Instruction d'utilisation Stanton RM.402

Résumé du contenu de la page N° 1

RM.402
Professional DJ Mixer
OWNER’S MANUAL
STANTON MAGNETICS, Inc.
information@stantondj.com
© 2004 Stanton Magnetics, Inc.

Résumé du contenu de la page N° 2

Résumé du contenu de la page N° 3

Troubleshooting Warranty Stanton Magnetics, Inc. – Warranty Provision – Returns for Repairs or Replacement Problem / Symptom Possible Cause/ Solution Only plug turntables into this input, do not plug in Warranty Sound is distorted Through Stanton’s authorized dealers around the World, Stanton, or one of Stanton’s authorized dis- CD players or other Line Level sources. Turn down Phono Input tributors outside the U.S., will, without charge, repair or replace, at the sole discretion of the entity t

Résumé du contenu de la page N° 4

Please read carefully before use of this product Troubleshooting failure to follow the instructions printed below may void warranty Problem / Symptom Possible Cause/ Solution • Follow all security advice printed on your mixer Is the power on? Check the power switch.Make sure the channels are assigned properly to the • When removing the unit's AC plug from the power source, grasp crossfaders. Make sure INPUT GAIN, is turned and pull the plug, NEVER the cord itself! No Sound up and output level

Résumé du contenu de la page N° 5

Technical Specifications Welcome Frequency Response 20 Hz to 20 kHz +1 dB Congratulations on your choice of the Stanton RM.402 Professional DJ Mixer. You now own one of the most flexible DJ mixers ever THD+N (Line) > 0.005 % at 1 kHz designed. The rackmountable RM.402 offers up to three Microphone Signal to Noise Ratio inputs, three Phono inputs and nine Line inputs—making it one of the (ref: max level) > 109 dB (main signal path) most powerful DJ mixers around. And with Stanton’s smooth fader

Résumé du contenu de la page N° 6

Making Connections Application Example Are you ready to get on the 1’s and 2’s? Let’s make sure you’ve made This is a typical setup you’ll find in many nightclubs: 2 turntables, 2 CD all the right connections… players, plus a microphone for the DJ. Here’s how you would set up your equipment with the RM.402: 1. Be sure all equipment is powered “OFF” and all of the RM.402’s Channel faders and Level knobs are at minimum volume. 2. Connect the turntables to the Phono inputs of Channels 1 and 2. B

Résumé du contenu de la page N° 7

Description of Functions Making Connections 16. Input Selector switches: Use these to choose between the Outputs Phono, Line and Mic inputs. Use the REC output to connect a stand-alone CD recorder, DAT 17. Talkover switch: Switch this to the “ON” position to enable recorder, or tape deck. Use the BOOTH output to connect directly to Microphones 1 and 2. When moved to the “Talkover” position, powered monitors or your monitor amp. The ZONE output can be used the music is lowered by a preset amo

Résumé du contenu de la page N° 8

Description of Functions Description of Functions At this point, you’re pretty much ready to start mixing. So if you’re a 6. Headphone outputs: Connect up to two pairs of stereo know-it-all, or you’re just one of those people who like to learn by trial- headphones using 1/4-inch and 1/8-inch jacks. and-error, you are free to throw down. But if you wanna go for the gold and get your pilot’s license, take a moment and learn what each of the 7. Cue Pan slider: This adjusts the relative headphone b