Resumen del contenido incluido en la página 1
Electronic Air Cleaner
Model Number Model Number
Model Number Model Number Model Number
SST
SST1000 SST1000
SST1000 SST1000 SST1000
SST1400 SST1400
SST1400 SST1400 SST1400
SST1600 SST1600
SST1600 SST1600 SST1600
SST2000 SST2000
SST2000 SST2000 SST2000
O O O O OWNER’S MANU WNER’S MANU WNER’S MANU WNER’S MANU WNER’S MANUAL AL AL AL AL
• • Installation Installation
• • • Installation Installation Installation
• • Operation Operation
• • • Operation Operation Operation
• • Basic SST Service Guide Ba
Resumen del contenido incluido en la página 2
R RULES FOR SAFE ULES FOR SAFE R R RULES FOR SAFE ULES FOR SAFE ULES FOR SAFE If this unit has an electrical cord, the cord has a grounding type INST INST INSTALLA ALLA ALLATION TION TION AND OPERA AND OPERA AND OPERATION TION TION INST INSTALLA ALLATION TION AND OPERA AND OPERATION TION plug with a third (grounding) pin. This plug will fit only into a grounding type power outlet. If the proper type of outlet is not Please read instructions before installing and using the Elec- available, contac
Resumen del contenido incluido en la página 3
AB C HO HOW W THE THE AIR CLEANER AIR CLEANER W WORKS ORKS HO HO HOW W W THE THE THE AIR CLEANER AIR CLEANER AIR CLEANER W W WORKS ORKS ORKS Dirt particles flowing through the ducts (Figure 1) first enters Dirty Air In Clean Air Out the pre-filters (A) where large particles (hair, lint, etc.) are trapped. Smaller particles (smoke, dust, pollen, etc.) pass through these pre-filters and enter the ionizing section (B). Here each tiny particle receives a positive electrical charge. These charged par
Resumen del contenido incluido en la página 4
PREINST PREINSTALLA ALLATION TION PREINST PREINST PREINSTALLA ALLA ALLATION TION TION (Interchangeable) (Interchangeable) Collecting Cell Collecting Cell Not to Exceed 20 Outlet Box Cabinet Power Pack Air Flow Handle Air Flow Furnace Opening Contact Electronic Button Air Cleaner Contact Pre-Filters Opening Button (Interchangeable) See text for Cell Removal Clearance Furnace Electronic Transition Section Figure 4 Air Cleaner (if Needed) Knockouts for Figure 3 3/4" Conduit 6 7/8" (three sides) LO
Resumen del contenido incluido en la página 5
TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS TYPICAL MOUNTING POSITIONS Air Flow Air Flow Air Flow Rear View Rear View Figure 6 Figure 8 Figure 7 BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE BASEMENT FURNACE HIGHBOY FURNACE HIGHBOY FURNACE HIGHBOY FURNACE HIGHBOY FURNACE HIGHBOY FURNACE COUNTERFLOW COUNTERFLOW COUNTERFLOW COUNTERFLOW COUNTERFLOW (LOWBOY) (Figure 6) (LOWBOY) (Figure 6) (LOWBOY) (Figure 6) (LOWBO
Resumen del contenido incluido en la página 6
INST INSTALLA ALLATION TION INST INST INSTALLA ALLA ALLATION TION TION REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD REMOVE OLD FILTER AND DISCARD (Figure 12) (Figure 12) (Figure 12) (Figure 12) (Figure 12) NOTE: This filter may be mounted in the furnace compart- ment. CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT CLEAN BLOWER COMPARTMENT It is suggested that the furnac
Resumen del contenido incluido en la página 7
WIRING INSTR WIRING INSTRUCTIONS UCTIONS WIRING INSTR WIRING INSTR WIRING INSTRUCTIONS UCTIONS UCTIONS 7. With the cabinet installed, the air cleaner can now be 10. If this unit has an electrical cord, the cord has a wired to electrical input source. grounding type plug with a third (grounding) pin. This plug will fit only into a grounding type power outlet. If ! WARNING the proper type of outlet is not available, contact qualified personnel to install a proper outlet. Do not Installation of thi
Resumen del contenido incluido en la página 8
OPERA OPERATION TION OPERA OPERA OPERATION TION TION 1. With the 120 VAC power turned on at the circuit breaker for the furnace, push the air cleaner ON-OFF switch to the “ON” position (Figure 20). 2. With the furnace blower running, the air cleaner will be operating. An arcing or “snapping” sound may be heard. This will occur occasionally, however the unit is operating properly. 3. With the furnace blower running, the Operating Light should be ON. If the Operating Light is not ON this signifies
