Resumen del contenido incluido en la página 1
DO NOT
DISCARD
Owner’s Manual
Installation and Operation
Models:
FL92 Multi-Sided
Woodburning Fireplace
NOTICE
DO NOT DISCARD THIS MANUAL
• Read, understand • Leave this manual with
• Important operating
and follow these party responsible for
a n d m a i n t e n a n c e
instructions for safe use and operation.
instructions included.
i n s t a l l a t i o n a n d
operation.
WARNING
WARNING
HOT SURFACES!
If the information in these instruc-
tions is not followed exactly, a Screen/mesh, glass
Resumen del contenido incluido en la página 2
Read this manual before installing or operating this fireplace. Please retain this owner’s manual for future reference. Congratulations! Congratulations on selecting a Heatilator wood burning This owner’s manual should be retained for future refer- fireplace. The Heatilator fireplace you have selected is ence. We suggest you keep it with your other important designed to provide the utmost in safety and reliability. documents and product manuals. As the owner of a new fireplace, you’ll want to r
Resumen del contenido incluido en la página 3
Safety Alert Key: ! • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTION! Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury. • NOTICE: Indicates practices which may cause damage to the fireplace or to property. Table of Contents Congratulations! 2 7 Installation of Fireplace 21 Limite
Resumen del contenido incluido en la página 4
Limited Warranty Hearth & Home Technologies Inc. LIMITED LIFETIME WARRANTY Hearth & Home Technologies Inc., on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within two years f
Resumen del contenido incluido en la página 5
WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. • Contact your installing dealer for warranty service. If the installing dealer is unable to provide necessary parts, contact the nearest HHT authorized dealer or supplier. Additional service
Resumen del contenido incluido en la página 6
Listing and Code Approvals 1 B. Non-Combustible Materials A. Appliance Certification • Materials which will not ignite and burn, composed of any combination of the following: This fireplace system has been tested and listed in accor- - Steel - Iron dance with UL 127 standards by Underwriters Laborato- - Brick - Tile ries Inc. for installation and operation in the United States. - Concrete - Slate This fireplace may be installed in sleeping rooms EX- - Glass - Plasters CEPT in manufactured h
Resumen del contenido incluido en la página 7
User Guide Operating Instructions 2 WARNING HOT SURFACES! Glass and other surfaces are hot during operation AND cool down. Hot glass will cause burns. • DO NOT touch glass until it is cooled • NEVER allow children to touch glass • Keep children away • CAREFULLY SUPERVISE children in same room as fi replace. • Alert children and adults to hazards of high temperatures. High temperatures may ignite clothing or other fl ammable materials. • Keep clothing, furniture, draperies and other fl ammable
Resumen del contenido incluido en la página 8
B. Seasoned Wood D. Grate Properly seasoned wood is important for successful This fireplace is designed to be used with the grate sup- operation of your fireplace. Most woodburning fireplace plied with this unit or one approved by HHT. The grate will problems are caused by burning wet, unseasoned wood. break down over time and will need occasional replace- ment. Seasoned firewood is wood that is cut to size, split and air dried to a moisture content of around 20%. WARNING! Risk of Fire! Use o
Resumen del contenido incluido en la página 9
H. Glass Doors J. Vented Gas Log Sets & Gas Log Lighters • Optional • Glass doors are optional. • Vented gas logs or gas log lighters can be installed in • Refer to Figure 2.2 for how to properly use them. this fi replace. Follow the instructions provided with the WARNING! Risk of Fire! Install ONLY doors ap- accessory for operation. proved by Hearth & Home Technologies, Inc. WARNING! Risk of Fire or Asphyxiation! WARNING! Risk of Fire and Smoke! Fireplaces • DO NOT install unvented gas l
Resumen del contenido incluido en la página 10
M. Wood Fuel Seasoned Wood • Cut logs to size Hardwood vs Softwood • Split to 6 in. (152 mm) or less Your fireplace performance depends on the quality of the • Air dry to a moisture content of around 20% firewood you use. - Soft wood - about nine months • Seasoned wood contains about 8,000 BTUs per pound - Hard wood - about eighteen months . • Hard woods are more dense than soft woods. NOTICE: Seasoning time may vary depending on drying • Hard woods contain 60% more BTUs than soft woods. co
Resumen del contenido incluido en la página 11
Maintenance and Service 3 B. Chimney Inspection/Cleaning A. Disposal of Ashes Frequency: At least twice a year during heating season Frequency: When they reach bottom of grate or as recommended by a certified chimney sweep By: Homeowner By: Certified chimney sweep WARNING! Risk of Fire! Ashes could contain hot em- WARNING! Risk of Fire! Ignited creosote is extremely bers. HOT. Prevent creosote buildup. • Place ashes in a metal container with a tight-fitting lid. Refer to Figure 3.1 to remove
