Instruction d'utilisation GE 19211

Résumé du contenu de la page N° 1

GE Model 19210/19211
www.jascoproducts.com
Wireless Pushbutton

Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips screwdriver.

Included Hardware:
(2) 3x20mm screws
(2) Double sided adhesive pads

Required Tools: Small flat blade screwdriver, drill, drill bit, and phillips screwdriver.


Chime Tune Setting
All wireless chimes may have more than one push button. Th

Résumé du contenu de la page N° 2

ON: Add a jumper to a location OFF: Remove jumper from a location. 4. Remove or add the jumpers to match the table. 5. Store unused jumpers as shown. Parking the jumper on an open set of pins. The two jumpers on the left are in the parked position. Setting The House Security Code Each chime component has jumpers for setting the house security code. In most cases you will not need to change the factory settings for the security code. If your chime activates intermittentl

Résumé du contenu de la page N° 3

1. Remove batteries from the pushbutton by opening the case as shown below. 2. Locate the pushbutton jumpers shown below. Push Button Jumpers 3. Jumpers 1-6 are used to select 1 of 64 possible home security codes. 4. To change the house code, add or remove jumpers as needed. After matching the existing security code, test the system for proper operation. Positions 1-6 on the chime and pushbutton must match exactly. Push But

Résumé du contenu de la page N° 4

b. Replacing the back cover 1. Push buttons are typically mounted at the same height as the door knob or handle (between 36" and 44" above the floor). 2. Before mounting, choose a mounting location that is not farther than 150 feet from the chime unit location. Not farther than 150 feet 3. Place the push button where you would like to mount it and with the chime as close to its final position as possible and test operation. If it works, mount the button. If it does no

Résumé du contenu de la page N° 5

5. Drill two holes with 3/32” size drill in marked locations. 6. Secure back cover to the mounting surface with two supplied mounting screws. 7. Press front housing onto back cover. 8. Test operation. If the chime does not work, see TROUBLESHOOTING. Operation 1. Turn on the chime. 2. Gently press transmitter button to sound chime. Troubleshooting Chime doesn't work: 1. Make sure push button switch is depressed and held for at least 1 second. 2. Make sure plastic tag i

Résumé du contenu de la page N° 6

1. This device may not cause harmful interference, and 2. This device must accept interference received, including any interference that may cause undesired operation. For technical support contact Jasco Products Company at 1-800-654-8483 or www.jascoproducts.com Made in China is a trademark of General Electric Company and is used under license to Jasco Products Company LLC, 311 N.W. 122nd Street, Oklahoma City, OK 73114. www.jascoproducts.com