Resumen del contenido incluido en la página 1
HOMEOWNER'S CARE AND
OPERATION INSTRUCTIONS
®
DIRECT VENT MERIT
RETAIN THESE INSTRUCTIONS
LMDV-33/35/40 SERIES
FOR FUTURE REFERENCE
DIRECT-VENT GAS FIREPLACE HEATERS
WARNINGS
P/N 875,028M REV. D 05/2006
• Hot! Do not touch! The glass and
surfaces of this appliance will be hot
MODELS
during operation and will retain heat
for a while after shutting off the appli-
Millivolt Models Electronic Models
ance. Severe burns may result.
LMDVT-3328CNM LMDV-3530CNM
LMDVT-3328CNE
• Carefully sup
Resumen del contenido incluido en la página 2
SAFETY & WARNIING WARNING WARNING INFORMATION Children and adults should be Do not use these appliances if any part has been under water. alerted to the hazards of high IMPORTANT: PLEASE READ THIS Immediately call a qualifi ed, surface temperatures. Use MANUAL IN ITS ENTIRETY AND professional service technician caution around the appliance UNDERSTAND THESE RULES TO to inspect the appliances and to to avoid burns or clothing igni- FOLLOW FOR SAFETY. replace any parts of
Resumen del contenido incluido en la página 3
These appliances are designed to operate on natural CONGRATULATIONS! gas or propane gas only. The use of other fuels or combination of fuels will degrade the performance In selecting this LENNOX Direct-Vent Gas Appliance you have chosen the fi nest and most of this system and may be dangerous. dependable fi replace to be found anywhere. Its a beautiful, prestigious alternative to a Millivolt Models - BTU Input wood burning fi replace. Welcome to a Family of tens of thousands of satisfi ed LEN
Resumen del contenido incluido en la página 4
Gas Pressure - At the time of installation, it must be determined Gas Controls/Control Compartment Tables 4, 5 and 6 show the appliances' gas Access if the appliance needs to be derated. Contact pressure requirements. your local gas supplier for deration requirements The gas controls can be found behind the control for your area. compartment access door. Inlet Gas Supply Pressure (all models) Deration - At higher elevations, the amount of Removing Control Compartment Door: BTU fuel value
Resumen del contenido incluido en la página 5
I O O L I P T O IGNITER it OFF ON CONTROL TPTH TP TH L I I P H F F L F F O Millivolt Appliances - Appliances with Electronic Appliances - If your electronic appliance is equipped with an Millivolt systems will be fi tted with the gas optional remote wall switch or remote control kit To light electronic appliances refer to the detailed the appliance main burner may be turned on and control valve shown in Figures 4 or 5. lighting instructions found on Pages 20 & 21 off with the wall switch or
Resumen del contenido incluido en la página 6
If the venting system is disassembled for any 3. Keep the lower control compartment clean Clean Logs And Burner reason, a qualifi ed service technician should by vacuuming or brushing at least twice a Carefully remove the logs (use care when han- follow vent installation instructions for proper year. More frequent cleaning may be required dling the fi ber logs, as they become quite fragile reassembly and proper sealing of the venting due to excessive lint from carpeting, bedding after curin
Resumen del contenido incluido en la página 7
These are direct-vent appliances. They are Removing Glass Enclosure Panels Front Glass Enclosure Panel, Removal designed to operate only when the front glass (see Figure 6) and Installation enclosure panel is installed. Generally the front glass enclosure panel should not be removed 1. Remove the top louver assembly by pulling except to gain access to the components within it up and out. WARNING the fi rebox, and the appliance may only be op- Do not operate appliance with the erated wit
