Manual de instrucciones de Zenoah BC2311LE, BC2611LE, BC2611WE, BC3501LE, BC3501WE, BC4501WE

Resumen del contenido incluido en la página 1

15m (50ft)
848JJ893A0 (709)
BRUSHCUTTERS
BC2311LE
BC2611LE/WE
OWNER’S MANUAL
BC3501LE/WE
Thank you for purchasing a ZENOAH product.
Before using our brushcutter, please read this manual carefully
BC4501WE
to understand the proper use of your unit.
1 Explanation of pictorials
(1) (2) (3) (4) (5) (6) (7)
IMPORTANT
If warning label peels off or becomes soiled and
impossible to read, you should contact the dealer
from which you purchased the product to order new
labels and affix them in the requir

Resumen del contenido incluido en la página 2

[BC3501LE/WE/BC4501WE] 1. Measure out the quantities of gasoline and oil to • Using attached 4 socket screws, secure the be mixed. connection firmly with equal force. 2. Put some of the gasoline into a clean, approved fuel container. 3. Pour in all of the oil and agitate well. 4. Pour In the rest of gasoline and agitate again ■ INSTALLING BLADE for at least one minute. As some oils may be Remove the guard skirt of debris guard, when difficult to agitate depending on oil ingredients, using metal

Resumen del contenido incluido en la página 3

4. Move the choke lever to the closed position. the head and cause the clutch to slip, resulting 5. Set the stop switch to the “RUN” position. in damage to the clutch system if repeated Place the unit on a flat, firm place. frequently. Keep the cutting head clear of everything around it. ADJUSTING THE LINE LENGTH (1) (1) Cable adjuster • Your brushcutters is equipped with a semi- auto (1) type nylon line head that allows the operator to advance the line without stopping the engine. ■ ADJUSTING

Resumen del contenido incluido en la página 4

through the eyelets on the housing. Make sure ■ IMUFFLER that the spring and the washers are in place. WARNING 6. While holding the spool against the housing, pull the line ends to release them from the slot. •Inspect periodically, the muffler for loose 7. Line up the slot on the bottom cap with the hook fasteners, any damage or corrosion. If any on the housing, press the cap against the sign of exhaust leakage is found, stop using housing until it clicks. the machine and have it repaired immedi