Manual de instrucciones de NEC PX-42XR3A

Resumen del contenido incluido en la página 1

PX-42XR3A
Model Information
For the operation of your plasma monitor,
refer to “Operation Manual”.
NEC Solutions (America), Inc.

Resumen del contenido incluido en la página 2

IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. 17. Tilt/Stability - All televisions must comply with 2. Keep these instructions. recommended international global safety standards for 3. Heed all warnings. tilt and stability properties of its cabinets design. 4. Follow all instructions. • Do not compromise these design standards by 5. Do not use this apparatus near water. applying excessive pull force to the front, or top, of 6. Clean only with a dry clo

Resumen del contenido incluido en la página 3

PRÉCAUTIONS IMPORTANTES DE SÉCURITÉ A lire avant de faire fonctionner l’appareil 1. Lire ces instructions. 17. Tous les téléviseurs doivent être conformes aux normes 2. Garder ces instructions. inter-nationales de sécurité préconisées pour les 3. Respecter tous les avertissements. propriétés de sta-bilité et d’inclinaison dans la conception 4. Suivre toutes les instructions. des meubles. 5. Ne pas utiliser cet appareil près de l’eau. • Ne pas compromettre ces normes de conception en 6. Nettoyer

Resumen del contenido incluido en la página 4

Important Information Warning NOTE: Not for use in a computer room as defined in the Standard When you connect a computer to this monitor, use an RGB for the Protection of Electronic Computer/ Data Processing cable including the ferrite core on both ends of the cable. Equipment ANSI/NFPA 75. And regarding DVI and power cable, attach the supplied ferrite cores. If you do not do this, this monitor will not This equipment has been tested and found to comply with conform to mandatory FCC standards.

Resumen del contenido incluido en la página 5

Recommandations importantes Avertissement Attention Ne pas utiliser dans une salle d’ordinateurs telle que définie Cet modèle est fait pour être utilisé avec les accessoires dans la Norme pour la protection des ordinateurs optionnels suivants. Toute utilisation avec d’autres électroniques/appareils de traitement des données ANSI/ accessoires optionnels peut entraîner une instabilité pouvant NFPA75. causer des blessures. Nom du fabricant: NEC Plasma Display Corporation DOC avis de conformation En

Resumen del contenido incluido en la página 6

Specifications Screen Size 36.1"(H)
20.4"(V) inches 918(H)
518(V) mm 1.38" diagonal 42" 2.13" (35) 40" (1018) (54) Aspect Ratio 16 : 9 Resolution 1024(H)
768(V) pixels 36.1" (918) Pixel Pitch 0.036"(H)
0.027"(V) inches 0.897(H)
0.675(V) mm Color Processing 4,096 steps, 68.7 billion colors Signals Synchronization Range Horizontal : 15.5 to 110 kHz (automatic : step scan) Vertical : 50.0 to 120.0 Hz (automatic : step scan) 3.5" (89) Input Signals RGB, NTSC (3.58/4.43), PAL (B,G,M,N), 1 1 1 Bezel c

Resumen del contenido incluido en la página 7

Table of Signals Supported Supported resolution 2, 4 • When the screen mode is NORMAL, each signal is converted to a 768 dots
768 lines signal. (Except for * * ) • When the screen mode is FULL, each signal is converted to a 1024 dots
768 lines signal. Computer input signals supported by this system Sync Polarity Presence Vertical Horizontal Screen mode RGB Dots
lines Model 5 frequency frequency NORMAL select* Memory Horizontal Vertical Horizontal Vertical FULL DVI Signal Type (Hz) (kHz)

Resumen del contenido incluido en la página 8

*1 Only when using a graphic accelerator board that is capable of displaying 852
480. *2 Display only 640 lines with the screen center of the vertical orientation located at the center. *3 The picture is displayed in the original resolution. The picture will be compressed for other signals. *4 Aspect ratio is 5:4. This signal is converted to a 720 dots
768 lines signal. *5 Normally the RGB select mode suite for the input signals is set automatically. If the picture is not displayed properly, se