Resumen del contenido incluido en la página 1
Owner’s Manual
Model
DF2608
NBDF2608
DF2622SS
DF2622BLK
IMPORTANT SAFETY INFORMATION: Always read this manual first
before attempting to install or use this fireplace. For your safety, always
comply with all warnings and safety instructions contained in this manual
to prevent personal injury or property damage.
To view the full line of Dimplex products, please visit
www.dimplex.com
7208680100R06
Resumen del contenido incluido en la página 2
Table of Contents Welcome & Congratulations . . . . . . . . . . . . . . . . .3 ImPor TAnT InsTruCTIons . . . . . . . . . . . . . . .4 Fireplace Installation .......................7 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11 maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . .13 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17 replacement Parts . . . . . . . . . . . . . . . . . . . . . . . .20 Always use
Resumen del contenido incluido en la página 3
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty. Please record your model and serial numbers below for future reference: model
Resumen del contenido incluido en la página 4
IMPORTANT INSTRUCTIONS ① read all instructions before using ⑨ Do not operate any unit with a damaged cord or plug, or if the the electric fireplace. heater has malfunctioned, or if the ② This fireplace is hot when in use. electric fireplace has been dropped To avoid burns, do not let bare skin or damaged in any manner. Contact touch hot surfaces. The trim around Dimplex Technical service 1-888-346- the heater outlet becomes hot during 7539. heater operation. ⑩ Do not use outdoors. ③
Resumen del contenido incluido en la página 5
IMPORTANT INSTRUCTIONS ⑯ Do not insert or allow foreign ⑳Avoid the use of an extension objects to enter any ventilation or cord. Extension cords may overheat exhaust opening as this may cause and cause a risk of fire. If you must an electric shock or fire, or damage to use an extension cord, the cord shall be no. 14 AWG minimum size and the heater. rated not less then 1875 Watts. ⑰ Although this unit is of zero ㉑ Do not burn wood or other clearance design, to prevent a materials in
Resumen del contenido incluido en la página 6
IMPORTANT INSTRUCTIONS operation is subject to the following ! NOTE: This equipment has been two conditions: (1) this device may tested and found to comply with not cause interference and; (2) this the limits for Class B digital device, device must accept any interference, pursuant to part 15 of the FCC including interference that may cause rules. These limits are designed to undesired operation of the device. provide reasonable protection against harmful interference in a res
Resumen del contenido incluido en la página 7
Fireplace Installation WARNINg: Ensure the power Fireplace Assembly cord is not installed so that The only assembly required is it is pinched or against any to slide the Front Glass onto the sharp edges and ensure that fireplace and install hardware to the power cord is stored or keep it in place. secured to avoid tripping or 1. remove fireplace and glass snagging to reduce the risk of carefully from the carton, fire, electric shock or injury to discard the plastic bag and pers
Resumen del contenido incluido en la página 8
Fireplace Installation the fireplace (Figure 2). the fireplace near an existing outlet (refer to noTE 1). 5. Place the Front Glass onto the track of the fireplace 3. store the fireplace in a safe (Figure 2) and slide it along dry and dust free location. the front until it reaches the CAUTION: Clearance for far left of the unit. air circulation beneath the 6. re-attach the right hand trim fireplace is provided by two piece using the three (3) (2) spacers. Do not install Philips sc
Resumen del contenido incluido en la página 9
Fireplace Installation Dimensions without trim are 26 New Wall Construction ¼ inch (663 mm) wide x 22 ⅞ 1. select a suitable location that inch (580 mm) high x 8 ¾ inch is not susceptible to moisture (222 mm) deep. The fireplace and is away from drapes, does not require any additional furniture and high traffic. venting (Figure 3). 2. Place the fireplace in the desired location to see how it Fireplace Insert will look in the room. Installation 3. mark the desired location on Inst
Resumen del contenido incluido en la página 10
Fireplace Installation Option #2: A new outlet can be surfaces which may restrict installed inside the framing air circulation. If installing construction. the fireplace in a carpeted area, place a one-piece, solid, Plug the unit into a 15 Amp, 120 flat surface under the fireplace Volt outlet. If the cord does not insert. Ensure that all feet rest reach, you may use an extension securely on this surface. cord rated for a minimum of 1875 Watts. For Bathroom Use If this unit is in
Resumen del contenido incluido en la página 11
