl,o Transmitter 192 kHz Frequency "\ Myl
Résumé du contenu de la page N° 10
CONNECTIONS TRANSDUCER ENTER MENU Toturnthesimulatoron, key, pressthe included with the unit for transducer See the transducer owner's manual F' CF then the to the "CHANGE press key adjacent OFFSET installation instructions. SETUP" label. Now the next to the press key below 'MORE" label until the screen shown .4 "SIM ON" Press the next to the key appears. KEYBOARD immedi- label. The simulator mode starts in the The has in two vertical columns. The keys arranged keys I
Résumé du contenu de la page N° 11
GPS MODULE SELF-TEST - ON The ON turns the Ultra on. key This feature tests the GPS module and returns a code. This code special is of interest to the service the UltraNavGPS However, only department. - off. OFF Press and HOLD the Off to turn the UltraNavGPS key this code and a status either "MODULE interprets displays message, PASSED" or "MODULE FAILED". The number current software version - GPS mode to the SONAR This switches the UltraNJavGPS from the also at the bottom of
Résumé du contenu de la page N° 12
SELECT UNITS OF MEASURE TURN BACKLIGHT ON ALITO ,F 0 SET SPEAKER VOLUME ADJUST DISPLAY CONTRAST I}53FT 4C I the These menus are of the ones found in the sonar menus. See duplicates sonar section for more information on these features. METRICI )
Résumé du contenu de la page N° 13
NMEA COMMUNICATION SONAR OPERATION cable sends data out the white wire on the The UItraNavGPS power Electronics set the NMEA Marine to standanis according by (National allows the UltraNavGPS AUTOMATIC This _____________________ Association). feature is and infor- is first turned the Automatic to send When .the UltraNavGPS on, depth, navigation position, IS: OUTPUT the screen. such as the word "AUTO" at the of mation to "listener' enabled. This is indicated top units, chart
Résumé du contenu de la page N° 14
___________ For are anchored at a location that is example, suppose you accurately marked on a chart. Your UltraNavGPS a that is displays longitude position q3•3rT -20 .010 less than the one on the chart. the Position Correction degrees Using ec Factor Offset make the UltraNavGPS read the same as feature, (PCF) you the If chart. raise anchor and the UltraNavGPS will add the move, you made to all This makes it more match the change you positions. closely e datum used the cha
Résumé du contenu de la page N° 15
CHANGING STARTUP SETFINGS GRAYLINE® on for the first time. The UItraNavGPS must be initialized when it's turned and weak echoes. It GRAYLINE lets between strong you distinguish of the GPS section in this manual. This is described at the beginning value. This allows on that are a "paints" gray targets strongerthan preset as if wish to one of the However, change only parameters (such time), you For to tell the difference between a hard and soft bottom. example, you menu. To d
Résumé du contenu de la page N° 16
left. - •- S_S!_ Thesatellitenumber(SAT)inusebythechannelshowstotherightof - flMflUC uwmauc Azimuth is the direction of the satellite from the channel number. your When turned on for the first the UItraNavGPS time, automatically places is the of the satellite above the horizon. location. Elevation present height the bottom in the lower half of the screen. This is called Auto signal SIG is the ratio. The the the better. Channel SNR, signal-to-noise higher be and is of the auto
Résumé du contenu de la page N° 17
CDI Alarm and Range ZOOM the CDI alarm also CDI Changing changesthe r ARRIVAL is a common method used to show or the Enlarging "zooming" picture on the screen. To the change range steering ALARM ___ two different small detail and fish The UltraNavGPS signals. gives you CDI alarm first the MENU - settings, press key. o.sa a screen zoom The zoom and zoom sizes, option. operation plus split to the "GPS Then the press key adjacent in and manual modes. is different the au
Résumé du contenu de la page N° 18
ERASING A ROUTE - ZOOM MANUAL MODE until the "ROUTES" label To erase a the MENU route, key appears, press in manual the When the zoom white the unit is the mode, key you press selection screen shown on then the next to that label. The route press key in the 4X screen shown below The unit is automatically placed appears. Press the "UP" or "DOWN" the the adjacentto previous page appears. keys zoom For a 2X the to the 2X/4X mode. zoom, simply press key adjacent When the desir
Résumé du contenu de la page N° 19
FOLLOWING A ROUTE the to the CLEAR label. There are sonar menus key adjacent eight To follow MENU until a the route, press key RTE: *01 accessible with the menu The menu shows different menus, key. key the "ROUTES" the label appears, theqpress 030105 on which mode the unit is in. For it a sonar screen depending example, next to that label. The screen shown at key is the menu will show the first sonar menu screen. showing, pressing key This is the route selection right appea
Résumé du contenu de la page N° 20
"EDIT ROUTE" Now the next to the key press - 1 SONAR MENU PAGE ROUTE label. The screen shown below E011 right ap- _ This is the selection menu. waypoint pears. 'ERASE ROUTE This lets choose which are to you waypoints FISH 1.0. be in route. The first placed your waypoint's as fish. The Fish 1.0. feature identifies that meet certain conditions targets RTE FORWARD number and location in the center of appears The all echoes and eliminates surface clutter, micro-computer a
