Resumen del contenido incluido en la página 1
STAINLESS STEEL GAS GRILL
USE AND CARE GUIDE
®
MODEL NO.:720-0125-LP
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-913-8999 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE.
Resumen del contenido incluido en la página 2
IMPORTANCE WARNING * * * *** FOR YOUR SAFETY If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid 4. If odor continues, immediately call you gas supplier or your fire department. FOR YOUR SAFETY 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. 2. An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. 1
Resumen del contenido incluido en la página 3
TABLETABLE OF CONTENTS SECTION TWO: SECTION ONE: Assembly instruction………………4-11 Precaution…………………………1-2 Gas hook-Up ………………………. 12 Placement of the grill ……………...3 Leak testing ….……………………. 12 Installer final ….…………………… .13 Propane tank Assemble ……………14 Operating instruction……………….15 SECTION THREE: SECTION FOUR Lighting instruction ……………………………..16 Explodedview ………………………………22 Using the side burner …………………………..17 Partslist…………………………………..….23 C
Resumen del contenido incluido en la página 4
PRECAUTIONS Do not repair or replace any part of the grill unless WARNING specifically recommended in this manual. All other Do not try lighting this appliance without reading the service should be referred to a qualified technician. “LIGHTING INSTRUCTIONS” section of this manual. CHILDREN SHOULD NOT BE LEFT ALONE OR TESTED IN ACCORDANCE WITH ANSI Z21.58a- UNATTENDED IN AN AREA WHERE THE GRILL 1995 STANDARD FOR OUTDOOR COOKING GAS IS BEING USED. NEVER ALLOW THEM TO SIT, APPLIAN
Resumen del contenido incluido en la página 5
PRECAUTIONS When using the grill, do not touch the grill rack, burner could, in the presence of heat, ignite or cause metal parts grate or immediate surroundings as these areas become to corrode. extremely hot and could cause burns. Use only dry potholders. Moist or damp potholders on hot surfaces Do not use the grill for cooking excessively fatty meats or may cause burns from steam. Do not use a towel or bulky products which promote flare-ups. Do not operate the grill cloth in place or p
Resumen del contenido incluido en la página 6
T M The Glasso ASSEMBLY INSTRUCTIONS PLEASE READ THE INSTRUCTIONS CAREFULLY AND FOLLOW STEP BY STEP. Attention: Please lock the caster during the process of installation of the grill. TOOLS REQUIRED: Philips head screwdriver(not provide),monkey wrench(not provide) Step1 ：. Assemble two regular casters to the right side panels and caster with brakes on the left side panel as shown figure below.. 4
Resumen del contenido incluido en la página 7
T M The Glasso Step 2: : Assemble bottom panel to side panels,back panel and transom panel with eight( 14) 1/4’ *15 mm screws as shown figure below Step 3: Assemble the head part to the bobywork part. Remove the head unit of grill from carton. Insert the upper portion of the grill onto the cart from the top with four (4)1/4*13mm screws. Caution!! The firebox is heavy, and we recommend two or more people to lift up firebox. 5
Resumen del contenido incluido en la página 8
T M The Glasso Step 4: First assemble handle of side shelf,then assemble sprice tray and control panel of side burner as the figure show below: Step5: Remove the head unit of screws with four (8)1/4’*13mm screws. 6
Resumen del contenido incluido en la página 9
The Gla Ts M so T M The Glasso Step 6 : Assemble the fortified steel to the main with (8)1/4’*13. . Step7: Assemble side shelf and side burner with four(8) 1/4*13mm screws as figure show below . 7
Resumen del contenido incluido en la página 10
ASSEMBLY INSTRUCTIONS Side burner valve assembly: Step 1: Insert valve assembly through side Step 2: Remove 4(four) screws & washers panel from the “U” brackets on the side burner Valve (#22) (Side panel, right #29) Step 3: Insert valve stem assembly
Resumen del contenido incluido en la página 11
T M The Glasso T M The Glasso Step 8: Assemble the door to the grill as the figure show below: Step9: Assemble the motor bracket to the fire box with four (4) 1/4*10mm screws. 9
Resumen del contenido incluido en la página 12
How to install a gas tank Opening the front door and place gas tank into the gas tank holes. Secure the gas tank by turning the retention screw at the right of the grill clockwise until it is tight. . 10
Resumen del contenido incluido en la página 13
Your gas grill is ready to use 11
Resumen del contenido incluido en la página 14
GAS HOOK-UP Only the pressure regulator and hose assembly L.P. GAS HOOK-UP: supplied with the grill should be used. Any Ensure that the black plastic grommets on the LP replacement pressure regulator and hose assembly cylinder valve are in place and that the hose does must be specified by the grill manufacturer. not come into contact with the grease tray or the grill head. This is a liquid propane configured grill. Do not attempt to use a natural gas supply unless the grill CONNECTI
Resumen del contenido incluido en la página 15
local gas supply may make it necessary to adjust BEFORE TESTING the burners. The flames of the burners should be Make sure that all packing material is removed from visually checked. the grill including the burner tie-down straps. Flames should be blue and stable with no yellow DO NOT SMOKE WHILE LEAK TESTING. tips, excessive noise or lifting. If any of these conditions exist, check to see if the air shutter or NEVER LEAK TEST WITH AN OPEN FLAME. burner ports are blocked by dirt, de
Resumen del contenido incluido en la página 16
PROPANE TANK ASSEMBLE Attach propane gas tank to regulator inlet fitting by turning the regulator clockwise as shown in figure below. LP gas cylinder must be fitted with a listed overfill prevention device (OPD) 14
Resumen del contenido incluido en la página 17
OPERATING INSTRUCTION General use of the grill Each main burner is rated at 12,000 Btu/hr. The The rotisserie motor is capable of turning up to a main grill burners encompass the entire cooking 12lb. cut of meat or poultry. The motor slides onto area and are side ported to minimize blockage from the stainless steel motor mount. The rotisserie falling grease and debris. Above the burners are motor must be electrically grounded in accordance stainless steel radiant (flame covers). The ign
Resumen del contenido incluido en la página 18
LIGHTING INSTRUCTIONS WARNING: IMPORTANT! variations in the local gas supply may take minor adjustments necessary. BEFORE LIGHTING… Inspect the gas supply hose prior to turning the gas Burner flames should be blue and stable with no “ON”. If there is evidence of cuts, wear, or abrasion, yellow tips, excessive noise, or lifting. If any of it must be replaced prior to use. Do not use the grill these conditions exist call our customer service line. if the odor of gas is present. Only
Resumen del contenido incluido en la página 19
USING THE SIDE BURNER control knob counterclockwise to the “HI” position. If WARNING: IMPORTANT! the burner does not light, turn the control knob to USING THE SIDE BURNER: “OFF”. If the smell of gas is detected and the igniter Inspect the gas supply hose prior to turning the gas is not functioning, immediately turn the control knob “ON”. If there is evidence of cuts, wear or abrasion, “OFF”. Allow 5 minutes for any accumulated gas to it must be replaced prior to use. Do not use the side
Resumen del contenido incluido en la página 20
LIGHTING ILLUSTRATIONS Step1. Make sure the lid is open Step 2. Push and turn one of main or side burner knobs to HI position Step 3. You may need 3 or 4 trials to light the burner. After the burner is lit, adjust the knob as desired 18
