Résumé du contenu de la page N° 1
VN-V25U_26U_EN.book Page 1 Friday, January 18, 2008 2:56 PM
IP CAMERA
INSTRUCTIONS
VN-V25U
VN-V26U
VN-V25U VN-V26U
Thank you for purchasing this JVC product.
Before operating this unit, please read the
instructions carefully to ensure the best
possible performance.
LST0674-001A
Résumé du contenu de la page N° 2
VN-V25U_26U_EN.book Page 2 Friday, January 18, 2008 2:56 PM Getting Started Safety Precautions Information for Users on Disposal of Old Equipment [European Union] This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and recycling in accordance
Résumé du contenu de la page N° 3
VN-V25U_26U_EN.book Page 3 Friday, January 18, 2008 2:56 PM ● This installation should be made by a Due to design modifications, data given in this qualified service person and should conform instruction book are subject to possible change to all local codes. without prior notice. ● This installation shall be in accordance with the National Electrical Code, ANSI/NFPA 70. WARNING: ● The unit is to be powered by an AC 24 V TO REDUCE THE RISK OF FIRE OR power supply. ELECTRIC SHOCK, DO NOT T
Résumé du contenu de la page N° 4
VN-V25U_26U_EN.book Page 4 Friday, January 18, 2008 2:56 PM Getting Started These are general IMPORTANT SAFEGUARDS and certain items may not apply to all appliances. IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. All warnings on the product and in the operating instructions should be adhered to. 4. Unplug this appliance system from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleani
Résumé du contenu de la page N° 5
VN-V25U_26U_EN.book Page 5 Friday, January 18, 2008 2:56 PM Setting Using Internet Explorer ......33 Contents Setup ........................................................ 33 Internet Explorer Setup ......................... 33 Getting Started ................................... 2 Setting ...................................................... 36 Safety Precautions ..................................... 2 View Page ............................................. 36 Main Features ................
Résumé du contenu de la page N° 6
VN-V25U_26U_EN.book Page 6 Friday, January 18, 2008 2:56 PM Getting Started Support for PoE (Power over Main Features Ethernet) This product supports PoE (IEEE802.3af) and High Picture Quality enables power supply from a LAN cable. The camera unit of this product employs a PoE: class 2 (VN-V25U) 330,000-pixel CCD (1/4") which enables high class 0 (VN-V26U) quality video surveillance. Built-in JPEG and MPEG4 Viewer Support for Dual Stream Monitoring of JPEG and MPEG4 images via a
Résumé du contenu de la page N° 7
VN-V25U_26U_EN.book Page 7 Friday, January 18, 2008 2:56 PM How to use this manual Operating Environment Symbols used Recommended Computer Caution : Describes precautions concerning Specifications the operation of this product. OS : Windows XP (Professional or Note : Describes reference information, Home Edition) (SP2) such as functions and usage CPU : Pentium4 1.5 GHz or higher restrictions of this product. Memory capacity A : Indicates the reference page : 1 GB or more numbers and
Résumé du contenu de la page N° 8
VN-V25U_26U_EN.book Page 8 Friday, January 18, 2008 2:56 PM Getting Started Saving Energy Cautionary Notes When this product is not in use for a long period of time, turn off the power of the Maintenance and location of use system to ensure safety and reduce power This product is intended for use indoors. consumption. Make sure that you use a housing etc., when using it outdoors. Maintenance Do not place this product in the following Be sure to turn off the power before environ
Résumé du contenu de la page N° 9
VN-V25U_26U_EN.book Page 9 Friday, January 18, 2008 2:56 PM If a high luminance object (such as a lamp) is In the case of VN-V26U, the image and sound shot, a white smear may appear at the upper may not synchronize when playing back using and lower ends of this object on the screen. built-in viewer. This is not a malfunction. This phenomenon (smear) is characteristic of When VN-V26U is sending high bitrate, the solid-state image sensors, and is not a image and sound can be paused d
Résumé du contenu de la page N° 10
VN-V25U_26U_EN.book Page 10 Friday, January 18, 2008 2:56 PM Getting Started Name and Function of Parts Front / Bottom / Side The model illustrated in the diagram is VN-V26U. A I H G B F E C D J A Back Focus Adjustment Ring Use screws with a length between 5 mm to 7 mm. Screws beyond the specified length may This ring is used for back focus adjustment and switching the lens mount method. damage the interior, while those shorter than specified may cause the camera to fall off, and To oper
Résumé du contenu de la page N° 11
