Manual de instrucciones de LevelOne FNC-0115

Resumen del contenido incluido en la página 1

FNC-0115

100FX Multi-mode SC Fiber Optic PCI Express Card





User Manual

















Ver. 1.00-0801

Resumen del contenido incluido en la página 2

Table of Contents 1. Overview.....................................................................................................................1 2. Checklist .....................................................................................................................1 3. Model Description......................................................................................................1 4. Network Remote Boot Configuration..........................................

Resumen del contenido incluido en la página 3

Caution Circuit devices are sensitive to static electricity, which can damage their delicate electronics. Dry weather conditions or walking across a carpeted floor may cause you to acquire a static electrical charge. To protect your device, always: • Touch the metal chassis of your computer to ground the static electrical charge before you pick up the circuit device. • Pick up the device by holding it on the left and right edges only. Electronic Emission Notices Federal Communicatio

Resumen del contenido incluido en la página 4

1. Overview Fast Ethernet PCI-e 100Base-FX Fiber Adapter is a Fast Ethernet Board that fully complies with all IEEE 802.3u and 100Base-FX standards. Two LED indicators (LINK/ACT and FDX) on the bracket will help to oversee the board link, activities and full-duplex status. Fast Ethernet PCI-e 100Base-FX Fiber adapters support Pre-boot Execution Environment (PXE), Remote Program Load (RPL), and Bootstrap Protocol (BOOTP). Multi-Boot Agent (MBA) is a software module that allows your n

Resumen del contenido incluido en la página 5

5. LED Description LED Color Function Lit when cable connection is good LINK/ACT Green and speed is at 100Mbps. Blinks when any traffic is present. FDX Green Lit when full-duplex mode is active. 6. Wake on LAN The Wake on LAN function on this adapter can recognize a wake-up frame and signal the PC to power up. The default value of WOL (Wake on LAN) function is ON. You can also disable the WOL function by putting the jumper on the pin 1 and pin 2. Never drop the jumper, oth

Resumen del contenido incluido en la página 6

7. Network Parameter Multi-mode Fiber 62.5/125um, 50/125um Full Duplex 2000m LINK/ACT FDX TX RX Fig. 1 Diagnostic LEDs and Bracket 3

Resumen del contenido incluido en la página 7

8. Technical Specifications Standards : IEEE 802.3u Fast Ethernet 100Base-FX IEEE 802.3x Full-Duplex Flow Control IEEE 802.1Q VLAN Connector : 1310nm SC multi-mode Fiber Optic Cable:  62.5/125, 50/125μm multi-mode Data Transfer Mode/Speed:  Full duplex (Default) mode  100Mbps speed Diagnostics LED on Bracket:  LINK/ACT  FDX Bus Slot : PCI-e 1.0 Compliant Power Requirement : Max. 3W, +3.3VDC@1A Ambient Temperature : 0° t