Resumen del contenido incluido en la página 1
COMPACT LP.& NATURAL
GAS VENT-FREE STOVE
’
OWNER S OPERATION AND INSTALLATION MANUAL
Do not store, or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas
Resumen del contenido incluido en la página 2
SAFETY INFORMATION WARNINGS 5. Do not use this heater as a IMPORTANT: Read this WARNING: Do not use acces- wood-burning heater. Use only owner’s manual carefully and sories not approved for use with the logs provided with the heater. completely before trying to this heater. 6. Do not add extra logs or ornaments assemble, operate, or service such as pine cones, vermiculite, or this heater. Improper use of Due to high temperatures, the rock wool. Using th
Resumen del contenido incluido en la página 3
LOCAL CODES UNPACKING SAFETY INFORMATION 1. Remove top inner pack. lnstall and use heater with care. Continued 2. Tilt carton so that fireplace is Follow all local codes. In the upright. absence of local codes, use the 15. Turn off and unplug heater and 3. Remove protective side packaging. latest edition of The National Fuel let cool before servicing. Only a 4. Slide fireplace out of carton. Gas Code. ANSZ223.1, also known qualified service person should 5. Remove protectiv
Resumen del contenido incluido en la página 4
AIR FOR COMBUSTION AND VENTILATION Confined and Unconfined Space Unusually Tight Construction WARNING: This heater shall not be installed in a confined The National Fuel Gas Code, ANS The air that leaks around doors space or unusually tight construc- Z223.1 defines a confined space as and windows may provide enough tion unless provisions are provided a space whose volume is less fresh air for combustion and for adequate combustion and ven- than 50 cubic
Resumen del contenido incluido en la página 5
3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas water heater 30,000 Btu/Hr Gas furnace Btu/Hr Vent-free heater + 26,000 Btu/Hr Vented gas heater Btu/Hr
Resumen del contenido incluido en la página 6
INSTALLATION NOTICE: This heater is in- tended for use as supplemental heat. Use this heater along with your primary heating system. Do not install this heater as your primary heat source. If you have a central heating system, you may run system's circulating blower while using heater. This will help circulate the heat throughout the house . In the event of a power outage, you can use this heater as your primary heat so
Resumen del contenido incluido en la página 7
INSTALLATION Continued CONNECTING TO GAS SUPPLY The installer must supply an external IMPORTANT: Install equipment shutoff regulator. The external regulator will re- valve in an accessible location. The equip- WARNING: A qualified service duce incoming gas pressure. You must ment shutoff valve is for turning on or person must connect heater to gas reduce incoming gas pressure to between shutting off the gas to the appliance. supply. Fo
Resumen del contenido incluido en la página 8
INSTALLATION Continued CHECKING GAS CONNECTIONS WARNING: Never use an WARNING: Test all gas piping CAUTION: Make sure external open flame to check for a leak. and connections for leaks after install- regulator has been installed between Apply a mixture of liquid soap and ing or servicing. Correct all leaks at natural gas supply and heater. See water to all joints. Bubbles forming once. guidelines under Connecting to Gas show a leak. Co
Resumen del contenido incluido en la página 9
INSTALLATION Continued INSTALLING LOGS D. Do not use this appliance if any part has WARNING: Failure to position been under water. Immediately call a the parts in accordance with these qualified service technician to inspect the diagrams may result in property dam- appliance and to replace any part of the age or personal injury. control system and any gas control which has been under water. CAUTION: After installation Figure 11 -Control Knob and and perio
Resumen del contenido incluido en la página 10
OPERATING HEATER Continued THERMOSTAT CONTROL OPERATION The thermostat control knob can be set to any comfort level between HI and LO. The thermostat will gradually modulate the heat output and flame height from higher to lower settings, or pilot, in order to maintain the comfort level you select. The ideal comfort setting will vary by household depending upon the amount of space to be heated, the output of the central heating system, etc. Note: Select
