Resumen del contenido incluido en la página 1
Mi4004 Suffix A
User’s Guide
iWake Clock Radio
with Dual Alarm
Before operating this product,
please read these instructions completely.
Resumen del contenido incluido en la página 2
SAFETY PRECAUTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER- SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock t
Resumen del contenido incluido en la página 3
SAFETY PRECAUTIONS INFORMATION: This equipment complies with Class B digital device regulations. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turn
Resumen del contenido incluido en la página 4
LOCATION OF CONTROLS FRONT/TOP 9. TIME SET Button 1. TUNE Up/Down/Skip n / o 10. HR (Hour) Button Buttons ® 11. MN (Minute) Button 2. iPod Dock with 12. AL1 SET Button Connector & 13. AL2 SET Button Interchangeable Universal 14. ALARM 2 Button Docks 15. ALARM 1 Button 3. VOLUME Up/Down 16. SNOOZE/SLEEP Button Buttons 17. Right Speaker 4. Power Button ® 18. Remote Sensor 5. iPod /LINE IN Button 6. AM/FM Button 7. Left Speaker 8. Display 3
Resumen del contenido incluido en la página 5
LOCATION OF CONTROLS (CONTINUED) REAR 1. DIMMER Switch 2. DC 13.5V IN Jack 3. LINE IN Jack 4. FM Wire Antenna 5. DST (Daylight Savings Time) Switch 6. Headphones Jack 7. Battery Compartment (Bottom of Unit) 4
Resumen del contenido incluido en la página 6
LOCATION OF CONTROLS (CONTINUED) REMOTE 1. Battery Compartment 5. VOLUME Up Button (Side of Unit) 6. Power/PLAY/PAUSE 2. TUNE Down/Skip o (®p) Button Button 7. TUNE Up/Skip n Button 3. VOLUME Down Button 8. Belt Clip 4. MODE Button NOTES: • The remote buttons function in the same way as the buttons on the main unit. ® • To switch between modes (AM/FM, LINE IN or iPod , use the MODE button. • To turn on the unit, press the Power/PLAY/PAUSE (®p) button. To turn the unit off, press and hold the Po
Resumen del contenido incluido en la página 7
POWER SOURCE AC CONNECTION Insert the small end of the AC adapter into the DC 13.5V IN jack (located on the rear of the unit). Connect the other end to a wall outlet having 120V AC, 60 Hz. AC Adapter, DC 13.5V Z NOTES: • The AC adapter supplied with the unit is polarized to help minimize the possibility of electric shock. If the AC plug does not fit into a nonpolarized AC outlet, do not file or cut the wide When using a grounding adapter, make blade. It is the user’s responsibility to sure the re
Resumen del contenido incluido en la página 8
POWER SOURCE (CONTINUED) REMOTE BATTERY INSTALLATION 1. Remove the Battery Compartment by pressing in on the tab and then sliding the compartment out. 2. Install a CR2025 battery, paying attention to the polarity diagram in the Battery Compartment (positive side up). 3. Replace the Battery Compartment. BATTERY PRECAUTIONS Follow these precautions when using batteries in this device: 1. Use only the size and type of batteries specified. 2. Be sure to follow the correct polarity when installing the
Resumen del contenido incluido en la página 9
® INSERTING AN IPOD 1 2 ® Locate the correct iPod Universal Dock Press the rear side of the holder until it to use as shown on pages 16-17. Insert is positioned inside the cavity. the dock into the cavity (as shown), NOTE: To remove the holder, insert making sure the tabs are facing front, your finger (or other object) into the gap and slip the tabs into place. in the holder, then gently pull the holder out to remove it. 3 4 ® If using the dock: Insert the iPod onto If using the LINE IN jack: In
Resumen del contenido incluido en la página 10
OPERATION ® USING AN IPOD WITH THIS UNIT 1 2 ® ® With an iPod connected (see Operate the iPod as per its previous page), turn the Mi4004 on by owner’s manual and the sound will pressing the Power button (if it is not be heard through the Mi4004’s on already); “iPod” will appear in the speakers. display. 1 Adjust the volume as desired by 1 1 1 NOTE: If the Mi4004 is in a mode pressing the Volume Up/Down ® other than iPod , press the buttons. ® ® iPod /LINE IN button to select iPod mode. NOTES: 3
Resumen del contenido incluido en la página 11
OPERATION (CONTINUED) USING THE RADIO 1 2 Turn the Mi4004 on by pressing the Press the AM/FM button Power button; "AM" or "FM" will repeatedly to select the desired 1 1 appear in the display. band (AM or FM). 3 4 Repeatedly press the TUNE Adjust the volume as desired by Up/Down/Skip n / o buttons to manually pressing the Volume Up/Down advance the frequency in the display up buttons. or down until the desired frequency For private listening, plug in appears. 1 headphones into the Headphones For
Resumen del contenido incluido en la página 12
OPERATION (CONTINUED) TO SET OR RESET THE ACTUAL TIME 1 2 2 1 Within 5 seconds, press the MN With the power off, press the TIME SET button; the time will (Minute) button 1 to set the 1 blink. present minute and the HR (Hour) button 2 to set the present hour. Make sure to set the correct AM/PM setting. DST (DAYLIGHT SAVINGS TIME) 3 1 Press the TIME SET button (or For your convenience, there is a DST (Daylight Savings Time) switch wait approx. 5 seconds) and the 1 located on the rear of the unit.