Resumen del contenido incluido en la página 8
1. Place the rear log (A) as shown. Position the INSTALL VERMICULITE, VOLCANIC 2 notches on the bottom of the log over the WARNING STONE, GLOWING EMBERS AND LOGS 2 corresponding locating brackets against the back wall of fi rebox. The size and position of the log 1. Remove the front glass enclosure panel 2. Place the left log (B) as shown. The notch (see Removing Glass Enclosure Panels on set was engineered to give the on the bottom of the log should fi t over the this page). appl
Resumen del contenido incluido en la página 9
MODEL LMDV-3328 & LMDV-3530 Log Placement Instructions A LOG SET Catalog Number H3366 * Item Description A Log, Rear B Log, Left C Log, Left Center D Log, Right Center E Log, Right D * Item "letters" above correspond to photos B C E Install the Embers, Vermiculite, Volcanic Stone and Logs in the order shown here (1 through 6) and per the instructions on Page 8. DO NOT PLACE EMBERS OVER GAS SLOTS 1 4 Embers Hole on bot- tom of log (E) A fi ts over pin Volcanic on log (A). Stone V-Shape are
Resumen del contenido incluido en la página 10
MODEL LMDV-4035 Log Placement Instructions LOG SET A Catalog Number H3365 * Item Description A Log, Rear B Log, Left C Log, Center C D Log, Center Front B E Log, Right E * Item "letters" above correspond to photos D Install the Embers, Vermiculite, Volcanic Stone and Logs in the order shown here (1 through 6) and per the instructions on Page 8. 1 DO NOT PLACE EMBERS OVER GAS SLOTS 4 Embers Volcanic Stone Vermiculite B Notch on log bottom Place log over pins 2 fi ts over bracket C 5 Pin Pin
Resumen del contenido incluido en la página 11
BURNER ADJUSTMENTS (QUALIFIED TECHNICIANS ONLY) Flame Appearance and sooting Proper fl ame appearance is a fl ame which is blue at the base and becomes yellowish-orange in the body of the fl ame. When the appliance is fi rst lit, the entire fl ame may be blue and will gradually turn yellowish-orange during the fi rst 15 minutes of operation. If after a short period the fl ame stays lowered blue, or if the fl ame is orange with evidence of sooting (black tip), the air shutter opening may need
Resumen del contenido incluido en la página 12
Burner Air Shutter Adjustment Procedure SIT MILLIVOLT PILOT ASSEMBLY CAUTION Proper Pilot Flame Appearance 1. Locate adjustment rod and adjust air shutter Igniter Rod Hood to the standard setting as shown in Figure Carbon will be produced if the air 12 (adjustment rod is located in the lower shutter is closed too much. Any control compartment). Note: Rotating the damage due to carboning result- Thermocouple adjustment rod clockwise decreases air and 3/8" Min. ing from improperly sett
Resumen del contenido incluido en la página 13
TH TH TP TP WIRING DIAGRAMS Electronic Wiring Diagram (Honeywell) Showing Blower Wiring for Optional FBK-100, FBK-200 & FBK-250 Kits Schematic Representation Only Wiring diagrams are provided here for refer- ence purposes only. This information is also Wall Mounted Blower Speed Control Switch or ON/OFF Switch for Blower Kit (optional) Auxiliary View A provided on schematics attached directly to the J-Box Wiring when Relay Module C/W FBK-250 only. Plug blower appliance on a pullout panel lo
Resumen del contenido incluido en la página 14
