Resumen del contenido incluido en la página 1
l
l
l
l
l
l
l
l
l
l
l
l
l
MO0909-EA
Operation Guide 3135 3206
Getting Acquainted
• The watch continues to operate, even when it is not exposed to light.
Congratulations upon your selection of this CASIO watch. To get the most out
Leaving the watch in the dark can cause the battery to run down, which will
of your purchase, be sure to read this manual carefully.
result in some watch functions being disabled. If the battery goes dead, you
will have to re-configure watch settings after rec
Resumen del contenido incluido en la página 2
SE l l l ESE l l E l l ENE l NE l NNE l l N l l NNW l l l Operation Guide 3135 3206 Timekeeping To change the Daylight Saving Time (summer time) setting Use the Timekeeping Mode to set and view the current time and date. • In the Timekeeping Mode, an indicator moves along the ring around the 1. In the Timekeeping Mode, hold down E until DST indicator display as seconds advance. the city code starts to flash, which indicates • The tide graph shows tidal movements for the current date in accorda
Resumen del contenido incluido en la página 3
l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l Operation Guide 3135 3206 • Any ongoing direction measurement operation is paused temporarily while To perform magnetic declination correction the watch is performing an alert operation (daily alarm, Hourly Time Signal, 1. In the Digital Compass Mode, hold down E countdown timer alarm) or while illumination is turned on (by pressing L). for about two seconds until the magnetic Magnetic declination The measurement operation resumes for
Resumen del contenido incluido en la página 4
Operation Guide 3135 3206 Using the Digital Compass While Mountain Climbing or 3. In the Timekeeping, Digital Compass, 12 o’clock Barometer/Thermometer, or Altimeter Mode, Hiking position press C to take a compass reading. This section describes three real-life situations where you could use the • The compass reading information (angle watch’s built-in digital compass. value, direction indicator, and four pointers • To set a map and find your current location based on the 12 o’clock position of
Resumen del contenido incluido en la página 5
l l l l l l l l Operation Guide 3135 3206 Note that if there are sudden changes in barometric When you measure altitude using a reference altitude specified by you pressure or temperature, the graph line of past After you specify a reference altitude, the watch uses that value to convert the measurements may run off the top or bottom of the display. current measured barometric pressure value to altitude. The entire graph will become visible once barometric • When mountain climbing, you can set t
Resumen del contenido incluido en la página 6
l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l Operation Guide 3135 3206 Tide/Moon Data Specifying a Reference Altitude In the Tide/Moon Data Mode, you can see the current tide and the current After you specify a reference altitude, the watch adjusts its air-pressure-to- date’s Moon phase for your Home City. You can specify a date and view tide altitude conversion calculation accordingly. The altitude measurements and Moon data for that date. produced by this watch are s
Resumen del contenido incluido en la página 7
l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l Operation Guide 3135 3206 2. While the Moon information (Moon age and Countdown End Beeper Hour phase) and tide information (current tide level The watch beeps each second of the final 10 seconds before a countdown and tide range) are displayed, hold down E reaches zero, and at zero. The first five beeps (seconds 10 through 6) are u
Resumen del contenido incluido en la página 8
l l l l l l Operation Guide 3135 3206 Stopwatch To set an alarm time Hours The stopwatch lets you measure elapsed time, Alarm on 1. In the Alarm Mode, use A and C to scroll split times, and two finishes. 1/100 second indicator through the alarm screens until the one whose • The display range of the stopwatch is 23 hours, time you want to set is displayed. 59 minutes, 59.99 seconds. A • The stopwatch continues to run, restarting from zero after it reaches its limit, until you stop it. AL1 AL2 AL3
Resumen del contenido incluido en la página 9
Operation Guide 3135 3206 Warning! There are two standard methods of expressing altitude: Absolute altitude and • Always make sure you are in a safe place whenever you are reading relative altitude. Absolute altitude expresses an absolute height above sea the display of the watch using the auto light switch. Be especially level. Relative altitude expresses the difference between the height of two careful when running or engaged in any other activity that can result different places. in accident
Resumen del contenido incluido en la página 10
l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l l Operation Guide 3135 3206 Battery Power Indicators Recovery Times The table below shows the amount exposure that is required to take the The battery power indicator on the display shows you the current status of the battery from one level to the next. rechargeable battery’s power. Approximate Exposure Time Exposure Level Level Battery Power Function Status (Brightness) Level 5 Level 4 Level 3 Level 2 Level 1 Indicato
Resumen del contenido incluido en la página 11
l l l l l l l l l l l l l l l l l l Operation Guide 3135 3206 Tide Graph Button Operation Tone The Tide Graph graphically represents the current tide condition using one of The button operation tone sounds any time you Mute indicator three patterns that represent spring tide, intermediate tide, and neap tide, as press one of the watch’s buttons. You can turn the shown below. button operation tone on or off as desired. • Even if you turn off the button operation tone, Tide Name Graph Description
Resumen del contenido incluido en la página 12
l l l l l l l l l l l l l l l l l l l l l l l l l l l Operation Guide 3135 3206 • The letters “UTC” is the abbreviation for “Universal Time Coordinated”, To calibrate the pressure sensor and the temperature sensor which is the world-wide scientific standard of timekeeping. It is based upon 1. Press B to enter the Barometer/ carefully maintained atomic (cesium) clocks that keep time accurately to Thermometer Mode. within microseconds. Leap seconds are added or subtracted as necessary 2. In the Ba
Resumen del contenido incluido en la página 13
Operation Guide 3135 3206 City Code Table Bearing Sensor Precision: City UTC Offset/ City UTC Offset/ Direction: Within ±10° City City Code GMT Differential Code GMT Differential Values are guaranteed for a temperature range of –10°C to 40°C (14°F PPG Pago Pago –11 JED Jeddah +3 to 104°F). HNL Honolulu –10 THR Tehran +3.5 North pointer: Within ±2 digital segments ANC Anchorage –9 DXB Dubai +4 LAX Los Angeles –8 KBL Kabul +4.5 Pressure Sensor Precision: DEN Denver –7 KHI Karachi +5 CHI Chicago –6
