Resumen del contenido incluido en la página 1
SHERWOOD INDUSTRIES IS AN ENVIRONMENTALLY RESPONSIBLE COMPANY. THIS MANUAL IS PRINTED ON RECYCLED PAPER.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
PELLET STOVE
Ome ga
OWNER’S MANUAL
PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION
AND USE OF THIS PELLET-BURNING ROOM HEATER. FAILURE
TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
Contact your building or fire officials about restrictions and installation
inspection requirements in your ar
Resumen del contenido incluido en la página 2
Table of Contents Introduction........................................................................................3 Rating Label Location................................................................3 Fuel Quality...............................................................................3 Safety Warnings & Recommendations....................................................4 Operating Instructions..........................................................................6 Dimensions & Sp
Resumen del contenido incluido en la página 3
Introduction * This manual is designed for the home owner in conjunction with the technical manual. * RATING LABEL LOCATION: The rating label is located on the inside of the hopper. FUEL QUALITY: Fuel quality is important, please read the following: Your Enviro pellet stove has been designed to burn 1⁄4” (6mm) dia wood pellets and other organic fuels. DO NOT use this appliance as an incinerator. DO NOT use unsuitable and non recommended fuels, including liquid fuels as this will void any warra
Resumen del contenido incluido en la página 4
Safety Warnings & Recommendations Please read this entire Owner’s Manual before installing or operating your Enviro Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Any unauthorized modification of the appliance or use of replacement parts not recommended by the manufacturer is prohibited. All national and local regulations and shall be complied with when operating this appliance. Caution: Do not connect to any air distribution du
Resumen del contenido incluido en la página 5
Safety Warnings & Recommendations ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 110-120 volts (4.2 Amps), 60 hertz electrical outlet and also must be accessible. If this power cord should become damaged, a replacement power cord must be purchased from the manufacturer or a qualified Enviro dealer. Be careful that the electrical cord is not trapped under the appliance and that it is
Resumen del contenido incluido en la página 6
Operating Instructions DIMENSIONS & SPECIFICATIONS: 13 2 1 / 1 6 " ( 55 4m m ) 15 1 5 / 16 " ( 4 04 m m ) 1 22 / 1 6 " ( 5 6 1 m m ) 3 2 6 / 8 " ( 6 6 9m m ) 3 2 4 / 1 6 " (6 1 5 m m ) 1 2 6 / 8 " ( 6 6 4m m ) 15 4 1 / 16 " ( 1 06 5m m ) 1 42 / 2 " ( 10 80m m ) 13 2 3 / 1 6 " ( 6 0 5 m m ) Figure 1: Dimensions of Omega. Table 1: Omega Specifications. Description Fuel type Residential Pellet Heater 6mm (1⁄4”) dia. Pellets - wood, corn, wheat, barley, & grass only* Voltage Current Max Power 110 -
Resumen del contenido incluido en la página 7
Operating Instructions CONTROL BOARD FUNCTIONS: 1. ON/OFF BUTTON: Used to turn the unit ON and OFF manually. 2. FUEL TYPE BUTTON: Used to switch between fuel type modes; Pellet (for all qualities of wood pellets) and Multifuel (for all fuels including wood pellets). When set on Multifuel it will run at a reduced High Feed Rate with wood pellets. NOTE: Fuel Type can only be chnaged when the unit is cold. P E L L E T P E L L E T 4 3. THERMOSTAT SWITCH: Sets the unit’s control mode; AUTO/OFF o
Resumen del contenido incluido en la página 8
Operating Instructions PRE-BURN CHECK: The burn pot liner holes must be clear and the liner installed properly against the ignitor tube and locked in place. Check the hopper for enough pellets to start the unit. Note: Fuel Type can only be changed when the unit is cold. The thermostat mode can be changed during normal operation. The unit has an automatic cleaning cycle; every thirty (30) minutes the agitator will turn continuously for P E L L E T P E L L E T 4 one (1) minute to help clean
Resumen del contenido incluido en la página 9
Operating Instructions TURNING YOUR PELLET STOVE OFF: • MANUAL and HI / LOW mode: To turn the unit OFF, simply press the ON / OFF button. This will stop the feed of pellets. The blowers will continue to operate and cool the stove down. When cool enough, the stove will turn off. • AUTO / OFF mode: To turn the unit OFF, turn the Thermostat down or Timer off. • Οn shut-down the burn pot agitator will run continualy for two (2) minutes when on Pellet Fuel Type and fifteen (15) minutes when on M
Resumen del contenido incluido en la página 10
Routine Cleaning and Maintenance The following list of components should be inspected and maintained routinely to ensure that the appliance is operating at its optimum and giving you excellent heat value. The appliance, flue gas connector and the chimney flue require regular cleaning. Check them for blockage prior to re-lighting after a prolonged shut down period. Check the Burn Pot Liner DAILY Weekly Bi-annually or 2 Tons of Fuel Burn Pot and Liner - Empty Exhaust Vent TOOLS REQUIRED TO CLEA
Resumen del contenido incluido en la página 11
Routine Cleaning and Maintenance HEAT EXCHANGER TUBES (Weekly) There are two (2) sets of exchanger tube scrapers; the handles are located under the top grill (trivet). Lift the grill and move the handles all the way up and down a few times (ONLY WHEN THE UNIT IS COLD) in order to clean away any fly ash that may have collected on the heat exchanger tubes. As different types of pellets produce different amounts of ash, cleaning of the tubes should be done on a regular basis to enable the un
Resumen del contenido incluido en la página 12
Routine Cleaning and Maintenance EXHAUST PASSAGES (Biannually) 1. Open the firebox door by lifting the handle. 2. Remove the burn pot assembly and clean all the parts. 3. Lubricate all screws with penetrating oil. 4. Using a 3⁄8” socket, remove the two F ir e b o x L i n e r (2) bolts that hold the firebox liner in place. Vacuum the firebox and firebox liner thoroughly. 5. Open the ash box door; remove the ash box and cleanout the cavity. 6. Clean out the transition box to the combustion
Resumen del contenido incluido en la página 13
Warranty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest level of quality and customer service is the most important thing we do. Each Enviro stove is built on a tradition of using only the finest materials and is backed by our Exclusive Lifetime Limited Warranty to the original purchaser. With Enviro, you’re not just buying a stove, you’re buying a company with years of unequalled performance and qual
Resumen del contenido incluido en la página 14
Warranty Exclusions and Limitations: 1. This Warranty does not cover tarnish, discoloration or wear on the plating or paint. 2. This Warranty excludes wear and tear or breakage caused by cleaning, moving or service on log set. 3. A qualified installer must install this stove or fireplace. This Limited Warranty covers defects in materials and workmanship only if the product has been installed in accordance with local building and fire codes; in their absence, refer to the owner’s manual. If t
Resumen del contenido incluido en la página 15
Warranty 17. Damage to plated surfaces caused by fingerprints, scratches, melted items, or other external scores and residues left on the plated surfaces from the use of abrasive cleaners or polishes is not covered in this warranty. 18. The Limited Warranty does not cover tarnish, discoloration or wear on the plated surfaces. 19. The paint on the Metal Brick Liner may peel. This is due to the extreme conditions applied to the paint during normal usage. It is not a flaw and is not covered und
Resumen del contenido incluido en la página 16
Installation Data Sheet The following information must be recorded by the installer for warranty purposes and future reference. NAME OF OWNER: NAME OF DEALER: _________________________________________ _________________________________________ ADDRESS: ADDRESS: _________________________________________ _________________________________________ _________________________________________ _________________________________________ _________________________________________ _____________________________