Resumen del contenido incluido en la página 9
REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE REPLACING AN IONIZING WIRE If an ionizing wire should break, it can be replaced as follows: 1. Remove all pieces of broken wire. Make sure sup- ports at each end are in good condition and not bent out of shape. 2. Hook the new wire onto the support at one end. 3. Hold your finger against the support at the other end (Figure 21) and hold the ionizing wire between thumb and forefinger as sho
Resumen del contenido incluido en la página 10
B B B B BASIC SST SER ASIC SST SER ASIC SST SER ASIC SST SER ASIC SST SERVICE GUIDE VICE GUIDE VICE GUIDE VICE GUIDE VICE GUIDE This guide will cover most homeowner complaints. If, after checking the items listed, the unit still fails to operate properly, contact the nearest Authorized Service Center. SER SER SERVICE INDICA VICE INDICA VICE INDICATION TION TION SER SER SERVICE CHECKS VICE CHECKS VICE CHECKS SER SERVICE INDICA VICE INDICATION TION SER SERVICE CHECKS VICE CHECKS ON/OFF switch “ON”
Resumen del contenido incluido en la página 11
Blk Wht Blu Wht/Brn TECHNICAL REP TECHNICAL REP TECHNICAL REP TECHNICAL REP TECHNICAL REPAIR GUIDE AIR GUIDE AIR GUIDE AIR GUIDE AIR GUIDE All voltage measurements indicated can be made with a ! WARNING high voltage D.C. probe and a general purpose volt ohm Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless you are Do not attempt repair of this unit unless
Resumen del contenido incluido en la página 12
4. Using a standard extension cord, apply 120 VAC to POWER SUPPLY POWER SUPPLY POWER SUPPLY POWER SUPPLY POWER SUPPLY power pack. Turn power switch to “ON” position. CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE CHECKOUT PROCEDURE 5. Connect meter negative (-) lead to metal frame of 1. Turn power switch to the “OFF” position and remove collecting cell. Use high voltage probe to measure the power pack from cabinet. voltage at collecting cell ionizer or cell plates. V
Resumen del contenido incluido en la página 13
OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION OZONE REDUCTION All electronic air cleaners typically produce a small amount of ozone that is within established limits. Some customers may notice an odor especially at high altitudes or low air flow rates. W1 This power supply has a “hairpin” shaped jumper Cut and separate wire labeled W1 (see Fig 24) that can be cut and Ozone Reduction separated in case of such complaints. This will Jumper cause the power supply to limit the maxim
Resumen del contenido incluido en la página 14
REP REPAIR P AIR PAR ARTS TS REP REP REPAIR P AIR P AIR PAR AR ARTS TS TS 15 18 14
Resumen del contenido incluido en la página 15
REP REPAIR P AIR PAR ARTS TS REP REP REPAIR P AIR P AIR PAR AR ARTS TS TS PARTS LIST FOR ELECTRONIC AIR CLEANERS When ordering repair parts, always give the following information as shown in this list. 1. The PART NUMBER 2. The PART DESCRIPTION 3. The MODEL NUMBER 4. The NAME OF ITEM - Electronic Air Cleaner. Al Alw wa ays or ys order b der by “P y “PAR ART NUMBER” T NUMBER” . . . . . . Not b Not by “ITEM NUMBER” y “ITEM NUMBER” Al Al Alw w wa a ays or ys or ys order b der b der by “P y “P y “
Resumen del contenido incluido en la página 16
WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE WASH REMINDER SCHEDULE frequent washing may be necessary on some installations A regular washing schedule is necessary to ensure proper where there is new carpeting, plaster dust or excessive efficiency. A thorough washing once every month will be cigarette smoke, etc. (See page 8 for maintenance and adequate for most installations. More or Less instructions on how to clean a cell.) Year JAN FEB MAR APR M
