Resumen del contenido incluido en la página 1
www.furuno.co.jp
Resumen del contenido incluido en la página 2
**00016841411 00016841411** **00016841411 00016841411**
Resumen del contenido incluido en la página 3
IMPORTANT NOTICES The descriptions in this manual are intended for readers with a solid knowledge of English. No part of this manual may be copied or reproduced without written permission. If this manual is lost or worn, contact your dealer about replacement. The contents of this manual and equipment specifications are subject to change without notice. The example screens (or illustrations) shown in this manual may not match the screens you see on your display. The screen you see depends o
Resumen del contenido incluido en la página 4
SAFETY INSTRUCTIONS The operator and installer must read the applicable safety instructions before attempting to install or operate the equipment. Indicates a potentially hazardous situation which, if not avoided, WARNING could result in death or serious injury. Indicates a potentially hazardous situation which, if not avoided, CAUTION can result in minor or moderate injury. Warning, Caution Mandatory Action Prohibitive Action Safety instructions for the operator WARNING WARNING Do not o
Resumen del contenido incluido en la página 5
SAFETY INSTRUCTIONS Safety instructions for the installer CAUTION WARNING Observe the following compass safe ELECTRICAL SHOCK HAZARD distances to prevent interference to a Do not open the equipment unless totally familiar with electrical circuits magnetic compass: and service manual. Standard Steering Only qualified personnel should work compass compass inside the equipment. FA-50 0.30 m 0.30 m Turn off the power at the switchboard PR-240 0.90 m 0.60 m before beginning the in
Resumen del contenido incluido en la página 6
TABLE OF CONTENTS FOREWORD ....................................................................................................................v SYSTEM CONFIGURATIONS.......................................................................................vii 1. INSTALLATION .....................................................................................................1-1 1.1 Equipment List .......................................................................................................
Resumen del contenido incluido en la página 7
FOREWORD A Word to the Owner of the FA-50 Congratulations on your choice of the FURUNO FA-50 AIS Transponder. We are confident you will see why the FURUNO name has become synonymous with quality and reliability. For 60 years FURUNO Electric Company has enjoyed an enviable reputation for quality marine electronics equipment. This dedication to excellence is furthered by our extensive global network of agents and dealers. This equipment is designed and constructed to meet the rigorous demands o
Resumen del contenido incluido en la página 8
FOREWORD Interfaces for radar, PC for future networking expansion GPS/VHF combined antenna for easy installation available Built-in GPS receiver for position-fixing device Program Version Item Program No. Version No. Date FA-50 AIS Transponder 0550233 01.** July 2007 Main Program **: Minor change vi
Resumen del contenido incluido en la página 9
SYSTEM CONFIGURATIONS Either VHF GPS antenna antenna GPA-017S or 017 GPS/VHF combined antenna GVA-100-T Distributor DB-1 PC w/FAISPC MX HUB AIS TRANSPONDER FA-50 EXTERNAL NAVNET DISPLAY NAVNET RADAR EXTERNAL CHART PLOTTER DISPLAY ECDIS PILOT PLUG OR GPS* (ex. GP-150) SPEED LOG SENSOR GYROCOMPASS AC-DC POWER SATELLITE COMPASS SUPPLY PR-240 OR FR-8xx2 SERIES 12-24 VDC 24 VDC IF-1500AIS 100-115/ 200-230VAC 1φ, 50/60 Hz *Usaually FA-50 uses the internal GPS. When connecting the external GPS, use o
Resumen del contenido incluido en la página 10
SYSTEM CONFIGURATIONS This page is intentionally left blank. viii
Resumen del contenido incluido en la página 11
1. INSTALLATION 1.1 Equipment List Standard supply Name Type Code No. Qty Remarks AIS transponder FA-50 - 1 Antenna unit GVA-100 - 1 GPS/VHF combined GPA-017S - 1 set GPS antenna GPA-017 - 1 set GPS antenna w/10 m cable Distributor DB-1 - 1 For GVA-100 Spare parts SP05-05801 001-031-960 1 set 4A fuses (Type: FGMB 125V 4A, Code No.: 000-157-482-10) Accessories FP05-06110 000-166-648 1 set FAISPC-MX for PC Installation CP24-00502 005-955-560 1 set For GPA-017S materials CP05-11401 001-031-970 1
Resumen del contenido incluido en la página 12
