Manual de instrucciones de Sunbeam 3108

Resumen del contenido incluido en la página 1

Adjustable
Can Ot3ener
instruction
- Model #3108/M6del#3138

Resumen del contenido incluido en la página 2

31

Resumen del contenido incluido en la página 3

When using electrical appliances, basic safety precautions should always be followed including the following: l Read all instructions before using the can opener. l To protect against the risk of electrical shock, do not put can opener in water or other liquid. l Close supervision is necessary when any can opener is used by or near children: l Unplug from outlet when not in use, before putting on or taking off parts, and before cleaning. l Avoid contacting moving parts. l Do not opera

Resumen del contenido incluido en la página 4

Plug electrical cord into 120 volt, 60 cycle AC outlet. Raise can opener lever to upright position (A). Insert can so that the lower edge of the can lip rests on top of the drive wheel. Be certain that the cutting edge is on the inside of the can lip as shown (B).Push can opener lever down firmly (C) and hold until the can lid is automatically pierced and the cutting action begins. It is not necessary to hold the can opener lever down during the cutting cycle. When the can is fully open,

Resumen del contenido incluido en la página 5

To insure proper sanitation, all removable parts on the can opener should be detached and cleaned thoroughly in warm, sudsy water at regular intervals. Before cleaning, UNPLUG THE CORD FROM OUTLET. The motor housing easily wipes clean using a damp cloth. Never immerse the motor housing in water. Removing the Lid litter: Lift up to slide out as pictured (E). Removing the Cutting Unit: Raise can opener lever to its fullest upright position. Push can opener lever to the right to remove it

Resumen del contenido incluido en la página 6

Twist the knob to raise and lower the cutting assembly. To adjust the height of the cutting assembly follow these directions: 1. Twist the knob in a counter-clockwise direction until the knob clicks into place. The cutting assembly Is raised for opening extra tall cans. 2. Twist the knob in a clockwise direction to lower the cutting assembly for opening regular size cans and for compact storage. The motor and internal gears of your can opener unit are permanently lubricated at the factory for li

Resumen del contenido incluido en la página 7

31

Resumen del contenido incluido en la página 8

Knives: Plug the electrical cord into a 120 volt, 60 cycle AC outlet. Press down on the can opener lever to start the grinding wheel. Allow the motor to develop full speed. Insert the knife into either slot of the sharpening guide, holding it flat against the sloping wall of the housing. Lower the blade until it touches the wheel. Draw the knife blade towards you (I), keeping the blade against the sloping wall of the housing.Maintain only a slight pressure on the wheel. Repeat the same