Manual de instrucciones de American Standard Rondo 7242.XXXW

Resumen del contenido incluido en la página 1

7242.XXXW
RONDO™
HIGH GLOSS ACRYLIC
SERIES WHIRLPOOL
SHOWN LESS ALL FITTINGS
INSTALLATION INSTRUCTIONS
1816mm
(71-1/2)

RECOMMENDED FITTING
165mm 908mm
LOCATION 64 X 279mm
(6-1/2) (35-3/4)
(2-1/2 X 11)
THANK YOU...
76mm
(3) C/L OF DRAIN
for selecting an American Standard bath. Your new
267mm
bath is shipped to you after careful inspection. The
(10-1/2)
whirlpool version is completely assembled with pump,
229 X 305mm
motor, and system piping. All you need to finish the
(9 X 12)
CUTOUT
inst

Resumen del contenido incluido en la página 2

INSTALLATION AND FRAMING INSTRUCTIONS The variety of installations possible for this whirlpool may require framing procedures other than those shown. Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Provisions must be made in all installations for an access opening for servicing the pump and controls. It is strongly recommended that an additional opening be provided for access to the drain components. 1. Position the whirlpool into the installation ope

Resumen del contenido incluido en la página 3

ELECTRICAL INSTALLATION INSTRUCTIONS All wiring must be performed by a licensed electrician in accordance with the national electrical code and all other applicable codes. WARNING: When using electrical products, basic precautions should always be observed, including the following: 1. DANGER: RISK OF ELECTRIC SHOCK Connect only to a circuit protected by a ground-fault circuit interrupter. 2. Grounding is required. The unit should be installed by a licensed electrician and grounded. 3. Install

Resumen del contenido incluido en la página 4

WIRE SELECTION GUIDE Maximum distance from The sizes shown on this fusebox to motor chart are recommendations Motor 50' 100' 150' 200' for copper conductors Hi Performance only. Always follow Rating 120V Power Line local and national electrical codes 2.1 12 10 8 8 DRAIN CONNECTION AND SYSTEM TEST Using recommended drain opening, connect whirlpool drain to waste line. Tighten all drain joints securely. Check the pump couplings and make sure they are hand-tight. Clean the whirlpool and fill