Operation Figure 5 A D B E C Electric Fireplace Manual C. Light Dimmer Control Controls (Figure 5) Turn the Light Dimmer Control The manual controls for the knob to increase or decrease the fireplace are behind the access brightness of the interior of the panel located at the bottom of the fireplace. fireplace. D. Heater On/Off Switch A. Three Position On/Off The Heater on/off switch Switch supplies power to the heating The switch has two (2) on unit when the Three Position on
Resumen del contenido incluido en la página 12
Operation To turn the heater off, rotate the Three Position On/Off knob fully counter clockwise. Switch on the fireplace is set to the remote control setting (“ II ”position). Resetting the Temperature To operate, push the on button Cutoff Switch to turn the fireplace on, push the This unit is equipped with a oFF button to turn the fireplace thermostat which controls the off. temperature of the room by turning the heater on and off. The Battery Replacement (Figure 6) heater is prot
Resumen del contenido incluido en la página 13
Operation on button located on the Figure 6 remote control transmitter. ! NOTE: You will have only 10 seconds to perform this last step. Failure to do so will OFF result in these steps needing Button to be followed again. ON This will synchronize the remote Button control transmitter and receiver. Battery Cover Maintenance WARNINg: Disconnect power flames and embers, and two (2) before attempting any bulbs above that illuminate the log maintenance or cleaning to exterior. re
Resumen del contenido incluido en la página 14
Maintenance Figure 7 Figure 8 Log Ember Bed Back Trim Ledge Rear Log Set Front Tab Assembly Glass Front side section Edge the number of times you need the log set assembly by the to open the unit to replace light ember bed or plastic grate. bulbs. Care must be taken when removing the Log set assembly ! NOTE: Log set assembly fits as it contains LED’s and wires tightly into firebox, some force (DF2608 only). may be necessary to remove. 1. slide fireplace out of mantel. 7. Set log set
Resumen del contenido incluido en la página 15
Maintenance clockwise. and attach trim. 12. replace light filter bracket Upper Light Bulb Requirements and flicker rod. Quantity of two (2) clear 13. Install the log set assembly by chandelier or candelabra bulbs placing the front, bottom edge with an E-12 (small) socket base, of the ember bed in the track 15 Watt rating. behind the control panel. Do not exceed 25 Watts per once in place, push down on bulb. the back edge of the ember To access the upper light bulb bed until the r
Resumen del contenido incluido en la página 16
Maintenance of the fireplace to remove glass Cleaning (Figure 7). The glass is cleaned in the factory 6. upper bulbs are located in during the assembly operation. the upper left and upper right During shipment, installation, corners of fireplace, behind handling, etc., the clear door may the light block bracket (Figure collect dust particles, these can 9). be removed by dusting lightly with a clean dry cloth. 7. Remove the four (4) Phillips screws that attach the light To remove
Resumen del contenido incluido en la página 17
Warranty defects in material and workmanship for Two Year Limited Warranty a period of 2 years from the date of the Products to which this limited warranty first purchase of such products as follows: applies (a) a repair or replacement warranty on This limited warranty applies to your newly defective products or parts, including purchased Dimplex electric fireplace. This in-home services, for the first year following the date of first purchase; and (b) limited warranty applies only
Resumen del contenido incluido en la página 18
Warranty operation with an incorrect power source. refund the purchase price for such product or part. This limited warranty entitles the purchaser to on-site or in- What you must do to get service under home warranty services. Accordingly, this limited warranty Dimplex will be responsible for all Defects must be brought to the attention of labour and transportation costs Dimplex Technical service by contacting associated with the repair or Dimplex at 1-888-DImPLEX (1-888- replaceme
Resumen del contenido incluido en la página 19
Warranty costs. such costs shall not be the ConsEQuEnTIAL, or InCIDEnTAL responsibility of Dimplex. Loss, CosT, or DAmAGE ArIsInG ouT oF or In ConnECTIon WITH • For surrounds (mantels) and trims THE sALE, mAInTEnAnCE, usE, or for the period ending at midnight on InABILITY T o usE THE ProDuCT, the first anniversary of the date of EVEn IF DImPLEX or ITs DIrECT ors, first purchase, Dimplex will in its sole oFFICErs, or AGEnTs HAVE BEEn discretion either repair or replace such ADVIsED
Resumen del contenido incluido en la página 20
Replacement Parts Log Set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0439560100RP Flicker motor. ..................................... 3000240200KIT Heater Assembly (Built-in Cutout) ..................... 2000330100RP Thermostat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2300150100RP main on/off switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2800071100RP manual Heat selection switch ..................
