Instruction d'utilisation Blaupunkt RP4-CH11

Résumé du contenu de la page N° 1

Accessory Output
+12volts 1amp max.
RP4-CH11
Radio Replacement & Steering Wheel Control Interface
for Chrysler/Dodge/Jeep Vehicles
Introduction & Features
The RP4-CH11 interface allows the replacement of a factory radio in select Chrysler/Dodge/Jeep vehicles with MSCAN or
LSFT-CAN databus radios. Using this interface will retain factory features such as steering wheel controls (SWC) vehicle
entertainment system (VES) and the factory audio amplifier whenever the original radio is removed. The

Résumé du contenu de la page N° 2

7 7 6 6 5 5 4 4 3 3 RP4-CH11 Radio Replacement & Steering Wheel Control Interface for Chrysler/Dodge/Jeep Vehicles Installation Steps SET RADIO SELECT SWITCH Advent, Alpine BOYO, Dual, Blaupunkt Clarion JVC Kenwood OEM Pioneer Valor Visteon, Sony 1 7 8 4 2 3 6 7 5 1.The radio select rotary switch on the side of the interface must be adjusted to the proper radio setting before plugging the interface into the vehicle (see page 2 for setting chart). 2. Only one of the two pr

Résumé du contenu de la page N° 3

RP4-CH11 Radio Replacement & Steering Wheel Control Interface for Chrysler/Dodge/Jeep Vehicles Optional Steering Wheel Control Programming (cont.) 11/9/2011 - 11:01 AM swi-rc radio and button chart.xls Optional Programming Order Advent, Boyo, Dual, Visteon, Sony Alpine JVC Kenwood Clarion Valor OEM Pioneer Blaupunkt 1 Volume + Volume + Volume + Volume + Volume + Volume + Volume + Volume + Volume + 2 Volume - Volume - Volume - Volume - Volume - Volume - Volume - Volume - Volume - 3 Mute Mute Mu

Résumé du contenu de la page N° 4

RP4-CH11 Radio Replacement & Steering Wheel Control Interface for Chrysler/Dodge/Jeep Vehicles Testing & Verification 1. Turn the ignition on. The LED on the interface will turn on & the +12v accessory wire will turn on. 2. Turn on the radio & check balance & fade. Note: Factory amplified Systems will not fade as neither the aftermarket radio or the RP interface have the ability to control the amplifier’s fader. 3. Verify that the factory subwoofer (if present) is playing 4. Verify that all S