Resumen del contenido incluido en la página 1
In to the expe_
Owner's Manual
NOTE TO INSTALLER:
THIS MANUAL MUST BE LEFT WITH
THE EQUIPMENT USER.
FIRE OR EXPLOSION HAZARD
Failure to follow safety warnings could result in iniury, death,
or property damage.
USER: Please read all instructions in the manual and retain
all manuals for future reference.
Do not store or use gasoline or other flammable vapors and
liquids in the vicinity of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
-Do not try to light any appliance.
-Do not touch any
Resumen del contenido incluido en la página 2
WELCOME TO TODAY'S GENERATION FURNACE COMPONENTS OF COMFORT (Furnace shown in upflow position; may be used in downflow or horizontal orientation or applications. Vent Elbow may be turned Congratulations! Your new, higher efficiency gas furnace is a to a different position, depending on type of installation) sound investment which will reward you and your fanfily with years of warm memories winter after winter. INDUCER MOTOR ASSEMBLY Not only is your new furnace energy efficient, it is also extre
Resumen del contenido incluido en la página 3
IMPORTANT FACTS (DO'S AND DON'TS) • DO: READ AND UNDERSTAND THIS MANUAL • DO: Have your furnace and vent system inspected annually by a FIRE OR EXPLOSION HAZARD qualified service technician. Failure to follow safety warnings could result in personal • DO: Inspect your filter monthly and clean or replace when iniury, death, or property damage. needed. Keep insulation clear of furnace and maintain clearances • DO: Provide adequate airflow to the furnace for efficient shown on unit clearance label.
Resumen del contenido incluido en la página 4
2. Close the external manual gas valve. STARTING YOUR FURNACE Your furnace uses an automatic, hot surface ignition system to light the burners each time the thermostat signals the furnace to start. F* -....1 Follow these important safeguards: • Never attempt to manually light the burners with a match or other source of flame. A06188 Fig. 8 - Close Valve 3. Turn OFF electrical supply to the furnace. ........ Y A92319 Fig. 3 - Do Not Light Burner with Match • Read and follow the operating instruct
Resumen del contenido incluido en la página 5
/ 12. After about 17 seconds, the gas valve permits gas to flow to the main burners where it is ignited. Hot flames begin to warm the furnace's heat exchanger. After a time delay of approxim- ately 25-45 seconds the furnace blower is switched on. OR NOTE: If the main burners fail to ignite, the furnace control system will go through three more ignition cycles. Then if burners fail to ignite, the system will lockout. If lockout occurs or the blower does not come on, shut down your furnace and cal
Resumen del contenido incluido en la página 6
PERFORMING ROUTINE MAINTENANCE With proper maintenance and care, your furnace will operate econonfically and dependably. Instructions for basic maintenance are found on this and the following pages. However, before beginning maintenance, follow these safety precautions: ELECTRICALSHOCK HAZARD Failure to follow this warning could result in personal A92185 injury or death. Fig. 13 - Turn Off Electrical Supply Turn off electrical power supply to your furnace before 2. Remove filter cabinet door (Se
Resumen del contenido incluido en la página 7
A00227 A06192 Fig. 16 - Slide Side Filter Out of Furnace Fig. 18 - Replace Side Filter Cabinet Door A00228 A06193 Fig. 17 - Slide Bottom Filter Out of Furnace Fig. 19 - Replace Bottom Filter Cabinet Door 4. Inspect the filter. If torn, replace it. NOTE: If side return ducts are used, 2 filters may be required in some models. The procedure listed above may be used to remove NOTE: If a washable filter has been replaced with: side filters. a. Factory specified disposable media filter -- Do not clea
Resumen del contenido incluido en la página 8
If rusty joints or seams, or signs of water leakages are COMBUSTION AREA AND VENT SYSTEM found, call your dealer for service. 4. Restore electrical power to the furnace. (See Fig. 11.) 5. Start the furnace and observe its operation. If possible, watch the burner flames. Are they burning bright blue? If UNIT OPERATION HAZARD not or if you suspect some other malfunction, call your ser- Failure to follow this warning could result in personal iniury vicing dealer. or death. 6. Replace the access doo
Resumen del contenido incluido en la página 9
Inaddition tothetype ofroutine maintenance youmight bewilling toperform, your furnace should beinspected regularly byaproperly trained service technician, You should workwithyour dealer orservice technician toassure your inspection includes thefollowing ata minimum, MAINTENANCE CHECKLIST Furnace specific, external items: Clean or replace air filters. X Inspect cabinet for signs of damage. X Inspect and clean door louvers if needed. X Inspect electrical disconnect for proper function. Repair or r
Resumen del contenido incluido en la página 10
NOTE TO EQUIPMENT OWNER: For your convenience, please record the model and serial numbers of your new equipment in the spaces provided. This information, along with the installation data and dealer contact information will be helpful should your system require maintenance or service. FURNACE INSTALLATION INFORMATION: Model # Date Installed Serial # DEALERSHIP CONTACT INFORMATION: AIR CONDITIONER OR HEAT PUMP Company Name Model # Address Serial # Phone Number INDOOR COIL (Furnace Coil or Fan Coil
