Resumen del contenido incluido en la página 1
ENGLISH
Resumen del contenido incluido en la página 2
SAFETY SYMBOLS This manual uses the safety symbols below. They denote critical information. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2000 by EIZO NANAO CORPORATION. All rights reserved. No par
Resumen del contenido incluido en la página 3
ENGLISH TABLE OF CONTENTS PRECAUTIONS .............................................................................. 4 1. INTRODUCTION .......................................................................... 10 1-1. Features ..................................................................................................... 10 1-2. Package Contents ...................................................................................... 10 1-3. Controls & Connectors ............................
Resumen del contenido incluido en la página 4
PRECAUTIONS IMPORTANT! ´ This product has been adjusted specifically for use in the region to which it was originally shipped. If operated outside the region to which it was originally shipped, the product may not perform as stated in the specifications. ´ To ensure personal safety and proper maintenance. Please read this section and the caution statements on the monitor (refer to the figure below). [Location of the Caution Statements] Risk of electric shock. Do not open. Risque de choc elect
Resumen del contenido incluido en la página 5
ENGLISH WARNING ´ Keep small objects away from the monitor. Small objects may accidentally fall through the ventilation slots into the cabinet, leading to fire, shock, or equipment damage. ´ Keep liquids away from the monitor. Spillage into the cabinet may result in fire, electric shock, or equipment damage. If an object or liquid falls/spills into the cabinet, unplug the monitor immediately. Have the monitor checked by a qualified service engineer before using it again. ´ Place the monitor o
Resumen del contenido incluido en la página 6
WARNING OK ´ To disconnect the power cord, grasp the plug firmly and pull. Never tug on the cord, doing so may cause damage and couldresult in fire or electric shock. ´ The equipment must be connected to a grounded main outlet. ´ Use the correct voltage. * The monitor is designed for use with a specific voltage only. Connection to a different voltage may cause fire, electric shock, or other damage. * Do not overload your power circuit, as this may result in fire or electric shock. * For proper
Resumen del contenido incluido en la página 7
ENGLISH WARNING ´ Install the monitor securely when attaching to an arm stand. When attaching an arm stand, please refer to the user’s manual of the arm stand and install the monitor securely with the enclosed screws. Not doing so may cause the monitor to come unattached, which may result in injury or equipment damage. When the monitor is dropped, please ask your dealer for advice. Do not continue using a damaged monitor. Using a damaged monitor may result in fire or electric shock. When re
Resumen del contenido incluido en la página 8
CAUTION ´ Do not block the ventilation slots on the cabinet. * Do not place books or any other papers on the ventilation slots. * Do not install the monitor in a closed space. * Do not use the monitor lengthwise or upside down. Using the monitor in this way blocks the ventilation slots and prevents proper airflow, leading to fire or other damage. Do not use the LCD monitor outdoors or indide a car. This LCD monitor has been made specifically for indoor use as a desktop monitor. Using it anyw
Resumen del contenido incluido en la página 9
ENGLISH Suggestions for Maximizing Comfort ´ To lessen the chance of possible injury and to increase your comfort and productivity while you operate the unit, we suggest the following: * Avoid less favorable body positioning. Sit back on the chair with your back straight. * Adjust the height of the chair so that the both soles touch the floor. * Adjust the height of your chair, monitor, or keyboard so that you can keep your wrists straight while typing. * Set the terminal slightly below eye lev
Resumen del contenido incluido en la página 10
1. INTRODUCTION Thank you very much for choosing an EIZO Color Monitor. 1-1. Features p.27) p.27) DVI digital input (TMDS ) compliant. p.27) 1024 x 768 resolution and automatic full screen support for lower resolutions. Smoothing function incorporated for the adjustment of an enlarged image. p.27) DVI DMPM power saving compliant, less than 3 W in power saving mode. Two kinds of brightness adjustment accessible through the brightness selection button on he front panel. 1-2. Package
Resumen del contenido incluido en la página 11
ENGLISH 1-3. Controls & Connectors Front (1) ScreenManager™ (2) Brightness Selection Button (3) Control Buttons (1) (4) Enter Button *1 (5) Power Indicator Indicated color Monitor’s status Green Power -on Yellow Power save mode Flashing Y ellow Power save mode (2 times for each) (6) Power Switch (2)(3)(4) (6) (5) Rear (7) Power Connector *2 (8) Security Lock Slot (9) DVI-D Input Connector *3 (10) 4 Holes for Mounting an Arm-Stand *3 (11) Stand (Detatchable) (10) (11) (9) (7)(8) *1 Regarding the
