Instruction d'utilisation Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1

Résumé du contenu de la page N° 1

INSTALL INSTRUCTIONS C-TM-IMP-1
HEAVY DUTY TRAK MOUNT
2006-2009 CHEVROLET IMPALA

TOOLS REQUIRED:
Ratcheting wrench Open-end wrench set
Standard Socket set Screwdriver Set

HARDWARE:
QTY DESCRIPTION PART #
1 18” Length Extrusion CM93055-2
1 12” Length Extrusion CM93055-1
1 Transmission Hump Bracket (no holes drilled) C-B43
1 Rear Extrusion Bracket CM001380
C-B42
1 Extrusion Adapter Bracket CM001379
12 ¼” Serrated Nut GSM30023
12 ¼ x ¾” Hex Head Bolt GSM33001
6 ¼” x ¾” Ph

Résumé du contenu de la page N° 2

SUB ASSEMBLY: 1. Confirm receipt of all hardware and components. 2. Remove partial OEM cup-holder/console located on the transmission hump. Note: Do not remove metal housing attached to this partial console. This piece is meant to strengthen the vehicles crumple zone and must not be removed. INSTALLATION: Sub-assemble C-B43 (only the View of partial OEM piece shown), 18” portion of console removed Attach rear extrusion bracket trak, extrusion adapter bracket, (CM001380) to ve

Résumé du contenu de la page N° 3

Cut floor mat, next to the seat Slide under seat support Slide guide brackets into seat rail rail to allow Under seat brackets into position as and loosely attach #10 x ¾” Phillips support bracket to slide under shown pan head machine screws seat rail 1. Position sub-assembled transmission hump bracket, 18” portion of trak, extrusion adapter bracket, rear extension bracket and 12” portion of trak to the under seat & guide brackets. 2. Loosely attach assembly using ¼-20 x ¾” Ph

Résumé du contenu de la page N° 4

C-TM-IMP-1 installed C-TM-IMP-1 installed w/ console, computer mounts and accessories. (Sold separately) C-TM-IMP-1_INST_11-08 4