Instruction d'utilisation Lucent Technologies AS60

Résumé du contenu de la page N° 1

Lucent Technologies
Bell Labs Innovations
Tapeless Digital
Answering System
with Time/Day AS60
Fold open this manual for information
about this telephone's installation and
operation. Please read Part 1 —
Important Product Information,
included in this package.
Parti
1997 Lucent Technologies. All rights reserved.
Printed in Mexico. Issue L I
847933405

Résumé du contenu de la page N° 2

INSTALLATION Connect the line cord. Connect the powe r cord. Plug one end o f the telephone line cord Plug the power cord into the jack labeled 1 POWER and into an electrical outlet not into the jac k labeled TE L LINE on the controlled by a wal l switch. Fit the power back of the system. Plug the other end into cord behind the strain relief tab. The a phone wall jack. Message Window flashes C L to indicate that you need to set the clock. Connect the telephone. NOTE: If you do not w

Résumé du contenu de la page N° 3

1 OPERATION Record and hear outgoing announcement Set and hear time/day Displays number of messages, other indicators Leave a message Use with other buttons to change settings Turn system on or off Delete all or selected messages •rf- Select number of times line rings before system answers Set and hear Remote Access Code Skip all or part Play messages Repeat all or part of a message • of a message Adjust volume Stop message playback 5 To change the hour setting, hold

Résumé du contenu de la page N° 4

OPERATION m the line will ring before the system answers a Recording Your Announcement call. Set to 2 for two rings, set to 4 for four Before using this answering system, you should rings, or set to T S fo r Tol l Saver. When yo u set record the announcement (up to 3 minutes long) the system to TS , the system answers after 4 that callers wil l hear when the system answers rings when you have no new messages, and af­ a call. If you choose not to record an announce­ ter 2 rings when you

Résumé du contenu de la page N° 5

OPERATION Skip to next message — Press and release WIlBII MCmOIV IS FUll ISKIP/SCANi. The system can record approximately 12 Skip part of a message — Hold down minutes of messages, including your {SKIP/SCAN': for a few seconds, then release it announcement, for up to a total of 99 to resume playing. The system beeps while messages. When memory is full, or 99 the button is held down. messages have been recorded, the Message Stop message playback — Press and Window flashes F. Delete m

Résumé du contenu de la page N° 6

I REMOTE OPERATION SCO Room Monitor with Intercom Playing Messages You can call the answering system and listen to 1 Dial your telephone number fro m a touch any activity in the room. tone phone. 1 Press :9 , iT to listen for 30 seconds. 2 When the system answers, enter your 2 I f yo u wish, you ca n press [Tj while Remote Access Code. The system the monitor is active to speak to some­ announces the number of messages one in the room (up to 30 seconds). received, then beeps twice.

Résumé du contenu de la page N° 7

IN CASE OF DIFFICOLTY to two when you have new messages I f this answering system does not work waiting. properly, try the followin g suggestions. I f • In some cases, the system might be you're still having difficulty, call Lucent affected by the ringin g system used b y Technologies at 1 800 222-3111. the local telephone company. • If the system's memory is full, or the Message Window Is Blank system is off, the system answers after • Make sure the power cord is securely 10 rings