Résumé du contenu de la page N° 1
RDW6012FI/SF
Dishwasher
User Guide
&
Installation & Service Instructions
U110142 - 01
Résumé du contenu de la page N° 2
Contents 1. Before You Start 1 4. Troubleshooting 14 At Time of Delivery 1 Resolving minor problems yourself 14 During Installation 1 Problems when the unit is switched on 14 During Normal Use 1 Problems with the appliance 14 If a Fault Occurs 1 Problems during washing 15 Caring for the Environment 1 Problems with the dishes, cutlery, etc. 15 2. Overview and Operation 2 5. Installation 16 Getting to Know Your Dishwasher 2 Positioning the Dishwasher 16 Salt 3 Cold Water Connection 16 Rinse Aid 4
Résumé du contenu de la page N° 3
DocNo.800-0101 - Introduction 1. Before You Start At Time of Delivery If a Fault Occurs Check packaging and dishwasher immediately for signs of If the appliance malfunctions, turn off the water supply and transport damage. If the appliance is damaged DO NOT USE. disconnect the plug from the wall socket. If you cannot solve Contact your supplier or customer services. the problem, contact your service centre. Please dispose of packaging materials properly. Only authorized persons should make re
Résumé du contenu de la page N° 4
DocNo.800-0204 - Overview - RDW6012SF dishwasher 2. Overview and Operation Getting to Know Your Dishwasher Fig.2-1 A B C D J K E A Upper rack L B Upper spray arm F G C Lower rack D Cutlery basket H I E Control panel F Lower spray arm G Salt container cap H Washing filter Detergent and rinse aid I dispenser J Water inlet hose K Drain hose L Power supply cord Dishwasher Interior (Fig.2-1) Control Panel (Fig.2-2) AB E Fig.2-2 C D F GH I J KL A ON-OFF button D Additional options button G Low sa
Résumé du contenu de la page N° 5
Salt Fig.2-3 The hardness of water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Low salt indicator Loading the salt into the container Always use salt intended for use with dishwashers. Fig.2-4 The salt container is located beneath the lower rack and should be filled as follows: 1. Whe
Résumé du contenu de la page N° 6
Rinse Aid Fig.2-5 This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door. When the low rinse aid indicator on the control panel (Fig.2-5) and the indicator on the dispenser (Fig.2-6) lights you must add rinse aid. Note: When 3-in-1 or similar combination detergent tablets, Low rinse aid indicator the rinse-aid is no longer useful. Loading the rinse aid Fig.2-6 To load the rinse aid: 1. To open the dispenser, turn
Résumé du contenu de la page N° 7
What you should not put into the Fig.2-9 dishwasher Cutlery and tableware manufactured in whole or part from wood. They become faded and unsightly in appearance. Furthermore the adhesives that are used are not suitable for the temperature that occurs inside the dishwasher. Delicate decorative glassware and vases, special antiques or irreplaceable china. The decorative patterns on such items will not be dishwasher-proof. Plastic objects that are not resistant to hot water, copper and pewt
Résumé du contenu de la page N° 8
Arranging Crockery, Glasses, etc. in the Fig.2-11 Dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, resulting in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washed. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher. Using the lower rack Fig.2-12 The lower rack has adjustable sup
Résumé du contenu de la page N° 9
Washing Dishes Fig.2-15 Fig.2-16 Programme overview Time delay Press for additional options (scroll through): Upper rack wash function Lower rack wash function Combi detergent tablets function Program select ArtNo.800-0304 - Using the cup rack ArtNo.800-0305 - Knife rack Start/reset button On/O button Fig.2-17 Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the deta
Résumé du contenu de la page N° 10
8 Programme Overview Additional options Detergent Types of crockery e. g. Amount Condition Wash Type of food Duration china, pots & pans, of food of food Description of cycle Rinse aid programme remaining Delayed Upper Lower Extended (mins) cutlery, glassses, etc. remaining remaining Tabs Prewash start wash wash wash Prewash with cold water. – – 5g 25g u 75-110 Main wash at 50°C or 65°C. 1 or 2 rinses with cold water. uu u – 5g 25g u 52-82 55°C/65°C Rinse with hot water. Au
Résumé du contenu de la page N° 11
Switching the dishwasher OFF Using 3-in 1 Detergent Tablets Several minutes after the programme has ended: General Advice 1. Open the door. 1. Before using these products you should first check 2. Set the ON-OFF button to OFF. that the water hardness in your supply is compatible with their use, as per the detergent manufacturers 3. Remove dishes, etc. when they have cooled down. instructions (on the product packaging). Note: For the best drying performance, we recommend that 2. These pr
Résumé du contenu de la page N° 12
To select the ‘tablets’ function: Fig.2-20 1. Open the door. Additional options button 2. Select the programme and then press the additional options button (Fig.2-20) until the tablets indicator [ ] lights. 3. Press the Start/Reset button (Fig.2-21) and close the door. The dishwasher will start immediately. To cancel the ‘tablets’ function: Follow the ‘Cancelling or modifying a cycle’ instructions. If you decide to switch to the use of a standard detergent system we advise that you: Fig.
