Manual de instrucciones de Fujitsu ETERNUS DX80

Resumen del contenido incluido en la página 1

Disk storage system
P3AM-3102-04EN
Setup Guide (SAS model)
Read this Setup Guide first
This guide describes the workflow required to proceed from installation to
operation of the (SAS model).
Workflow
Preparation Basic Setup
1 5
Read and understand the "Safety Precautions"
Installation Monitoring Setup
2 6
before use.
Cable Connection Server Connection
3 7
"Safety Precautions"
Startup Operation and Maintenance
4 8
The company names, product names and se

Resumen del contenido incluido en la página 2

S T E P Installation The rack rail (bracket) needs to be attached to the rack and the ETERNUS DX60/DX80 mounted. 1. Adjust the rack rail (bracket) 3. Mount the ETERNUS DX60/DX80 in the rack. size to fit the rack. ● Make sure to install or remove the enclosure IMPORTANT (Rear rack pillars) "L" is stamped on the inner to or from the rack by two or more people. Loosen the screws, side of the left rack rail. ● Multiple Drive Enclosures must be connected and adjust the rack rails to the depth of

Resumen del contenido incluido en la página 3

S T E P Startup Connect the PC to the ETERNUS DX60/DX80 with a LAN cable (for operation management), and turn on the ETERNUS DX60/ DX80. n "7.1 Setup Preparation" in the "User Guide" Power switch n "7.2 Basic Setup" in the "User Guide" The first time the power is turned on, volume IMPORTANT formatting may start according to the factory Controller Enclosure default settings. This does not affect the setup operation, which may be started immediately. S T E P Basic Setup Basic ETERNUS DX60/DX80

Resumen del contenido incluido en la página 4

S T E P Monitoring Setup Perform the ETERNUS DX60/DX80 monitoring setup if required. n Notification of ETERNUS DX60/DX80 problems as they occur is possible if the event notification method and level have been set. n For e-mail notification of ETERNUS DX60/DX80 problems, a destination e-mail address must be set. n If "ServerView" is used to monitor the server, the ETERNUS DX60/DX80 must be set to send an SNMP Trap to the server. n If remote support is required, the ETERNUS DX60/DX80 must be set