VN-V25U_26U_EN.book Page 11 Friday, January 18, 2008 2:56 PM Side KL MONITOR OUT PAL OFF NTSC RESET STATUS IRIS N M K [MONITOR OUT] Monitor Output Selection Note: Switch You can adjust the [LED State] settings via the Use this switch to select the availability of output network to turn off the indicator after startup is from the O [MONITOR OUT] terminal as well as complete. (A Page 71) the signal system. NTSC : Outputs NTSC signals. OF
Résumé du contenu de la page N° 12
VN-V25U_26U_EN.book Page 12 Friday, January 18, 2008 2:56 PM Getting Started Rear VN-V26U VN-V25U R Q R Q 1 2 G 2 1 2 1 1 2 G 2 1 2 1 AC24V AC24V ALARM ALARM SS MONITOR MONITOR OUT OUT AUDIO OUT 10BASE-T/ 10BASE-T/ SEE INSTRUCTION MANUAL SEE INSTRUCTION MANUAL 100BASE-TX 100BASE-TX T CAUTION: NEVER USE PoE AND AC 24V AT THE SAME TIME CAUTION: NEVER USE PoE AND AC 24V AT THE SAME TIME DO NOT CONNECT TO THE TELEPHONE NETWORK DO NOT CONNECT TO THE T
Résumé du contenu de la page N° 13
VN-V25U_26U_EN.book Page 13 Friday, January 18, 2008 2:56 PM Surveillance via Dual Stream Features Simultaneous distribution of JPEG and MPEG4 Surveillance Using the Built-in Viewer images enables real-time surveillance using MPEG4 (30 fps) and recording of JPEG images VN-V25U/26U comes with a built-in ActiveX at the same time. You can also lengthen the JPEG Viewer and MPEG4 Viewer. recording time by lowering the frame rate, JPEG images and MPEG4 images of resolution, and picture quali
Résumé du contenu de la page N° 14
VN-V25U_26U_EN.book Page 14 Friday, January 18, 2008 2:56 PM Getting Started Sending audio to the network (VN-V26U Alarm only) VN-V25U/26U comes with a motion detection Sends out audio picked up using the built-in feature and dual alarm input. microphone of VN-V26U to computers. By motion detection or alarm input, actions such as mail delivery, message transmission via TCP/ UDP, alarm output can be triggered. These VN-V26U Headset actions can also be triggered by combination of two alarm
Résumé du contenu de la page N° 15
VN-V25U_26U_EN.book Page 15 Friday, January 18, 2008 2:56 PM Setup Procedures Step 1 Connection/Installation (A Page 17) Connect the lens mount, power supply cord, LAN cable and alarm. Next, mount the camera to the ceiling. Remember also to mount the fall prevention wire. After the camera is mounted, connect the video monitor to the [MONITOR OUT] terminal at the rear of the unit, followed by adjusting the camera angle. You can select the video signals of the [MONITOR OUT] terminal usin
Résumé du contenu de la page N° 16
VN-V25U_26U_EN.book Page 16 Friday, January 18, 2008 2:56 PM Connection / Installation 2. Turn the lens in the clockwise direction to Mounting the Lens mount it to the camera firmly 1. Check the mounting method of the lens to 3. When using a DC iris lens, pay attention be used before mounting to the pin position before connecting the ● The default method used for this camera is lens cable CS mount. To use a C mount lens, loosen the back focus fastening screw using a screwdriver, follow
Résumé du contenu de la page N° 17
VN-V25U_26U_EN.book Page 17 Friday, January 18, 2008 2:56 PM Power Connection MONITOR OUT PAL OFF NTSC RESET Electricity can be supplied to this product either by connecting to the AC 24 V power supply or STATUS using the PoE (A Page 18). When power is supplied to this product, the [STATUS] indicator at the side lights up. The IRIS indicator lights up in orange color during startup, and switches to green color after startup is complete. You can select not to light up the [STATUS] Sta
Résumé du contenu de la page N° 18
VN-V25U_26U_EN.book Page 18 Friday, January 18, 2008 2:56 PM Connection / Installation ● In a system where multiple units of VN-V25U/ 26U are used, turn on the power of only one unit to configure the IP address settings using the Internet Explorer. Upon doing so, turn on the power of the second unit and configure accordingly. Configure the camera settings using the same procedure. ● When overlapping of the IP address occurs, check to ensure that there is only one VN-V25U/26U uni
Résumé du contenu de la page N° 19
VN-V25U_26U_EN.book Page 19 Friday, January 18, 2008 2:56 PM LAN Cable Connection Monitor Signal Output Terminal Connection Connect the camera to a hub or computer using a LAN cable. This terminal is used for adjusting the camera angle during installation. Connect it to devices such Cable to use as a video monitor using a video cable (RCA). ● Shielded cable ● Length of 100 m or shorter 1 2 G 21 21 When connecting to a hub Make use of a straight cable. AC24V ALARM When connecting to a
Résumé du contenu de la page N° 20
VN-V25U_26U_EN.book Page 20 Friday, January 18, 2008 2:56 PM Connection / Installation VN-V25U/26U Sensor Example Alarm Input/Output Terminal (1) DC3.3 V INPUT 1 or VCC Connection 2 Terminal R R OUT Connect the alarm input/output terminals with external devices, such as a sensor or buzzer. 3.3 V 1 mA Plug/Unplug the cable while pressing the button as shown in the diagram below. G Terminal GND (Alarm Input Equivalent Circuit) Cable to use Sensor Example (2) ● Shielded cable ● Length of 5
