Manual de instrucciones de Dell UltraSharp 1702FP

Resumen del contenido incluido en la página 1

Dell™ 1702FP Flat Panel Color Monitor
Quick Setup Guide
Safety Instructions
Observe the following safety guidelines when connecting and using your monitor:
 Be sure that your monitor is electrically rated to operate with the AC power available in your location.
 Locate your monitor near an easily accessible electrical outlet.
 Place the monitor on a solid surface and treat it carefully. The screen can be damaged if dropped, sharply hit, or
touched with a sharp or abrasive implement.
 Put you

Resumen del contenido incluido en la página 2

Monitor Controls and Indicators A Use these buttons to adjust (decrease/increase ranges) items in the OSD, buttons and to select sub-menus. B Use these buttons with the OSD to move the (highlighted) selection within menus; to select sub-menu items; and to make adjustments on various buttons selections. These buttons are also direct access buttons for the Brightness and Contrast control menu. C The MENU button opens the on-screen menu (OSD), exits from menus and sub-menus, and exits the OSD. M

Resumen del contenido incluido en la página 3

1. Insert the monitor CD into the CD-ROM drive, and click Next> twice when the Add New Hardware Wizard dialog box appears. 2. Click the CD-ROM drive box to install the drivers from the CD and then click Next>. 3. Confirm that the driver was found on the CD, and click Next> twice to install the driver. 4. Click Finish to exit the Add New Hardware Wizard dialog box. To manually install or update the driver, perform the following steps: 1. Click Start!Settings!Control Panel and then double-click

Resumen del contenido incluido en la página 4

No Image Is Displayed on the Monitor If the monitor power indicator is on but no image appears on the display, perform the following checks:  Ensure that the video connector is seated properly. Tighten the connector screws securely with your fingers.  Ensure that the computer is on.  Increase brightness and contrast controls.  Turn off the monitor and unplug the signal cable. Check the cable connector for bent or broken pins.  With the signal cable still disconnected, turn on the monitor.