Resumen del contenido incluido en la página 1
PHOENIX HD SCOOTER
PHOENIXHD3 / PHOENIXHD4
OWNER’S MANUAL
1
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS 1. PREFACE AND INTRODUCTION ……..………………………………… 3 2. SAFETY NOTICE…………………………………………………………...…. 4 2.1 Before driving 2.2 While driving 2.3 Labeling 2.4 EMI 3. PARTS INTRODUCTION……………..……………….. ……………………. 9 4. OPERATION………………………………………………………………….... 10 4.1 Control panel 4.2 How to operate your scooter 4.3 How to set to freewheel mode 5. DRIVING ON THE ROAD…………………………………………………….. 15 6. BATTERY CHARGING AND CARE……………………………………..... 16 6.1 Charging th
Resumen del contenido incluido en la página 3
1. PREFACE AND INTRODUCTION Please carefully read this owner’s manual before using the vehicle. Improper use of the vehicle could result in harm, injury or traffic accidents. To ensure that you get the most your scooter, please read this owner’s manual before using. ♦ This owner’s manual includes operation instructions for every aspect of the vehicle, assembly instructions, as well as instructions for how to deal with possible accidents. ♦ The symbols used in this manual are explai
Resumen del contenido incluido en la página 4
2. SAFETY NOTICE 2.1 BEFORE DRIVING The user needs to be familiar with the usage and operation of this vehicle before driving. Therefore, please follow the commendations in this safety notice.
The same traffic rules apply to the use of this vehicle as apply to pedestrians ♦ For your safety, please follow and adhere to the same traffic laws as pedestrians. ♦ Please do not drive your scooter after consuming alcohol or when you are tired. ♦ Please be careful when driving your sco
Resumen del contenido incluido en la página 5
2. SAFETY NOTICE 2.2 WHILE DRIVING
Do not use your vehicle under the circumstances below. ♦ On surfaces that are muddy, gravelly, bumpy, narrow, snowed over, icy, or canal towpaths not guarded by any fence or hedge. Keep away from places where you might get the wheels stuck. ♦ Do not drive at night or when it is raining, snowing, misty, or windy. ♦ Do not drive your vehicle in an “S” pattern or make erratic turnings. ♦ Do not take the scooter onto escalators. ♦ UNDER NO CIRCUM
Resumen del contenido incluido en la página 6
2. SAFETY NOTICE 2.3 Labeling Please carefully read all the labeling on the scooter before drive it. For your future reminding, do not remove them. 6
Resumen del contenido incluido en la página 7
2. SAFETY NOTICE 2.4 EMI This portion of the content will provide the user with basic information that describes the problems with EMI, known sources of EMI, protective measures either to lessen the possibility or exposure or to minimize the degree of exposure, and suggested action should unexpected or erratic movement occur. Caution: It is very important that you read this information regarding the possible effects of electromagnetic interference on your electric SCOOTER.
E
Resumen del contenido incluido en la página 8
2. SAFETY NOTICE 3. Long-range transmitters and transceivers, such as commercial broadcast transmitter (radio and TV broadcast antenna towers) and amateur (HAM) radios. Note: Other types of hand-held devices, such as cordless phones, laptop computers, AM/FM radios, TV sets, CD player, and cassette players, and small appliances, such as electric shavers and hair dryers, so far as we know, are not likely to cause EMI problems to your powered scooter. PO
WERED VEHICLE ELECTROMAG
Resumen del contenido incluido en la página 9
3. PARTS INTRODUCTION PARTS DESCRIPTION 1. Control panel 5. Seat 9. Anti-tip wheels 2. Basket 6. Seat Rotation Lever 10. Seat Post Knob 3. Charger Socket 7. Battery Pack 11. Seat Height Adjustment 4. Tiller Adjustment Knob 8. Freewheel Lever Pin 9
Resumen del contenido incluido en la página 10
4. OPERATION 4.1 CONTROL PANEL 1. Speed Dial 2. Horn Button 3. Battery Indicator 4. Power Switch 5. Power Eye 4.2 HOW TO OPERATE YOUR SCOOTER Power switch ♦ To switch the power on , turn the key clockwise in the ignition. The power eye should illuminate. ♦ To switch the power off, turn the key anticlockwise. The power eye should switch off and the key can be removed if required. Speed Dial Turn the
Resumen del contenido incluido en la página 11
4. OPERATION N Warning When on a gradient NEVER set the vehicle to the freewheel mode. The electromagnetic brakes will not be applied. This may result in injury or damage.
