Resumen del contenido incluido en la página 1
R
P/I-XP55TVP4
Pentium ATX Motherboard
USER'S MANUAL
Resumen del contenido incluido en la página 2
USER'S NOTICE No part of this product, including the product and software may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any lan- guage in any form by any means without the express written permission of ASUSTeK COMPUTER INC. (hereinafter referred to as ASUS) except documentation kept by the purchaser for backup purposes. ASUS provides this manual "as is" without warranty of any kind, either express or implied, including but not limited to the implie
Resumen del contenido incluido en la página 3
ASUS CONTACT INFORMATION ASUSTeK COMPUTER INC. Marketing Info: Address: 150 Li-Te Road, Peitou, Taipei, Taiwan, ROC Telephone: 886-2-894-3447 Fax: 886-2-894-3449 Email: info@asus.com.tw Technical Support: Fax: 886-2-895-9254 BBS: 886-2-896-4667 Email: tsd@asus.com.tw WWW: http://www.asus.com.tw/ Gopher: gopher.asus.com.tw FTP: ftp.asus.com.tw/pub/ASUS ASUS COMPUTER INTERNATIONAL Marketing Info: Address: 721 Charcot Avenue, San Jose, CA 95131, USA Telephone: 1-408-474-0567 Fax: 1-408-474-0568 Ema
Resumen del contenido incluido en la página 4
CONTENTS I. INTRODUCTION........................................................................... 1 How this manual is organized .......................................................... 1 Item Checklist .................................................................................. 1 II. FEATURES .................................................................................... 2 Features of the ASUS Motherboard ................................................. 2 Parts of the ASUS Mot
Resumen del contenido incluido en la página 5
CONTENTS Power Management Setup........................................................ 40 Details of Power Management Setup .................................40 PNP and PCI Setup .................................................................. 42 Details of PNP and PCI Setup ............................................ 42 Load BIOS Defaults ................................................................. 44 Load Setup Defaults .................................................................
Resumen del contenido incluido en la página 6
FCC & DOC COMPLIANCE Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provid
Resumen del contenido incluido en la página 7
I. INTRODUCTION How this manual is organized This manual is divided into the following sections: I. Introduction: Manual information and checklist II. Features: Information and specifications III. Installation: Instructions on setting up the motherboard IV. BIOS Setup: BIOS software setup information V. ASUS DMI Utility: BIOS supported Desktop Management Interface VI. ASUS PCI-SC200: Installation of an optional SCSI card VII. ASUS I-A16C: Installation of an optional Audio card VIII. DOS/Win3.1x
Resumen del contenido incluido en la página 8
II. FEATURES (Features) II. FEATURES Features of the ASUS Motherboard The ASUS P/I-XP55TVP4 is carefully designed for the demanding PC user who wants many features in a small package. This motherboard: • Easy Installation: Is equipped with BIOS that supports auto detection of hard drives, PS/2 mouse, and Plug and Play devices to make setup of hard drives, expansion cards, and other devices virtually automatic. • Multi-Processor/Multi-Speed Support: Supports one Intel P54C Pentium (75-200MHz
Resumen del contenido incluido en la página 9
II. FEATURES Parts of the ASUS Motherboard 256/512KB Pipelined CPU ZIF Socket 7 Burst L2 Cache T: USB Port 1 B: USB Port 2 PS/2 Keyboard PS/2 Mouse Parallel Conn. COM 2 Intel's 430VX PCIset COM 1 4 SIMM Slots 4 PCI Slots 4 ISA Slots BIOS Flash ROM ASUS P/I-XP55TVP4 User’s Manual 3 Floppy Drive Connector IDE 2 Connector IDE 1 Connector II. FEATURES (Parts of Board)
Resumen del contenido incluido en la página 10
III. INSTALLATION (Map of Board) III. INSTALLATION Map of the ASUS Motherboard 4 ASUS P/I-XP55TVP4 User’s Manual
Resumen del contenido incluido en la página 11
III. INSTALLATION Jumpers 1) L2SIZE p. 7 Total Level 2 Cache Size Setting (512KB/256KB) 2) BBLKW p. 8 Flash ROM Boot Block Program (Disable/Enable) 3) RTCLR p. 9 Real Time Clock RAM (Operation/Clear Data) 4) FS0, FS1, FS2 p. 10 CPU External Clock (BUS) Frequency Selection 5) BF0, BF1 p. 10 CPU:BUS Frequency Ratio 6) VID p. 11 CPU Voltage Regulator Output Selection Expansion Slots 1) SIMM Sockets p. 12 72-Pin SIMM Memory Expansion Sockets 2) L2 Cache p. 14 Level 2 Cache Expansion Slot 3) CPU ZIF
Resumen del contenido incluido en la página 12