ACCESSORY COMPONENTS Product Reference Information Cat. Model Ship. Ship. No. Weight Volumn H3313 LMDVT-3328CNM 95 lb. 13.08 cu. ft. H3314 LMDVT-3328CPM 95 lb. 13.08 cu. ft. H3315 LMDVR-3328CNM 95 lb. 13.08 cu. ft. H3316 LMDVR-3328CPM 95 lb. 13.08 cu. ft. H3317 LMDVT-3328CNE 95 lb. 13.08 cu. ft. H3318 LMDVR-3328CNE 95 lb. 13.08 cu. ft. H3319 LMDV-3530CNM 113 lb. 15.75 cu. ft. H3320 LMDV-3530CPM 113 lb. 15.75 cu. ft. H3321 LMDV-3530CNE 113 lb. 15.75 cu. ft. Standard Remote Control System Deluxe R
Resumen del contenido incluido en la página 15
ACCESSORY COMPONENTS Style View Doors - Arch Design Kits Cat. No. Model Model Model Series Arch Design H0858 AD35C 35” Arch Doors, Charcoal H0859 AD35TI 35” Arch Doors, Textured Iron LMDV-3530 H0860 AD35SP 35” Arch Doors, Satin Pewter H0861 AD35AB 35” Arch Doors, Antique Brass H0862 AD40C 40” Arch Doors, Charcoal H0863 AD40TI 40” Arch Doors, Textured Iron LMDV-4035 H0864 AD40SP 40” Arch Doors, Satin Pewter H0865 AD40AB 40” Arch Doors, Antique Brass Style View Doors - Arch Pane Design Kits H0930
Resumen del contenido incluido en la página 16
ACCESSORY COMPONENTS White Wall Switch Kit Cat. No. Model No. Description 85L87 FWSK OFF/ON Wall Switch Kit Forced Air Blower Kits 4 Piece Trim Kit OFF/ON Wall Switch Kit Cat. Model No. Description No. The OFF/ON wall switch kit may be used to control Cat. No. Model No. Description the operation of the fi replace burner. Install the 80L84 FBK-100 Blower, Standard 35” 4 Piece Finish Trim Kit, OFF/ON wall switch in a convenient location near 96K17 TK35PB4 (single speed) Polished Brass, LMDV-353
Resumen del contenido incluido en la página 17
P A ACCESSORY COMPONENTS * Assembled 8-Piece Louver Kits Polished Brass Brushed Stainless Models Where Used Cat. # Model Cat. # Model LMDVT-3328 H1522 LK-400B H1523 LK-400BS LMDVR-3328 I LMDV-3530 H1524 LK-500B H1525 LK-500BS LMDV-4035 H1526 LK-600B H1527 LK-600BS (ref. Form # 750,166M) * Lennox Nameplate Logo, 12L15, is sold separately. Polished Brass & Brushed Stainless Louvers Kits These kits include a top 4-louver assembly and a bottom 4-louver assembly. They provide a touch of elegance.
Resumen del contenido incluido en la página 18
I O O L I P T O it TPTH TP TH L I P I F F L H F F O LIGHTING INSTRUCTIONS – HONEYWELL AND SIT MILLIVOLT GAS VALVE FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. This appliance has a pilot which must be lighted with a piezo • Do not use any phone in your building. igniter. When lighting the pilot, follow these instructions • Immediately call your gas suppl
Resumen del contenido incluido en la página 19
I O O L I P T O it TPTH TP TH L I P I F F L H F F O INSTRUCTIONS D’ALLUMAGE – VANNE GAZ MILLIVOLT HONEYWELL ET SIT POUR VOTRE SÉCURITÉ, LISEZ CES INSTRUCTIONS AVANT L’ALLUMAGE AVERTISSEMENT : SI VOUS NE SUIVEZ PAS CES INSTRUCTIONS À LA LETTRE, IL POURRAIT S’EN SUIVRE UN INCENDIE OU UNE EXPLOSION CAUSANT DES DOMMAGES MATÉRIELS, DES BLESSURES CORPORELLES OU MÊME DES PERTES DE VIE. A. Cet appareil est muni d’une veilleuse qui doit être allumée avec un • Appelez immédiatement votre compagnie de gaz
Resumen del contenido incluido en la página 20
IGNITER OFF ON CONTROL LIGHTING INSTRUCTIONS — ELECTRONIC FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A. When lighting the appliance, follow these instructions • Immediately call your gas supplier from a neighbor’s exactly. phone. • If your gas supplier cannot be reached, call the fi re B. BEFORE OPERATING smell all around the appliance area department. f
