Manual de instrucciones de Philips Manufactured Housing Vinyl

Resumen del contenido incluido en la página 1

P H I L I P S
P R O D U C T S
MANUFACTURED HOUSING
VINYL WINDOW
INSTALLATION INSTRUCTIONS
(EXCLUDES STORM WINDOWS)
PHILIPS PRODUCTS
L IT -1610
PHONE NUMBER:
3/05
574/296-0000 R EV 2

Resumen del contenido incluido en la página 2

G ENERAL PROPER INSTALLATION IS ESSENTIAL FOR THE 2. Check the squareness with diagonal measurements (see figure 1). ACCEPTABLE PERFORMANCE OF THIS WINDOW. The difference between 1 to 4 and 2 to 3 should not exceed 1/4". If IMPROPER INSTALLATION WILL VOID THE WARRANTY. the R.O. does not conform to these requirements, it must be modified so that the sill is square to the floor within tolerance and These instructions are for Philips Products, Inc. vinyl windows only. the diagonals are withi

Resumen del contenido incluido en la página 3

1. Measure the window prior to proceeding with the installation to Figure 2 ensure that it matches the rough opening. 2. These windows are fabricated with fusion welded joined corners. Care should be exercised in the handling of the products as it is possible to crack the welded outer frame. Inspect the outer frame for damage. If frame is cracked, fractured, or damaged due to handling, contact Philips Products, Inc. for instructions. 3. Inspect the mounting flanges to ensure they have not

Resumen del contenido incluido en la página 4

6. Apply a ¼" continuous bead of pumpable sealant to the back 4. W arning: Fenestration products are not to be used with corrugated metal siding. side of the mounting flange (see figure 3), in line with pre- punched holes. (Caution: If the window units are pre-sealed prior 5. After the fasteners have been installed through the midpoint of to installation, a skin may form on the sealant, causing a potential each mounting flange, it is recommended that you re-check the for failure. Refer to

Resumen del contenido incluido en la página 5

6. Caution: The mounting flange is provided with pre-punched O PTIONAL F IELD M ULLING /S T ACKING P ROCEDURES holes, never leave holes or slots unsealed; water can penetrate. (Series 800 Windows Only) Caution: Fasteners should be installed so spacing is not more than 10" on center (see figure 4), but may be installed closer For mulling/stacking instructions use Lit-1607. together if so desired. Continue installation of the rest of the fasteners starting in the center of each member and

Resumen del contenido incluido en la página 6

C ASEMENT W INDOW H ING E A DJUSTMENT P ROCEDURES N OTE : T HESE PROCEDURES ARE T O BE USED ONL Y I F THE WINDOW NEEDS FUTURE ADJUSTING . 1. The amount of sash that this hinge will compensate for is dependant on the ratio of the sash width vs. sash height. To calculate the amount of sash drag adjustment for any given window size, take the ratio of width to height multiplied by 1/16”. Example: Sash size equals 24” x 36”, width to height ratio is .667. Total adjustment is .667 x 1/16 = .042 (a