Résumé du contenu de la page N° 13
Delayed start programming Delayed start button Fig.2-22 You can delay the start of a programme from 1 hour up to 24 hours. 1. Open the door, switch the dishwasher ON. 2. Press programme button to choose the desired programme. 3. Press the Delayed Start button (Fig.2-22); the time- remaining indicator changes to ‘1’. 4. Press the Delayed Start button as many times as necessary until the numerical display shows the required delay. Fig.2-23 5. To cancel the time delay setting, press the De
Résumé du contenu de la page N° 14
DocNo.800-0301 - Care & maintenance - RDW6012 dishwasher 3. Looking after your Dishwasher Care Fig.3-1 After E very Wash After every wash, set the ON-OFF button to OFF and leave the door slightly ajar so that moisture and odours are not trapped inside. Before cleaning or performing maintenance isolate nn from mains. Low salt indicator Overall condition of appliance Check that no grease or scale has accumulated on the inside Fig.3-2 of the dishwasher. If you discover any deposits: Clean the
Résumé du contenu de la page N° 15
Moving the Appliance Fig.3-5 If the appliance must be moved, try to keep it in a vertical position. If absolutely necessary, it can be positioned on its back. Seals ArtNo.800-0509 - Cleaning the lower spray arm One of the factors that cause odours to form in the dishwasher is food that remains trapped in the seals. Periodic cleaning with a damp sponge will prevent this from occurring. When You Go on Holiday When you go on holiday, it is recommended that you run a wash cycle with the dishwa
Résumé du contenu de la page N° 16
DocNo.800-0401 - Troubleshooting - RDW6012 dishwasher 4. Troubleshooting Resolving minor problems yourself Fig.4-1 Experience has shown that you can resolve most problems that occur during normal daily usage yourself, without having to call out a service engineer. Not only does this save costs but it also means that the appliance is available to use. The following list of common occurrences and their remedies should help you identify the causes of most problems. Fig.4-2 Problems when the u
Résumé du contenu de la page N° 17
If the dishwasher still does not function and/or the problem • Items in the rack were touching each other. persists, contact the nearest authorized service centre and • Not enough detergent was added to dispenser. provide them with the following information: • Selected wash programme was not intensive enough. 1. The nature of the problem. • Rotation of spray arm obstructed by dishes, etc. 2. The model type number (Mod...) and serial number • Nozzles in spray arm are blocked by remnants of f
Résumé du contenu de la page N° 18
DocNo.800-0501 - Installation - RDW6012 dishwasher 5. Installation Positioning the Dishwasher Fig.5-1 The dishwasher should be aligned to the front of the adjacent cabinets, with allowance made for the door thickness. The dishwasher has water supply and drain hoses that can be 600-700 mm positioned on either to the left or the right. Before installing the dishwasher into a kitchen cabinet, holes must not be drilled into the sides or door, as to avoid 80 mm compromising the performance and
Résumé du contenu de la page N° 19
Electrical Connection Fig.5-5 The dishwasher must be installed by a qualified electrician, in accordance with all relevant British Standards/Codes of Practice (in particular BS 7671), or with the relevant national and local regulations. WARNING: THIS APPLIANCE MUST BE EARTHED nn 870 mm max All external wiring must comply with the IEE Regulations for the Electrical Equipment of Buildings. Connection to the Adjustable feet electrical supply can be made with either a plug and socket or be per
Résumé du contenu de la page N° 20
The adjustable feet allow the dishwasher to be raised up to Fig.5-8 870 mm. If the space between the floor and the underside of the work surface is more than 870 mm, the unit should be positioned on suitable wooded spacers that should be fixed to the floor (Fig.5-5). Always use a spirit level to make sure that the appliance is level left-to-right and front-to-back. If the appliance is installed on carpet, ensure that there is clearance beneath the ArtNo.800-0111 - Marking appliance. the p
