Manual de instrucciones de Closet Maid 2894

Resumen del contenido incluido en la página 1

#2894
4' (1,22 m)
4' Pantry Organizer
Installation Instructions
Organizador de Despensa de 1,22 m
Instrucciones de Instalación
Before You Begin
1. Remove product from packaging and carefully inspect all
parts. (See Parts List below.)
2. Please read all instructions carefully before beginning.
Antes de empezar
1. Remueva el producto del paquete y cuidadosamente
inspeccione todas las partes. (Vea la lista de partes
abajo).
2. Haga el favor de leer todas las instrucciones
cuidadosamente antes de e

Resumen del contenido incluido en la página 2

Tools and Materials Herramientas y materiales 1/4" (6 mm) Measure and Fit 1 NOTE: This oganizer requires a minimum wall area or pantry width of 4'. It can also easily be installed on a wall area or a pantry wider than 4'. However, in the case of a wall area or pantry which is smaller than 4', the Hang Track and/or the Shelves will require cutting. CAUTION: To avoid personal injury, use care and a safe, sturdy stepping stool to position Hang Track. 1. Measure wall area or pantry width. (NOTE:

Resumen del contenido incluido en la página 3

Install Hang Track DRYWALL MURO SECO To install Hang Track into drywall: IMPORTANT: For 1. Drill 1/2" holes at marked locations on wall. optimum performance, 2. Remove toggle from bolt. Insert bolt through hole in Hang Track and re-install toggle onto end of bolt. align holes 1, 3, and 5 3. Place Hang Track against wall at hole locations. Squeeze (counting from either toggle bolts and push through drilled hole. Tighten bolt to end) with studs. If holes secure Hang Track to wall. 1, 3, and 5 ar

Resumen del contenido incluido en la página 4

Install Shelves 1 2 1. If your wall area or pantry width is less than 4' wide, it requires cutting the Shelves. If you wish your organizer to match the drawings in this manual, one of the 4' shelves will need to be cut to 24". Note: There are four 4' Shelves supplied. If necessary, cut Shelf/Shelves with a hacksaw or boltcutter in one inch increments. When installing flush against a sidewall, we recommend cutting Shelf from end that will be closest to side wall. 3 2. Place Shelf endcaps onto