Manual de instrucciones de DCS CMOTTK30

Resumen del contenido incluido en la página 1

MODEL CMOTTK30 CONVECTION MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Before you begin, read these instructions completely and carefully.
Getting Started
■ Remove packaging
Contents Tools Required
Part Description Qty 1/8” Drill
#2 Phillip Screwdriver
Trim Assembly 1
Base 1
Rear Duct 1
Forward Duct 1
Foam Tape 2 ft
Mounting Bracket (L/R) 2
Sheet Metal Screws 14
Before installing trim kit, install the convection duct as follows:
1. Insert the rear section of the duct into the forward section o

Resumen del contenido incluido en la página 2

Installing Trim Kit 1. Cut opening in the cabinet face per the following dimensions: Height: 19-3/16” + 1/16”, –0 Width: 25-3/4” + 1/16”, –0 Note: Refer to diagram on the following page. The minimum cabinet depth is 20”. When installing the Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the recommendations in the Microwave Installation/ Use & Care Manual. 2. Add adequate platform base support in the bottom of the cabinet for trim kit base to rest on. Fi

Resumen del contenido incluido en la página 3

REAR CABINET CONVECTION DUCT FOAM TAPE ON HORIZONTAL CLIP THIS FLANGE ORIENTATION ON MOUNTING FORWARD BRACKET 25 3/4" +1/16"-0" CONVECTION DUCT 1/8" HOLE FOR FOAM TAPE ON MOUNTING TOP PIN THIS FLANGE SCREW OF TRIM SCREW HOLE FOAM TAPE ON CENTER THIS FLANGE LINE MOUNTING BRACKET SUPPORT INSERT 4 TRIM KIT ASSEMBLY INSERT 1 BASE CABINET CUT-OUT: 19 13/16" +1/16" -0" BOTTOM PIN OF TRIM FLANGE INSERT 2 TRIANGULAR CENTERING TOP SCREW NOTCH HORIZONTAL CLIP ORIENTATION SCREW HOLE ON

Resumen del contenido incluido en la página 4

5800 Skylab Road, Huntington Beach, CA 92647 Tel: 714.372.7000 • Fax: 714.372.7001 Customer Service: 888.281.5698 P/N 241185 Rev. A 10/07 www.dcsappliances.com