Resumen del contenido incluido en la página 11
CLEANING AND MAINTENANCE CLEANING AND MAINTENANCE Clean the pilot assembly also. A yellow tip on the pilot flame WARNING: Turn off heater and indicates dust and dirt in the pilot let cool before cleaning. assembly. There is a small pilot air inlet hole about two inches from CAUTION: You must keep control where the pilot flame comes out of the pilot assembly (see Figure 18). areas, burner, and circulating air pas- With the unit off, lightly blow air sageways of heater clean. Inspect the
Resumen del contenido incluido en la página 12
TROUBLESHOOTING WARNING: Turn off heater and CAUTION: Never use a wire, Note: All troubleshooting items let cool before servicing. Only a needle, or similar object to clean are listed in order of operation. qualified service person should ODS/pilot. This can damage ODS/ service and repair heater. pilot unit. REMEDY OBSERVED PROBLEM POSSIBLE CAUSE 1. Turn on gas supply or open 1. Gas supply turned off or equip- When ignitor button is pressed,
Resumen del contenido incluido en la página 13
TROUBLESHOOTING Continued OBSERVED PROBLEM POSSIBLE CAUSE REMEDY Delayed ignition burner. 1. Manifold pressure is too low. 1. Contact local gas company. 2. Burner orifice is clogged. 2. Clean burner (see Cleaning and Maintenance, pages 11). 1. Damaged burner. 1. Clean burner orifice (see Cleaning Burner backfiring during combustion. 2. Gas regulator is defective. and Maintenance, page 11). 2. Replace gas regulator. Slight smoke or odor
Resumen del contenido incluido en la página 14
REPLACEMENT PARTS ACCESSORIES REPLACEMENT PARTS Purchase these heater accessories Note: Use only original replacement from your local dealer or Parts parts. This will protect your warranty Central. This part is not currently coverage for parts replaced under available from PRO-COM. warranty. PARTS UNDER WARRANTY Contact authorized dealers of this product. If they can't supply original replacement part(s) call the number on the back of manual. when contacting your dealer or PRO-COM, have
Resumen del contenido incluido en la página 15
1. Install legs and flex tube. Lay the heater down on its back and remove the regulator dustproof sticker and assemble the gas line into the inlet hole on the regulator. 2. Install the decorating logs. Figure 1 Fasten decorating logs 1¡¢ ¡¢ ¡¢2¡¢ ¡¢ ¡¢3 onto the correspondent angle iron (Figure 3). ¡¢ ¡¢¡¢ ¡¢ Figure 2 Figure 3 Insert the pinhole on the upper part of log 4 into the pin on the left side of log 1. Place the lower part on the flat roof at the left side of log 3 (Figure 4)
Resumen del contenido incluido en la página 16
ILLUSTRATED PARTS BREAKDOWN SN250TYLA-D SL250TYLA-D 16
Resumen del contenido incluido en la página 17
This list contains replaceable parts used in your heater. When PARTS LIST ordering parts, follow the instructions listed under Replacement SN250TYLA-D Parts on page 14 of this manual. SL250TYLA-D QTY K E Y PA RT D E S C RIP TION NO NUMB E R SD N250TYLA -D S L250TYLA - 00 1Ey B 3300D1 ecorati ng Logs A ssembl 1 04 2N) D 1703*400*O1 D S 3010(NG 04 3N) D 1808*400* OD S 3010(LP 1 0Z 46t 170-5M2 5 Nu 2 03 5N) B Y25-020EB1 urner(NG 03 6N) B Y25-120E B urner(LP 1 01 7E) L024-0I1 njec
Resumen del contenido incluido en la página 18
ILLUSTRATED PARTS BREAKDOWN SN250TYLA-D SL250TYLA-D 20 18
Resumen del contenido incluido en la página 19
PARTS LIST SN250TYLA-D SL250TYLA-D QTY PART KEY NO DESCRIPTION NUMBER SD N250TYLA-D SL250TYLA- 10Ey B3300D1 ecorating Logs Assembl 1 21Vl L028-0T1 op Pane 1 34Se L036-0D1 ecorating Fram 1 4BEl L019-01F1 an Fasten Pane 1 54Sl L031-0B1 ack Pane 1 66Et L004-0R1 egulator Bracke 1 74Sn L001-0R1 ight Colum 1 81Ee L011-0U1 pper Decorating Wir 1 94Sr L002(03)-0U2 pper (Mid) Louve 2 16 0Er L006-0S2 ide Reflecto 2 11 1Ey L007-0F1 irebox Floor Assembl 1 16 2El L012-0L1 ower Front Pane 1 11 3Er L013-0D1 o
Resumen del contenido incluido en la página 20
INSTALLING BLOWER ACCESSORY BLOWER ACCESSORY MODEL NFHTX186 backward so as to expose the three ACCESSORY MODEL 10. Plug power cord into a convenient 3- black, green, white lines on the four prong grounded wall receptacle near NFHTX186 strand cable at the back of rear panel. the heater. Be sure not to drop the temperature Tools required: Philips screwdriver controlled wire off the reflective panel. NOTICE: Shut off gas heater WARNING: 1. ELECTRICAL GROUND- Connect the green grounding means d
