Resumen del contenido incluido en la página 1
ELECTRIC STOVE
MODEL CGESS
SAFETY INFORMATION AND OPERATION MANUAL
Read these instructions completely before operating
electric stove. Failure to follow them could cause a
heater malfunction resulting in serious injury and/or
property damage.
Save this manual for future reference.
For more information, visit www.desatech.com
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS Safety Information ............................................... 2 Cleaning and Maintenance .................................. 4 Listing Approvals ................................................. 3 Technical Service ................................................ 6 Unpacking and Testing the Unit ........................... 3 Replacement Parts .............................................. 6 Product DimensionS & Specifications ................. 3 Troubleshooting .............
Resumen del contenido incluido en la página 3
SAFETY INFORMATION PRODUCT DIMENSIONS & Continued SPECIFICATIONS 12. Always disconnect the unit from the power supply before performing any cleaning, light 10.2" 14.2" bulb replacement, maintenance, relocating the heater or when the unit is not in use for long periods of time. 13. When transporting or storing the unit, keep it in a dry location, free from dust, excessive vibration or other factors, which may damage 21.5" the unit. LISTING APPROVALS This heater has been tested in accorda
Resumen del contenido incluido en la página 4
You should hear a small clicking sound indicat- GROUNDING ing the heater has started and heat will emit INSTRUCTIONS from the vents at the top of the unit from the This stove is for use on 120 volts. The cord has a front. To turn off heater, turn the dial counter plug as shown in Figure 2. An adapter is available clockwise past number 1 and turn the Heater for connecting three-blade grounding-type plugs Switch to OFF position. To increase the desired to two-slot receptacles. The green g
Resumen del contenido incluido en la página 5
8. Secure the rear cover of the unit to the main CLEANING AND frame by reattaching the 6 screws remove in MAINTENANCE step 1. Continued Most halogen light bulbs are rated to last approxi- mately 1800 hours. Like all light bulbs, halogen bulbs require periodic replacement. When the bulbs in your unit have burned out you will notice or more of the following: • Flame is dim or dark in certain areas Screws • Log set ember bed appears dim or dark in Screws certain areas WARNING: Do not instal
Resumen del contenido incluido en la página 6
CLEANING AND TECHNICAL SERVICE You may have further questions about your elec- MAINTENANCE tric stove. If so, contact DESA Heating Productsʼ Continued Technical Service Department at 1-866-672-6040. CLEANING FRONT PANEL GLASS When calling please have your model and serial numbers of your heater ready. WARNING: When cleaning You can also visit DESA Heating Productsʼ techni- cal services web site at www.desatech.com. unit, the power supply should be disconnected and the unit REPLACEMENT PART
Resumen del contenido incluido en la página 7
TROUBLESHOOTING WARNING: Turn off appliance and let cool before servicing. Only a qualified service person should service and repair heater. OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Stove turns off and will not 1. Stove has overheated and safe- 1. Reset switch by turning main turn on ty devise has cause thermal power switch off and waiting 5 switch to disconnect or home minutes then turning it back on circuit breaker has opened Flame is not moving 1. Loose wiring 1. Inspect wiring for loose con
Resumen del contenido incluido en la página 8
WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our standard written warranty. We make no other warranty, expressed or implied. LIMITED WARRANTY ELECTRIC STOVE DESA Heating Products warrants this product to be free from defects in materials and components for one (1) year from the date