Seat ♦ The seat can be rotated and locked in position at 45 degrees intervals. ♦ Push the seat adjustment lever forward and swivel the seat. ♦ Release the lever, and then continue swiveling the seat until it locks in position. F Attention Return the seat to the forward position before driving.
Resumen del contenido incluido en la página 12
4. OPERATION & Suggestion 1. You should recharge the batteries after each time the vehicle is used to ensure maximum range. The batteries should be charged up at least once a week even if the scooter is not used. 2. After charging or replacing a new battery, drive the vehicle for 2-3 minutes to make sure the battery capacity is sufficient. 3. In wintertime, the battery may respond more slowly and the battery range may be reduced. 4. When driving on a gradient, the battery ind
Resumen del contenido incluido en la página 13
4. OPERATION 4.3 How to set to freewheel mode Lever Lever Fig 4.1 Fig 4.2
Resumen del contenido incluido en la página 14
4. OPERATION
Tiller Adjustment The tiller can be adjusted in to many different positions to suit each driver. 1. Loosen the knob to adjust the tiller to positions you want. (Fig. 4
Resumen del contenido incluido en la página 15
5. DRIVING ON THE ROAD
Starting and Driving 1. Make sure the seat is installed properly. 2. Make sure the tiller has been secured properly. 3. Fold down the armrests so you can rest your arms on them. 4. Turn the power switch to “ON”. 5. Check battery indicator to see whether there is enough power for your journey. If you have any doubt about the remaining power, please recharge the batteries before departure. 6. Set the speed dial to a position you feel safe and comforta
Resumen del contenido incluido en la página 16
6. BATTERY CHARGING AND CARE 6.1 CHARGING THE BATTERY
Method 1: On board Charging (see photograph overleaf) Follow the procedure below step by step: 1. Turn the power switch to (OFF) 2. Plug the charger’s power cord into the mains. 3. Open the charging socket cap on the rear shroud. Then connect the charger’s round plug to the charging socket. Charger socket 4. Switch on the charger. 5. Both the charger’s red and orange LED will be lit when 6. Beginning charging. The
Resumen del contenido incluido en la página 17
6. BATTERY CHARGING AND CARE
Charging Hours The charging duration is about 6 hours. To ensure optimum performance a 10-hour charge is recommended. But we do not recommend a charging more than 24 consecutive hours.
Batteries (Inside the Pack) 1. The PHOENIX HD 3/PHOENIX HD 4 is powered by two sealed lead-acid deep-cycle batteries. 2. The batteries supplied with the scooter are 12 V 20ah batteries. N Warning Keep away from flammable objects while charging as it
Resumen del contenido incluido en la página 18
6. BATTERY CHARGING AND CARE ♦ The batteries carry a eight-month of manufacturer's warranty. This warranty only covers issues relating to manufacturing faults, and not faults relating to failure to recharge the batteries as instructed above. & Suggestion – How to maximize your batteries efficiency and service life 1. Fully recharge your new battery before its first time use. 2. Be sure to charge the battery fully every time. The battery life will be seriously shortened or decayed if
Resumen del contenido incluido en la página 19
6. BATTERY CHARGING AND CARE N Warning 1. The wiring system and charger are well situated in the battery pack while being assembled in plant. Do not attempt to re-locate the wiring system by yourself. The improper layout of wiring system may result in the wires pinched by battery box, which might result in the electronic system failure. 2. Be sure the battery wires are connected to their right battery terminal. & Suggestions If necessary, ask for he
Resumen del contenido incluido en la página 20
7. INSPECTION AND MAINTENANCE 7.1 INSPECTION • Clean the scooter with a damp cloth and dust down approximately once a week to preserve the appearance of the scooter. • Adjust the tiller height and return to the original position and swivel the seat once a week to ensure the parts adjust and remove smoothly and easily when required. • Check for signs of wear and tear on the tires and the upholstery on a regular basis. • For optimum performance and to increase the lifespan of your scoot