Resumen del contenido incluido en la página 12
2. CABLE CONNECTION 2-1. Before Connecting p.27) Following 4 resolutions with frequency can be displayed on this model. The lower display modes like 640 x 480 or 720 x 400 mode, automatically enlarge to the maximum display mode (1024 x 768). In this case, some lines of the characters may become fuzzy. Use “Smoothing” function to make the lines clear (see page 18). Resolution Frequency Remarks 6z 40 x 4806A 0 H VG 7z 20 x 4007t 0 H VGA Tex 8z 00 x 6006A 0 H VES 1z 024 x 7686A 0 H VES 2-2. Conn
Resumen del contenido incluido en la página 13
ENGLISH WARNING Use the enclosed power cord. If using the power cord other than the enclosed one, follow these guidelines. [USA and Canada] Use a UL LISTED/CSA LABELED or CERTIFIED power cord set meeting the following specifications: * Rating: min. 125 V, 10 A * Length: max.2.0 m * Type: SVT * Plug type: NEMA 5-15P, Parallel blade, Grounding type, 125 V, 10 A [Europe] Use a proper European standard approved power cord meeting the following specifications: * Rating: min. 250 V, 10 A *Length
Resumen del contenido incluido en la página 14
3. ScreenManager 3-1. How to use the ScreenManager As shown on the display, the ScreenManager is used to adjust the LCD monitor. ScreenManager consists of main menus and sub menus. Adjustments are made using the Enter and Control buttons (up, down, right and left) located on the front panel. < Main menu> Enter Button Control Buttons 1. Entering the ScreenManager Push the Enter button once to display the main menu of the ScreenManager. 2. Making Adjustments and Settings (1) Select the desired su
Resumen del contenido incluido en la página 15
ENGLISH 3-2. ScreenManager Adjustments and Settings. The following table shows all the ScreenManager’s adjustment and setting menus. Main menu Sub menu Reference Screen Position Resolution 4-1. Screen Adjustment (p.17) Smoothing Brightness PowerManager DVI DMPM 4-2. Power-save Setup (p.19) Others Off timer Set the monitor’s timer to on or off (p.16). Menu Position Adjust the ScreenManager’s menu position. Reset Return to the factory default settings. (p. 25) Information Information Review the cu
Resumen del contenido incluido en la página 16
Off Timer The off timer function causes the monitor to automatically enter a power off state after a predetermined amount of time has lapsed. This function was created to reduce p.27) afterimage characteristics that are particular to LCD monitors when the monitor screen is left on for a long period without use. [Procedure] (1) Select “Off Timer” in the ScreenManager “Others” menu. (2) Select “Enable” and press the right and left buttons to adjust the “On Period” (1 to 23 hours). [Off timer s
Resumen del contenido incluido en la página 17
ENGLISH 4. ADJUSTMENT 4-1. Screen Adjustment The monitor displays the digital input image correctly based on its pre-setting data. However, if the image position is not incorrect or larger than the actual image screen, please adjust the following adjustment items using the “Screen” menu of the ScreenManager. Allow the monitor to warm up for at least 20 minutes before making any adjustments. 1. The screen position is incorrect. “Position” adjustment The correct displayed position of the moni
Resumen del contenido incluido en la página 18
3. Smooth blurred texts. Adjust the “ Smoothing” Select a suitable level from 1~5 (soft ~ sharp). Select “Smoothing” and adjust by using the right and left buttons. 4. Set the Brightness of the screen Adjust the “Brightness” This controls the brightness of the screen. The brightness of the entire screen is controlled by changing the brightness of the backlight. [Brightness 1 & Brightness 2] The L351 has two memories for the preferable brightness setting (Brightness 1 & Brightness 2).
Resumen del contenido incluido en la página 19
ENGLISH 4-2. Power-save Setup p.27) This monitor complies with the DVI DMPM . [Procedure] (1) Set the PC’s power saving settings. (2) Select “DVI DMPM” in the “PowerManager” menu. [Power saving system] PC Monitor LED Power consumption On n On peratio G5 ree 3W Pg ower savingPw ower savinYW ello Less than 3 Flashing yellow Og ff mode Power savin Less than 1 W (2 times for each) Operate the mouse or keyboard to return to a normal screen from the Power save mode of the PC. Power on the PC to retur
Resumen del contenido incluido en la página 20
5. ATTACHING AN ARM STAND The L351 can be used with an arm stand by removing the tilt stand and attaching the arm stand to the terminal. NOTE ´ Use an arm stand that satisfies the followings. M4 x 16 mm When using the L351 with an arm stand, the arm stand must be VESA approved : 75 mm * Use an arm stand with a 75 mm x 75 mm hole spacing on the arm mounting pad. 75 mm * Use an arm stand that is able to support anobject weighing 8.0 kg. ´ TÜV/GS approved arm stand. ´ Use an arm stand with suffic
