Manual de instrucciones de Casio DQR-200U

Resumen del contenido incluido en la página 1

UP (+)
UP (+)
°C/ °F
°C/ °F
MA0402-EB
Operation Guide DQR-200U
Main unit Sub-unit
1
AB C
4 378 2
°C/ °F RESET
5
TEMP.
WAVE DOWN
CLEAR
MAX/MIN (—)
SNZ
SNZ
ON
ON
OFF
OFF RESET
ALM
°C/ °F RESET
ALM
TEMP. DOWN
WAVE CLEAR
MAX/MIN (—)
RESET
960
• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the
clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
Alarm Off Alar

Resumen del contenido incluido en la página 2

Operation Guide DQR-200U GENERAL GUIDE TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS Main unit • This clock is able to receive the time calibration signal transmitted from Rugby, England. Signal reception is possible within approximately Rugby 1,000 kilometers 1SNOOZE/LIGHT button 1,000 km of the transmitter. • Press this button to illuminate the display for about four seconds. • Even when the clock is within the reception range, signal reception is • Pressing this button while the alarm is soun

Resumen del contenido incluido en la página 3

UP (+) UP (+) °C/ °F °C/ °F Operation Guide DQR-200U 2. While the screen you want is on the display, use the Alarm Time Set buttons (2) to change the digits that are USING THE CLOCK flashing. Any of the following procedures can be used to set current date and time. • Auto receive of the time calibration signal • Manual receive of the time calibration signal Press + to increase Press — to decrease TEMP. DOWN WAVE CLEAR • Manual setting without using the time calibration signal MAX/MIN (—) the fl

Resumen del contenido incluido en la página 4

Operation Guide DQR-200U THERMOMETER FUNCTIONS USING THE LIGHT Both the main unit and the sub-unit are equipped with their own temperature sensors. Temperature data measured Pressing the SNOOZE/LIGHT button (1) turns on the light and illuminates the display for easy reading in the by the sub-unit is sent by wireless transfer to the main unit. This makes it possible to view both the indoor and dark. outdoor temperature on the main unit display. Important! Temperature Measurements • Overuse of the

Resumen del contenido incluido en la página 5

Operation Guide DQR-200U USING THE SUB-UNIT MAIN UNIT/SUB UNIT COMMUNICATION PRECAUTIONS Data Transfer from the Sub-unit Sub Unit Location • Data is transferred from the sub-unit to the main unit every three minutes. • Certain environmental conditions can greatly reduce the communication range. • The sub-unit is able to send data to the main unit up to an unobstructed distance of about 30 meters. • Avoid the following locations for the sub-unit. • The data receive status is indicated on the disp