Manual de instrucciones de Life Fitness Pro 9000 Series

Resumen del contenido incluido en la página 1

2 STACK MULTI-JUNGLE (SM20)
UNPACKING AND ASSEMBLY INSTRUCTIONS
M051-K50-A123 1

Resumen del contenido incluido en la página 2

SM20 Unpacking & Assembly Instructions The SM20 comes partially assembled. Follow the steps below to complete the assembly. WARNING: COMPONENTS OF THE SM20 ARE LARGE AND HEAVY. USE CAUTION WHEN ASSEMBLING THIS MACHINE. MATERIALS AND TOOLS REQUIRED FOR ASSEMBLY 9/16” 9/16” Pinch bar Socket wrench with Combination extension wrench You will also need a ladder. ASSEMBLY TIME Two people can accomplish this assembly in approximately 1/2 hour. UNPACKING Follow the steps below when unpacking the compon

Resumen del contenido incluido en la página 3

SM20 Unpacking & Assembly Instructions ASSEMBLY Figure 1 shows an assembled SM20. Figure 1. SM20 main components (cables removed for clarity). 1. 1 stack cell (2) 2. Connecting beam 1. Place the two weight “cells” in their final resting spots. The cells will be approximately 11’4” apart as shown in Figure 2. Figure 2. Set the weight stack cells. 3

Resumen del contenido incluido en la página 4

SM20 Unpacking & Assembly Instructions 3. Bolt on the connecting beam using a 5/8” socket with extension and combination wrench, to the cells using the four 7/16” x 6” bolts, 7/16” washers, and 7/16” nuts, end cap washers and end caps. Figure 3 shows the connected cells. You may wish to use a pinch bar to align the bolt holes. Figure 3. Bolt on the connecting beam. Figure 4. Configuration for 6” bolts. 4

Resumen del contenido incluido en la página 5

SM20 Unpacking & Assembly Instructions CROSSOVER CABLE ROUTING NOTE: THE INFORMATION BELOW IS FOR REFERENCE ONLY. THE CABLES ON THE SM20 HAVE BEEN INSTALLED AT THE FACTORY. Figure 5. Crossover cable routing. 5

Resumen del contenido incluido en la página 6

SM20 Unpacking & Assembly Instructions Figure 8. Screw the pulley into the weight stack. 6

Resumen del contenido incluido en la página 7

SM20 Unpacking & Assembly Instructions HARDWARE Hardware Figure 1. Assembly Parts. The parts shown in Hardware Figure 1 are used to assemble the SM20. They are: A. 7/16” x 6” hex head bolt (used to bolt connecting beam to the tops of the cells) B. 7/16” flat washer C. 7/16” cap washer (use on head end of the 6” bolt so end cap will fit on the nut) D. 7/16” hex head nut E. End caps (bolt covers) PARTS LIST Part # ID Description Quantity Main components 1 1-stack cell 2 Connecting beam 1 2 6” bolt