Instruction d'utilisation Sony EXPODISC A100

Résumé du contenu de la page N° 1

ExpoDisc Custom White Balance Procedures
Sony Cameras
Sony A100
1. Install the ExpoDisc and set the camera to Manual Focus mode.
2. Allow the camera to set an automatic exposure using the “P”, “S” or “A”
modes or set the correct manual exposure in “M” mode.
3. Rotate the function dial on the top-left of the camera to the WB position.
4. Press the Fn button in the center of the function dial to display the White-
Balance mode screen.
5. Using the controller pad to the right of the screen, move u

Résumé du contenu de la page N° 2

Sony A700 1. Install the ExpoDisc and set the camera to Manual Focus mode. 2. Allow the camera to set an automatic exposure using the “P”, “S” or “A” modes or set the correct manual exposure in “M” mode. 3. Press the WB (White Balance) Button to display the White Balance mode screen. 4. Select a custom white balance item ( ) using the / on the multi-selector. 5. Select ( SET), then press the center of the multi-selector to display the register screen. 6. The message “Use spot metering area.

Résumé du contenu de la page N° 3

8. Select a memory number with / ( 1), then press the center of the multi- selector. The Sony A900 allows you to save up to 3 custom white balance references. This white balance setting will stay in effect until a new custom white balance is registered under the same memory number. 9. Make sure that the number you registered (ie. 1), is the same white balance that you are set to on the White Balance mode screen. 10.If you get the message “Custom WB error” this indicates that you need to