Resumen del contenido incluido en la página 12
C. Check Firebox Refractory Frequency: After each ash removal By: Homeowner WARNING! Risk of Fire! Inspect fireplace refractory. Crumbling, deteriorated refractory can allow overheating of surrounding materials. Expansion and contraction will cause minor cracking of the refractory. This is normal. The refractory will require periodic replacement depending on use. The panels should be replaced if • Cracks exceed ¼ inch (6 mm) in width, • Metal is exposed behind the refractory, • Large piece
Resumen del contenido incluido en la página 13
Troubleshooting Guide 4 Start Fire Problems Possible Cause Solution Can’t get fire started Not enough kindling/paper or no Use dry kindling, more paper. Arrange kindling & Excessive smoke or spillage kindling/paper wood for air movement. Burns too slowly Damper closed/not fully open Open damper. Smolders, sizzles Not enough air for fire to ignite Check for restricted cap/shroud. Open air kit (if installed). Check for flue blockage. Pre-warm flue before starting fire (refer to starting fire
Resumen del contenido incluido en la página 14
) ) ) ) ) ) Installer Guide Getting Started 5 A. Typical Fireplace System Additional lateral NOTICE: support for chimney • Illustrations and photos reflect typical installations above roof (or enclosed and are for design purposes only. in chase) if needed • Illustrations/diagrams are not drawn to scale. (Section 8) • Actual product may vary from pictures in manual. Termination cap Non-combustible (Section 8 & 9) roof flashing maintains Storm Collar minimum clearance (Section 8) around chimn
Resumen del contenido incluido en la página 15
B. Design and Installation Considerations D. Negative Pressure WARNING! Risk of Asphyxiation! Negative pressure NOTICE: Check building codes prior to installation. can cause spillage of combustion fumes and soot. Fire must draft properly for safe operation. • Installation MUST comply with local, regional, state and national codes and regulations. Negative pressure results from the imbalance of air avail- • Consult insurance carrier, local building inspector, fire able for the fireplace to op
Resumen del contenido incluido en la página 16
E. Locating Fireplace & Chimney Location of the fireplace and chimney will affect perfor- mance. • Install within the warm airspace enclosed by the building envelope. This helps to produce more draft, especially during lighting and die-down of the fire. • Penetrate the highest part of the roof. This minimizes the effects of wind loading. • Locate termination cap away from trees, adjacent structures, uneven roof lines and other obstructions. • Minimize the use of chimney offsets. • Consider
Resumen del contenido incluido en la página 17
F. Tools and Supplies Needed H. Inspect Fireplace and Components WARNING! Risk of Fire and/or Explosion! Damaged Before beginning the installation be sure the following parts could impair safe operation. DO NOT install dam- tools and building supplies are available: aged, incomplete or substitute components. Keep fire- Reciprocating saw Framing material place dry. Pliers Non-combustible sealant • Remove fireplace and components from packaging and inspect for damage. Hammer Gloves • Vent syste
Resumen del contenido incluido en la página 18
Framing & Clearances 6 A. Select Fireplace Location 12 in. (305 mm) 62 in. from opening of Note: 1/2 in. min. (13 mm) (1575 mm) fireplace distance from fireplace to 16 in. combustible materials. (406 mm) In addition to these Note: framing dimensions, also reference the following sections: 56 in. (1422 mm) • Clearances • Mantel Projections • Fireplace Dimensions HEARTH EXTENSION (shaded) 64 in. (1626 mm) Figure 6.1 Fireplace Locations 18 Heatilator • FL92 Multi-Sided Woodburn
Resumen del contenido incluido en la página 19
B. Clearances WARNING! Risk of Fire! You must comply with all minimum air space clearances to combustibles as specified in Fig- ure 6.2. DO NOT pack required air spaces with insulation or other materials. Storm Collar Roof Flashing Shaded areas represent 2 in. (51 mm) min. air space clearance required around pipe (attic) Attic Insulation Shield (insulation) (ceiling) Offset/Return (secured 2 in. (51 mm) min. with hanger straps) (ceiling) Ceiling Firestop Must have 2 in. (51 mm) minimum cl
Resumen del contenido incluido en la página 20
39° angle C. Sidewalls/Surrounds • Adjacent combustible sidewalls must be located a minimum of 12 in. (305 mm) from the fireplace opening. • Combustible and non-combustible mantel legs, surrounds and stub walls may be constructed within the gridded area, Figure 6.3. 4 in. [102 mm] 11.92 in. 36 in. 36 in. 9 3/4 in. [303 mm] [914 mm] [914 mm] [248 mm] (fireplace opening) (fireplace opening 40 in. 40 in. FLUSH [1016 mm] [1016 mm] BRICK FRONT FRONT 12 in. 12 in. [305 mm] [305 mm] Figure 6.3 Mantel
