Manual de instrucciones de Grizzly 1553

Resumen del contenido incluido en la página 1

INSTRUCTIONS FOR C1550, 1551, 1553, 1554 and
C1552, C1555 SASH SETS
These router bits have sharp
•Failure to follow theSE
edges. use care while
guidelines will result in seri-
removing the waxy protec-
ous personal injury.
tive coating. Never turn on
•ALWAYS WEAR ANSI
the router with the protective
APPROVED EYE AND EAR
coating still on the bit.
PROTECTION WHEN USING
THIS BIT.
Designed specifically for archi-
•The use of a router table is
tectural window construction,
strongly recommended.
the M

Resumen del contenido incluido en la página 2

Step 2: Cutting Rail Ends Unplug the router and change bits. Raise the router bit so the top of the bead is Outer Side 1 ⁄16" below the top of your stock as shown in Figure B. Make sure that the miter gauge used passes closely enough to the router bit to give the workpiece proper support. It is recommended an extension be applied to the miter with screws, if the miter is more than an inch from the bit. See Figure C. Make 1 ⁄16'' sure that miter and face have working clearance so they won’t come