Manual de instrucciones de Grizzly H0801

Resumen del contenido incluido en la página 1

HEAT GUN
MODELS H0800 1200W AND H0801 1800W
110V - 120°C TO 590°C (248°F TO 1094°F)
INSTRUCTION MANUAL
COPYRIGHT © 2000 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
307100624 OCTOBER, 2000 PRINTED IN CHINA

Resumen del contenido incluido en la página 2

TABLE OF CONTENTS I. SAFETY INSTRUCTIONS 1 II. WARNINGS 1 III. STRIPPING OF PAINT OR VARNISH 3 IV. REMOVAL OF ADHESIVE FLOOR TILE 3 V. OTHER JOBS 3 VI. IMPORTANT 4 VII. SERVICE 4

Resumen del contenido incluido en la página 3

SAFETY INSTRUCTIONS BOTH MODELS H0800 AND H0801 ARE RATED FOR 110V/60 CYCLE HOUSEHOLD CURRENT. HEAT GUNS ARE DOUBLE INSULATED. Before starting work, please take a few minutes to carefully read all instructions. Pay close attention to safety guidelines and warnings included for your protection. Save these instructions for future use. WARNING * Never use the heat gun as a hair dryer! * For safe operation, read manual thoroughly. * Never use the heat gun near flammable materials or gases. * Use A

Resumen del contenido incluido en la página 4

WARNING * When servicing, use only identical replacement parts. * Never direct the hot airflow toward people or animals. * Do not wear loose-fitting clothing or jewelry. Wear nonskid footwear and a protective hair covering to contain long hair. * Maintain proper balance and footing at all times. * Keep the gun handle dry, clean, and free from oil and grease. * Always allow the heat gun to cool down completely before storing it. * Always store the gun in a safe place, out of the reach of childre

Resumen del contenido incluido en la página 5

WARNING * STAY ALERT! Always pay attention to the work at hand and use common sense when operating this and all tools. Do not operate the tool when you are tired or taking medication or drugs that may make you drowsy. STRIPPING OF PAINT OR VARNISH During removal, each of these finishes reacts differently to the heat as far as time needed and how they appear when heated. Latex may simply soften. Oil base paints will bubble or blister and may start to lift off the wood. Pre-experimentation is r

Resumen del contenido incluido en la página 6

STRIPPING OF PAINT, VARNISH OTHER JOBS Drying out paint and varnishes or wet, damaged timber prior to filling with compound and refinishing. Softening old putty before removal and replacement. Shrinking PVC shrink-wrap sheeting for packaging protection, polyvinyl wire joints and tubing. Waxing and/or dewaxing skis. IMPORTANT * Keep the air intake and outlet opening clean and free of dirt and debris. * Do not use gasoline, lacquer, turpentine or similar substances to clean the tool or work piece.