Résumé du contenu de la page N° 1
Volume
1
EverFocus
Operation Instruction
1/3" CCD Standard/High Resolution
1/3" CCD Standard/High Resolution
Digital Color Box Camera
Digital Color Box Camera
EQ200E/300E
EQ200E/300E
Résumé du contenu de la page N° 2
Operation Instruction © 2008 EverFocus Electronics Corp Please read this manual first for correct installation and operation. This manual should be retained for future reference. The information in this manual was current when published. The manufacturer reserves the right to revise and improve its products. All specifications are therefore subject to change without notice. All rights reserved. No part of the contents of this manual may be reproduced or transmitted in any
Résumé du contenu de la page N° 3
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio comm
Résumé du contenu de la page N° 4
Table of Contents 1. Product Overview……………………………………………5 1.1 Features ................................................................. 5 1.2 Accessory Parts List ................................................ 6 1.3 Specifications ......................................................... 7 1.4 Dimensions ............................................................. 8 1.5 Back Panel Overview ............................................... 8 1.6 Camera Setting DIP Switch ..................
Résumé du contenu de la page N° 5
CHAPTER 2 I N STALLATI ON CHAPTER 1 PRODUCT OVERVI EW Chapter 1 Product Overview The new redesigned EverFocus color box camera produces excellent images with 1/3” SONY Super HAD CCD. The EQ series offers cost-effective solutions suitable for all your surveillance applications. The camera includes an adapter ring and it is compatible with both C-mount and CS-mount lenses. In addition, EQ300E/EQ200E provides 24 hours monitoring Day/Night function. Available in high resolution (520TVL) an
Résumé du contenu de la page N° 6
CHAPTER 2 I N STALLATI ON CHAPTER 1 PRODUCT OVERVI EW 1.2 Accessory Parts List Please be careful when you unpack the box due to the electronics devices inside. Check and make sure that you have all the items listed below inside the original box: Camera unit x 1 Operation instructions (this document) x 1 Mounting kit includes: -C adaptor mount ring x 1 -L wrench x 1 -Iris Lens Connector (top) x 1 -Iris Lens Connector (bottom) x 1 Please Note: If an item appears t
Résumé du contenu de la page N° 7
CHAPTER 1 PRODUCT OVERVI EW CHAPTER 2 I N STALLATI ON 1.3 Specifications Type EQ200E EQ300E Pickup Device 1/3'' SONY Super HAD CCD Video Format NTSC or PAL NTSC: 525 TV lines, 60 fields/sec Scanning System PAL: 625 TV lines, 50 fields/sec. Picture Elements 510 x 492 (NTSC) ; 500 x 582 (PAL) 768 x 494 (NTSC) ; 752 x 582 (PAL) Horizontal Resolution 380 TV Lines 520 TV Lines Sensitivity 0.3 Lux/F=1.2 0.4 Lux/F=1.2 S/N Ratio Over 48dB (AGC off) Electronic Shutter 1/50(1/60)~1/100,0
Résumé du contenu de la page N° 8
CHAPTER 2 I N STALLATI ON CHAPTER 1 PRODUCT OVERVI EW 1.4 Dimensions 1.5 Back Panel Overview 8
Résumé du contenu de la page N° 9
CHAPTER 1 PRODUCT OVERVI EW CHAPTER 2 I N STALLATI ON 1.6 Camera Setting DIP Switch 1 ○ DD/VD For video drive auto iris lens, please set switch to VD. For Direct Drive iris lens, set switch to DD. Wire the cable of lens to Mini Plug according to the following table: IRIS Pin1 Pin Pin 3 Pin 4 3 4 Video Drive +12V GND VD-IRIS GND 1 2 Direct Drive Cnt- Cnt+ Drv+ Drv- For Direct Drive iris lens: Brightness Level can be a
Résumé du contenu de la page N° 10
CHAPTER 2 I N STALLATI ON Chapter 2 Installation This chapter will describe, in general terms, how to install the EQ300E/EQ200E camera. STEPS: 1. Plug the power 2. Mount the lens 3. Connect the video output 4. Adjust the lens 2.1 Plug the Power Plug the power cord to the outlet. Power indicator LED should light if the power source is properly connected. Warning • To prevent electrical shock, turn off the electrical power before making electrical connections. • Do not ex
Résumé du contenu de la page N° 11
CHAPTER 2 I N STALLATI ON 2.4 Adjust the Lens Once the image appears on the monitor, adjust the focus and diaphragm of the lens to obtain the best picture. When a lens does not hold focus at both ends of the zoom range, do back focus adjustment as following: i. Set the focus ring of the lens to infinity position. ii. Take picture of subject at a distance more than 20m away from the camera. iii. Loosen the lens mount fixing screw located at right-hand side of the front panel by us
Résumé du contenu de la page N° 12
CHAPTER 2 I N STALLATI ON EverFocus Electronics Corp. Head Office: Europe Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Albert-Einstein-Strasse 1 Hsi-Chih, Taipei, Taiwan D-46446 Emmerich, Germany TEL: +886-2-26982334 TEL: 49-2822-9394-0 FAX: +886-2-26982380 www.everfocus.de www.everfocus.com.tw China Office: USA L.A. Office: Room 609, Technology Trade Building, 1801 Highland Ave. Unit A Shangdi Information Industry Base, Haidian Duarte, CA 91010, U.S.A. District, Bei
