Résumé du contenu de la page N° 1
FAX Option Type 1018
Operating Instructions
Facsimile Reference (option)
>
ZEQH010N.eps
Read this manual carefully before you use this product and keep it handy for future
reference.
For safety, please follow the instructions in this manual.
Résumé du contenu de la page N° 2
Résumé du contenu de la page N° 3
USA ❖❖ FCC Requirements ❖❖ 1. This equipment complies with Part 68 of the FCC rules. On the cover of this equipment is a label that contains, among other information, the FCC registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the tele- phone company. 2. This equipment uses the following USOC jack: RJ11C An FCC compliant telephone cord and modular plug is provided with this equipment. This equip- ment is designed to be co
Résumé du contenu de la page N° 4
Available Options • Handset (Handset Type 1018) Supplies • Marker Ink (Marker Type 30 is recommended for the best performance)
Résumé du contenu de la page N° 5
NOTICE R CAUTION: Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Shielded interconnect cables must be employed with this equipment to ensure compliance with the pertinent RF emission limits governing this device. Direct (or indirect reflected) eye contact with the laser beam may cause serious eye damage. Safety precautions and interlock mechanisms have been designed to prevent any possible laser beam exp
Résumé du contenu de la page N° 6
Note to users in the United States of America - -Notice: - - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential in- stallation. This equipment generates, uses and can radiate radio frequency ener- gy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio com
Résumé du contenu de la page N° 7
Important Safety Instructions Caution When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, includ- ing the following: • Do not use this product near water, for example, near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. • Avoid using a telephone during an electrical storm. There may be a remote risk of electric shock from lightning. • Do not use a
Résumé du contenu de la page N° 8
How to Read this Manual Symbols In this manual, the following symbols are used: R WARNING: This symbol indicates a potentially hazardous situation that might result in death or serious injury when you misuse the machine without following the in- structions under this symbol. Be sure to read the instructions, all of which are de- scribed in the Safety Information section in the Copy Reference manual. R CAUTION: This symbol indicates a potentially hazardous situation that might result in mi- nor o
Résumé du contenu de la page N° 9
TABLE OF CONTENTS Manuals for This Machine......................................................................... 1 Basic Features (this manual) ........................................................................ 1 Advanced Features ...................................................................................... 1 1.Getting Started Guide to Components............................................................................... 3 Front View .........................................
Résumé du contenu de la page N° 10
Dialing....................................................................................................... 30 Number Keys .............................................................................................. 30 Quick Dials .................................................................................................. 32 Speed Dials................................................................................................. 33 Groups ...........................................
Résumé du contenu de la page N° 11
Manuals for This Machine Two Facsimile Reference manuals are provided, the Basic Features manual and the Advanced Features manual. Please refer to the manual that suits your needs. Basic Features (this manual) The Basic Features manual explains the most frequently used fax functions and operations. Advanced Features The Advanced Features manual describes more advanced functions, and also explains settings for key operators. ❖ ❖❖ ❖ Chapter 1 Transmission Options Explains about sending at a spec
Résumé du contenu de la page N° 12
2
Résumé du contenu de la page N° 13
1. Getting Started Guide to Components Front View 1. Document Feeder (ADF)/Platen 2. Exposure Glass Cover (Option) Place the original face down on the upper Holds a document stack of up to 30 left corner of the exposure glass, aligning sheets which are fed automatically one at the upper left corner with the reference mark. Close the platen cover when you a time.Place documents face up here. set a document on the exposure glass. 3
Résumé du contenu de la page N° 14
Getting Started 3. Handset (Option) This permits voice communication. 4. Main Power Switch If the machine dose not operate after turning on the operation switch, check if 1 the main power switch is turned on. If it is off, turn it on. However, if the machine is installed with the fax option, do not turn the main power switch off. Note ❒ As the main power switch is normally set by your service representative, do not touch this switch. ❒ If the operation switch is on and there is still no power, t
Résumé du contenu de la page N° 15
Guide to Components Rear View 1 1. Bypass Tray 2. G3 Line Connector Select this tray for non-standard size pa- 3. Optional Handset/External Tele- per. phone Connector See Chapter 2 “Copying from the Bypass Tray” in the Copy Reference. 5
Résumé du contenu de la page N° 16
Getting Started Operation Panel 1 1. Receive File Indicator 10.0000 1111 keys Lights to tell you a message has been re- Press to move the cursor or select func- ceived into memory. tions. 2. Communicating Indicator 11.{{OK}} key {{ }} Lights during transmission or reception. Press to answer "Yes" to a question dis- played on the display. 3.{{{{Job Information}}}} key 12.{{{{Speed Dial}}}} key Press to search for information on a spe- cific job. Press to select a Speed Dial. 4. Transmission Opti
Résumé du contenu de la page N° 17
Operation Panel 19. User Function keys 28. Operation switch Each of these can be programmed for Press this switch to turn the power on rapid access to frequently used features. (the On indicator goes on). To turn the power off, press this switch again (the On ❖❖ Features Programmed by Default ❖❖ indicator goes off). 1 Key Function F1 Manual Reception F2 Reception Mode F3 Stamp 20.{{Resolution}} key {{ }} Press to switch between Standard, Detail and Fine. 21.{{{{Image Density}}}} keys (iiii and
Résumé du contenu de la page N° 18
Getting Started Starting the Machine To start the machine, turn on the op- eration switch. Turning On the Power 1 Note A Confirm that the power cord is ❒ This machine automatically enters plugged into the wall outlet firm- Energy Saver mode or turns itself ly and the Main Power switch is off if you do not use the machine on. for a while. See Chapter 2 “Settings You Can Change with the User B Turn on the operation switch. The Tools” in the System Settings. On indicator should light. The panel dis
Résumé du contenu de la page N° 19
Starting the Machine Turning Off the Power A Turn off the operation switch. The On indicator will go out. 1 Important ❒ Before you unplug the power cord, confirm that the display in Facsimile mode indicates that the remaining memory space is 100%. ❒ Fax files stored in memory will be deleted an hour after you turn the Main Power switch off or you unplug the power cord. 9
Résumé du contenu de la page N° 20
Getting Started Switching Between Copy Mode and Facsimile Mode 1 This machine is both a fax and a copier. When you turn on the power switch, the copier screen is shown and the machine is ready to make copies. When you wish to use fax functions, press the {Facsimile} key. You can set this machine to display facsimile mode immediately after the power switch is turned on. See Chapter 2 “Setting You Can Change with the User Tools” in the System Settings. Limitation ❒ You cannot switch modes under t