Resumen del contenido incluido en la página 13
OPERATION (CONTINUED) TO SET OR RESET THE ALARM TIME 1 2 1 1 3 2 With the power off, press either the Within 5 seconds, press the MN AL1 SET button 1 (to set Alarm 1) (Minute) button 1 to set the alarm or AL2 SET button 2 (to set Alarm minute and the HR (Hour) button 2 2) ; the Alarm time will blink in the to set the alarm hour. Make sure to display. set the correct AM/PM setting. Press the AL1 SET button 3 or AL2 SET button 4 again (or wait approx. 5 seconds); the alarm time will stop blinking.
Resumen del contenido incluido en la página 14
OPERATION (CONTINUED) 5 ® ® If set to iPod , insert the iPod as shown on ® page 8. Then, using the controls on the iPod , select the track that you would like to wake to ® and put the iPod into Pause mode. DO NOT ® turn the iPod off; let it go to sleep by itself. When the alarm time is reached, the unit will start playback on the track that you selected and the tracks following it in the playlist. The Mi4004 will playback for 20 minutes then turn off automatically or, if the remaining playlist h
Resumen del contenido incluido en la página 15
OPERATION (CONTINUED) TO SHUT THE ALARM OFF 1 2 1 2 3 1 2 ® If the alarm was set to Radio or iPod , press the Power button 1 to turn off the alarm and If the alarm was set to BUZZ, press the the alarm will be set for the next day. To not ALARM 1 1 or ALARM 2 2 button set the alarm for the next day, press the (which corresponds to the alarm that ALARM 1 2 or ALARM 2 3 button (which was set) and the alarm will turn off and corresponds to the alarm that was set) NOT be set for the next day. To set
Resumen del contenido incluido en la página 16
OPERATION (CONTINUED) SLEEP DIMMER SWITCH 1 1 ® With the unit in the LINE IN, iPod or Slide the DIMMER switch to adjust Radio mode, press the SNOOZE/ the dimmer of the display. If the SLEEP button; the SLEEP indicator and display is too dim, slide the "10" will appear in the display for five DIMMER switch towards “H” for a seconds which indicates the unit will turn brighter display. Slide the DIMMER off after 10 minutes. Repeatedly press switch towards “L” for a less bright the SNOOZE/SLEEP butt
Resumen del contenido incluido en la página 17
OPERATION (CONTINUED) ® IPOD UNIVERSAL DOCKS ® Locate your iPod in the chart on the next two pages and select the respective Universal Dock (the Universal Dock No. is engraved at the front ® of the Universal Docks as shown on the next page) to match with your iPod . ® Insert the corresponding Universal Dock and your iPod into the unit as described on page 8. ® iPod Type Memory Univ. Dock No. Fourth 10 to No. 4 Generation 15GB ® iPod 30GB No. 5 ® iPod 30GB No. 6 Photo 40 to No. 7 60GB ® iPod 4 t
Resumen del contenido incluido en la página 18
OPERATION (CONTINUED) ® iPod Type Memory Univ. Dock No. ® iPod 2 to nano 4GB Please use the Universal Fifth 30GB Dock included Generation ® with your iPod . ® iPod (w/Video) 60GB NOTE: • The 5 holders provided with this unit are Universal Docks. IMPORTANT! The Universal Dock No. is engraved at the front of the docks. Please refer to the illustration below for the location of the Universal Dock No. 17
Resumen del contenido incluido en la página 19
TROUBLESHOOTING GUIDE If you experience a problem with this unit, check the chart below before calling for service. SYMPTOM CAUSE SOLUTION No sound. Volume is Increase volume. set to minimum. AM or FM, no sound. Power is not on. Press the Power button, then the AM/FM button to select AM/FM. Volume is Increase volume. set to minimum. AM/FM, poor sound. Station is not tuned Retune the AM or FM properly. broadcast station. FM: Wire Extend FM wire antenna is not antenna. extended. AM: Unit is not p
Resumen del contenido incluido en la página 20
SPECIFICATIONS GENERAL: Power Source .............DC 13.5V Adapter (Center Positive) Battery Backup.......................2 x 1.5V “AAA” size batteries Speaker...............................................................2 x 4 ohms Output Power ...........................................................2 x 5W RADIO SECTION: Frequency Range (FM) ................................87.5–108 MHz Frequency Range (AM) ...............................520–1710 KHz Specifications are subject to change witho
