Résumé du contenu de la page N° 1
WC430 Integrated
Slimline Dishwasher
Manual for Installation, Use and Maintenance
Passionate about style
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
WC430 Manual.indd 1 3/6/09 11:19:00
Résumé du contenu de la page N° 2
Important Important The CDA Group Ltd The cannot CDA be Group held Ltd responsible cannot be for held injuries responsible or losses for caused injuries by or inc losses orrect caused use or by inst inc allation orrect of use this or installation of this product. Please note pr that oduct. CDA Please reserv not e the e that right CD to A in reserv validat e the e the right guar to ant inee validat supplied e the with guarant this ee prsupplied oduct following with this inc pr orr oduct ect foll
Résumé du contenu de la page N° 3
• The plastic housing on the water inlet pipe contains an electrically operated valve. The wires that connect to this valve are inside the inlet hose. Do not cut through the inlet hose, and do not put the plastic housing in water. • Children could get locked inside the appliance. Therefore when disposing of an old appliance, cut off the plug and set aside, and damage the door lock so that the door can no longer be closed. Recommendations • To reduce energy and water consumption, remove al
Résumé du contenu de la page N° 4
Starting a Programme • Turn on the water tap • Press the Power button. • Press the Programme Selection button until the required programme light is illuminated. When you close the door, the dishwasher will beep once and the programme will start automatically. The Delay Timer This dishwasher is equipped with a variable delay timer which can be set for 2, 4, 6, 8, 10 or 12 hours’ duration. • To set the delay timer, first switch the dishwasher on by pressing the power button. Then press t
Résumé du contenu de la page N° 5
Detergent To fill the detergent dispenser 1. Push the latch to open the dispenser. 2. Add the required amount of detergent to the main detergent dispenser. 3 If your dishes are in need of an intensive wash, then add 5 cm of detergent into the prewash section of the dispenser. 3. Then close the detergent dispenser lid until the latch locks. Please note: You should only use detergents designed specifically for use in dishwashers. fig. 1 Combination detergents (e.g. 3-in-1 tablets) must not
Résumé du contenu de la page N° 6
Softener Adjustment The efficiency of your dishwasher depends on the softness of the tap water. To ensure best efficiency, the dishwasher is equipped with a system that reduces the hardness in the mains water supply. The efficiency will increase when the system is correctly set. To find out the water harness level of your water supply contact your local water board. en To set the softener adjustment system unscrew the cap from the salt container and rotate the ring indicated in figure 4 acc
Résumé du contenu de la page N° 7
Rinse Aid Rinse Aid Rinse Aid To fill the rinsRinse Aid e aid compartment To fill the rinse aid compartment To fill the rinse aid compartment To fill the rinse aid compartment 1. Open the rinse aid compartment by turning and removing the cap as 1. Open the rinse aid compartment by turning and removing the cap as 1. Open the rinse aid compartment by turning and removing the cap as shown in figure 4. 1. Open the rinse aid compartment by turning and removing the cap as shown in figure5.
Résumé du contenu de la page N° 8
General Information To adjust the height of the upper basket: Dishwasher Baskets Dish • Open the bask washer Bask et retaining clips, as shown in figur ets e 8, by turning them to To adjust the height of the upper basket: the side. To adjust the height of the upper basket: 1. Open the basket retaining clips, as shown in figure 7, but turning them to • Remove the upper basket, and relocate the alternate set of wheels on the the side. 1. Open the basket retaining clips, as shown in
Résumé du contenu de la page N° 9
Technical Information Width 44.6 cm Depth 55 cm Height 82 cm Capacity 9 standard place settings Mains water pressure 0.03-0.6 MPa Power voltage 220-240V ~50 Hz Rated current input 10 A Total absorbed power 1950 W 8 WC430 Manual.indd 9 3/6/09 11:19:07
Résumé du contenu de la page N° 10
Programme Listing Programme Intensive Normal Economic Glass Rapid wash Prewash O O O O O names and 70 wash 55 wash 50 wash 45 wash 40 wash No heat temperatures Level of soil High Medium Medium Small Small NA Detergent A+B A+B A+B A A NA amount A=Main B=Prewash Hot prewash Cold prewash Cold prewash Prewash O O O O O 70 wash 55 wash 50 wash 45 wash 40 wash Cold rinse Cold rinse Cold rinse Warm rinse Cold rinse Hot rinse Hot rinse Hot rinse Hot rinse Dry Dry Dry Dry End End End End End End Progr
Résumé du contenu de la page N° 11
Care and Maintenance Before beginning any care or maintenance, you should always disconnect the appliance from the electricity supply, and also turn off the water supply. Door seals Wipe the dishwasher door seals regularly with a damp cloth to remove any residue. fig. 10 Filters You should clean the filters at least once a month. • Remove the lower basket • Remove the filter assembly by pulling upwards on the cup handle • Remove the fine filter from the filter You should clean and rinse the f
Résumé du contenu de la page N° 12
Failure C Failur odes and T e Codes and T roubleshoo roubleshoo ting ting Your dishwasher c Your dish ontrw ol panel is equipped with a diagnostic displa asher control panel is equipped with a diagnostic displa y to help in the ev y to help in the ev ent of a problem with the applianc ent of a problem with the applianc e. e. Failure Codes and Troubleshooting The programme indicators also serve as a diagnostic display to help in the event of a problem with the appliance. Error Code Error Code Err
Résumé du contenu de la page N° 13
Failure Code and Troubleshooting Problem Possible cause Check the plug, fuse and circuit breakers of the mains supply The water tap is turned off The programme will not start The dishwasher door is not fully closed The water inlet filter or the machine filters are blocked The w The wat ater dr er drain hose is bloc ain hose is block ked or kink ed or kniced. ked Water remains inside the dishwasher at the end of the The filters are blocked programme Power failure The dishwasher stops in the mid
Résumé du contenu de la page N° 14
Electrical information Warning! This appliance must be earthed. The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow the steps below: 1. Remove the fuse cover and fuse. 2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover. 3. Replace fuse cover. Important: Do not use the appliance without the fuse cover in position. How to connect an alternative plug If the fitted plug is not suitable f
Résumé du contenu de la page N° 15
Installation • Do not install this appliance if it is damaged in any way. Installing a damaged appliance may invalidate the warranty. • The water supply tap should be located in an adjacent cupboard so that it can be accessed after installation. • Ensure the appliance is level by adjusting the feet as necessary. • Only use the water inlet supplied with the appliance. • If the water pressure is above 10 bar, a pressure relief valve should be used. • After connecting the water
Résumé du contenu de la page N° 16
To contact our Customer Care Department, or for Service, please contact us on the details below. Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu WC430 Manual.indd 16 3/6/09 11:19:11