III. INSTALLATION (Jumpers) III. INSTALLATION Installation Steps Before using your computer, you must complete the following steps: 1. Set Jumpers on the Motherboard 2. Install DRAM Modules 3. Install the Central Processing Unit (CPU) 4. Install Expansion Cards 5. Connect Ribbon Cables, Cabinet Wires, and Power Supply 6. Setup the BIOS Software 1. Jumpers Several hardware settings are made through the use of jumper caps to connect jumper pins (JP) on the motherboard. See "Map of the Motherboar
Resumen del contenido incluido en la página 13
III. INSTALLATION Jumper Settings 1. Total Level 2 Cache Size Setting (L2SIZE) This jumper sets the total amount of L2 cache that is present. If you have both onboard cache chips (see "Map of Motherboard" for locations) and a Cache Expansion Slot, then you have 256KB. If you only have onboard cache chips, then you have 512KB. An "ASUS" or "COAST" cache module can be used to upgrade the 256KB version to 512KB. If there is no onboard cache, you may install a cache module of either 256KB or 51
Resumen del contenido incluido en la página 14
III. INSTALLATION (Jumpers) III. INSTALLATION 2. Flash ROM Boot Block Programming (BBLKW) This sets the operation mode of the boot block area of the Programmable Flash ROM to allow programming in the Enabled position. This is required only if prompted by the Flash Memory Writer Utility as shown in BIOS SOFTWARE. Programming BBLKW Disabled/Protect [1-2] (Default) Enabled [2-3] BBLKW BBLKW 123 123 Disabled / Protected Enabled (Default) Boot Block Programming (Disable / Enable) 8 ASUS P/I-XP55TV
Resumen del contenido incluido en la página 15
III. INSTALLATION 3. Real Time Clock (RTC) RAM / Battery Test Jumper (RTCLR) The CMOS RAM is powered by the onboard button cell battery. You can test the battery’s current by removing this jumper and attaching a current meter to each pin. WARNING: You must unplug the power cord to your power supply to ensure that there is no power to your motherboard. The CMOS RAM containing BIOS setup information will be cleared by this action. You must enter BIOS to “Load Setup Defaults” and re-enter any u
Resumen del contenido incluido en la página 16
III. INSTALLATION (Jumpers) FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 FS0 FS1 FS2 III. INSTALLATION 4. CPU External (BUS) Frequency Selection (FS0, FS1, FS2) These jumpers tell the clock generator what frequency to send to the CPU. These allow the selection of the CPU’s External frequency (or BUS Clock). The BUS Clock times the BUS Ratio equals the CPU's Internal frequency (the advertised CPU speed). 5. CPU to BUS Frequency Ratio (BF0, BF1) These jumpers set the frequency ratio between the Intern
Resumen del contenido incluido en la página 17
III. INSTALLATION Compatible Cyrix CPU Identification The only Cyrix CPU that is supported on this motherboard is labeled Cyrix 6x86 P166+ but must be Revision 2.7 and later. Look on the underside of the CPU for the serial number. The number should read G8DC6620A or larger. 6. Voltage Regulator Output Selection (VID0 - VID6) These jumpers set the voltage supplied to the CPU. Determine whether your CPU has a Single Power Plane or Dual Power Planes and then the voltage that it uses. Current Int
Resumen del contenido incluido en la página 18
III. INSTALLATION (SIMM Memory) III. INSTALLATION 2. System Memory This motherboard supports four 72-pin SIMMs of 4MB, 8MB, 16MB, or 32MB to form a memory size between 8MB to 128MB. SIMMs can be either 60ns or 70ns Extended Data Output (EDO) or Asymmetric/Symmetric Fast Page Mode (FPM) modules. . Install memory in any or all of the banks in any combination as follows: Bank SIMM Memory Module Total Memory Bank 0 4MB, 8MB, 16MB, 32MB x2 SIMM Slots 1&2 72-pin FPM or EDO SIMM Bank 1 4MB,
Resumen del contenido incluido en la página 19
III. INSTALLATION SIMM Memory Installation Procedures: 1. The SIMM memory modules will only fit in one orientation as shown because of a "Plastic Safety Tab" on one end of the SIMM sockets which requires the "Notched End" of the SIMM memory modules. 1234 72 Pin SIMM Sockets Bank 0 Bank 1 Notched End 2. Press the memory module firmly into place starting from a 45 degree angle making sure that all the contacts are aligned with the sockets. 3. With your finger tips, rock the memory module into a ve
Resumen del contenido incluido en la página 20
III. INSTALLATION (Level 2 Cache) III. INSTALLATION Static RAM (SRAM) for Level 2 (External) Cache The motherboard you purchase may have either 0KB, 256KB, or 512KB onboard. If you have both onboard cache chips (see "Map of Motherboard" for locations) and a Cache Expansion Slot, then you have 256KB. If you only have onboard cache chips, then you have 512KB. An "ASUS" or "COAST" cache module can be used to upgrade the 256KB version to 512KB. If there is no onboard cache, you may install a cac