1. INSTALLATION Optional supply Name Type Code No. Qty Remarks AC-DC power PR-240-CE - 1 supply Whip antenna CP05-11001 001-034-670 1 For outside Japan Antenna cable CP20-02700 004-381-160 1 For GPA-017S set CP20-02710 004-381-170 1 For GPA-017S CP24-00300 000-041-938 1 For GVA-100 CP24-00310 000-041-939 1 For GVA-100 Coaxial cable TNC-PS/PS-3D- 000-133-670-11 1 TNC-TNC, 15 m L15M-R Right-angle No.13-QA330 000-803-239 1 For GPA-017/S antenna base L-angle anten- No.13-QA310 000-803-240 1 For GPA
Resumen del contenido incluido en la página 13
1. INSTALLATION 1.2 AIS Transponder FA-50 Mounting considerations, mounting The FA-50 can be mounted on a desktop, deck or on a bulkhead. When selecting a mounting location, keep the following points in mind: • The temperature and humidity should be moderate and stable. • Locate the unit away from exhaust pipes and vents. • The mounting location should be well ventilated. • Mount the unit where shock and vibration are minimal. • Keep the unit away from electromagnetic field-generating equipmen
Resumen del contenido incluido en la página 14
1. INSTALLATION Other VHF whip antenna Whip antenna for AIS More than 2.8 m More than 10 m More than 0.5 m Horizontal separation distance Vertical separation distance Cabling • Use coaxial cable type 5D-2V or the equivalent. • The cable should be kept as short as possible to minimize signal attenuation, and the maximum length is 50 meters. • All outdoor-installed connectors on coaxial cables should be fitted with preventive isolation such as vulcanizing tape to protect against water pen
Resumen del contenido incluido en la página 15
1. INSTALLATION 1.4 GPS Antenna Install the GPS antenna unit referring to the outline drawing at the back of this manual. When selecting a mounting location for the antenna, keep in mind the following points. • Select a location out of the radar beam. The radar beam will obstruct or prevent re- ception of the GPS satellite signal. • There should be no interfering object within the line-of-sight to the satellites. Objects within line-of-sight to a satellite, for example, a mast, may block rece
Resumen del contenido incluido en la página 16
1. INSTALLATION How to attach the connector N-P-8DFB for cable 8D-FB-CV Outer Sheath Inner Sheath Shield Armor Remove outer sheath and armor by the dimensions shown left. Expose inner sheath and shield by the dimensions 30 50 shown left. Cover with heat-shrink tubing and heat. Cut off insulator and core by 10mm from its end. 30 10 Twist shield end. Washer 1 Slip on clamp nut, washer 1, gasket and clamp as shown left. If it is difficult to slip the clamp onto the cable
Resumen del contenido incluido en la página 17
1. INSTALLATION 1.5 GPS/VHF Combined Antenna Install the combined antenna unit referring to the outline drawing. When selecting a mounting location for the antenna, keep in mind the following points. • Select a location out of the radar beam. The radar beam will obstruct or prevent re- ception of the GPS satellite signal. • There should be no interfering object within the line-of-sight to the satellites. Objects within line-of-sight to a satellite, for example, a mast, may block reception or
Resumen del contenido incluido en la página 18
1. INSTALLATION Whip antenna fixture Loosen four screws. (M5x16) Antenna fixing bracket Combined box Bottom cover GPS/VHF combined antenna The top of the stanchion comes into contact with the flange. Stanchion Installing distributor DB-1 The length of the cable between the distributor and transponder is 1 m so locate the distributor within 1 m from the transponder. Fix the distributor on the bulkhead, facing the cable entrance downward. Remove the lid of the distributor and secure the distri
Resumen del contenido incluido en la página 19
1. INSTALLATION Self-tapping screw (4x30) Note: Be sure no foreign material or water enters the distributor. 1.6 AC-DC Power Supply (option) When selecting a mounting location for the unit, keep the following in mind: Keep the unit out away from areas subject to water splash. Locate the unit away from exhaust pipes and vents. The mounting location should be well ventilated. Mount the unit where shock and vibration are minimal. A magnetic compass will be affected if the unit is placed too c
Resumen del contenido incluido en la página 20
1. INSTALLATION 1.7 Wiring Connect power source, LAN cable, VHF antenna and ground wire as shown below. GPS/VHF Combined GPS Antenna Antenna GVA-100-T GPA-017/S 150M-W2VN Either one Distributor 0.8 m 0.6 m DB-1 RG-10U/Y (8D-FB-CV, option) Attached to Distributor RG-10U/Y, 50 m (approx. 1m) : Ground is not required. 8D-FB-CV, 30 m/50 m: Option RG-10U/Y, 20 m: Local supply AIS TRANSPONDER COM/POWER NETWORK VHF ANT 12-24 VDC GPS ANT 2.0-1.0 A LAN CABLE P5E-4PTX-BL GROUND WIRE PC, HUB, IV-1.25sq (2
