Resumen del contenido incluido en la página 1
quick start manual
®
EDGE 800
TOUCHSCREEN GPS-ENABLED BIKE COMPUTER
Resumen del contenido incluido en la página 2
© 2010 Garmin Ltd. or its subsidiaries content without obligation to notify any person or organization of such changes or improvements. Visit All rights reserved. Except as expressly provided the Garmin Web site (www.garmin.com) for current herein, no part of this manual may be reproduced, updates and supplemental information concerning copied, transmitted, disseminated, downloaded the use and operation of this and other Garmin or stored in any storage medium, for any purpose products.
Resumen del contenido incluido en la página 3
™ 8. Get Garmin Connect or Garmin Getting Started ® Training Center software warninG (page 9). Always consult your physician before 9. Transfer history to your computer you begin or modify any exercise (page 10). program. See the Important Safety and Product Information guide in the about the Battery product box for product warnings and other important information. warninG This product contains a lithium-ion ® When using your Edge the first time, battery. See the Important Safety
Resumen del contenido incluido en la página 4
3. Plug the small end of the AC Charging the Edge charger into the mini-USB port. notice To connect the device to your To prevent corrosion, thoroughly computer using the USB cable, see dry the mini-USB port, the weather page 10. cap, and the surrounding area before 4. Charge the device completely. charging or connecting to a computer. A fully charged battery can run for 1. Plug the AC charger into a standard up to 15 hours before it must be wall outlet. recharged. 2. Pull up the we
Resumen del contenido incluido en la página 5
6. Press down slightly and turn the 2. Place the rubber disk ➊ on the back Edge clockwise until it locks into of the bike mount. place. The rubber tabs align with the back of the bike mount so it stays in place. ➊ ➌ releasing the Edge 1. Turn the Edge clockwise to unlock the device. ➋ 2. Lift the Edge off the mount. 3. Place the bike mount on the bike stem. Turning on the Edge 4. Attach the bike mount securely Press and hold . using the two bands ➋. 5. Align the tabs on the back of t
Resumen del contenido incluido en la página 6
Keys Configuring the Edge The first time you turn on the Edge, you are prompted to configure system settings and user profile settings. • Follow the on-screen instructions to complete the initial setup. ™ • Activate and pair the ANT+ sensors during configuration, if your Edge included a heart rate monitor and a GSC 10: ◦ If you have a heart rate monitor, select Yes. For setup information, see page 5. Press and hold to turn the ◦ If you have a speed and cadence device on and off. sen
Resumen del contenido incluido en la página 7
Touchscreen Buttons Locating Satellite Signals It may take 30–60 seconds to locate Select to view satellites and satellite signals. open the GPS settings menu. Select to open the settings 1. Go outdoors to an open area. menu. 2. Make sure that the front of the When viewing a course, select to view additional features. device is oriented toward the sky. Select to delete a course, 3. Wait while the device searches for workout, or activity. satellites. Select to close the page Do not begi
Resumen del contenido incluido en la página 8
1. Connect the heart rate monitor After you put on the heart rate monitor, module ➊ to the strap. it is on standby and ready to send data. When the heart rate monitor is paired, ➊ a message appears, and appears solid on the status page. 2. Wet both electrodes ➋ on the installing the GSC 10 back of the strap to create a strong NOTE: If you do not have a GSC 10, connection between your chest and you can skip this task. the transmitter. Both magnets must be aligned with ➋ their respecti
Resumen del contenido incluido en la página 9
➓ ➍ ➏ ➌ ➊ ➎ 4. Unscrew the spoke magnet ➐ from ➋ the plastic piece. 2. Loosely attach the GSC 10 using two cable ties ➋. 3. Attach the pedal magnet ➌ to the crank arm using the adhesive mount ➐ and a cable tie ➍. ➑ The pedal magnet must be within 5 mm of the GSC 10. The ➒ indication line ➎ on the pedal magnet must line up with the indication line ➏ on the GSC 10. Edge 800 Quick Start Manual 7
Resumen del contenido incluido en la página 10
5. Place the spoke in the groove of the 9. Pedal to test the sensor alignment. plastic piece, and tighten it slightly. The red LED blinks each time the The spoke magnet can face away pedal magnet passes the sensor. from the GSC 10 if there is not The green LED blinks each time enough room between the sensor the spoke magnet passes the sensor arm and the spoke. The spoke arm. magnet must line up with the NOTE: The LED blinks for indication line ➑ on the sensor the first 60 passes after a
Resumen del contenido incluido en la página 11
Going for a ride Saving Your ride Data Before you can record history, you Press and hold RESET to save must locate satellite signals (page 5) or your ride data and reset the timer. ™ pair your Edge with an ANT+ sensor. Using Free Software Garmin provides two software options for storing and analyzing your ride data. • Garmin Connect is Web-based software. • Garmin Training Center is computer software that does not require the Internet after installation. 1. From the timer page, press S
Resumen del contenido incluido en la página 12
4. Open Garmin Connect Transferring History to (www.garminconnect.com), or open Your Computer Garmin Training Center. notice 5. Follow the instructions included To prevent corrosion, thoroughly with the software. dry the mini-USB port, the weather cap, and the surrounding area before Following a Course From charging or connecting to a computer. the w eb 1. Connect the USB cable to an 1. Connect the Edge to your computer. available USB port on your 2. Go to www.garminconnect.com, co
Resumen del contenido incluido en la página 13
3. Select the number of data fields you Saving Your Location want to see on the page. You can save your present location, such as your home or parking spot. To turn off an optional page, set the Before you can save your location, you number of data fields to Off. must locate satellite signals (page 5). 4. Select a data field to change it. 1. From the map, select the position Edge Temperature readings icon . You can customize the Edge to display The position icon represents your temperat
Resumen del contenido incluido en la página 14
Locking the Touchscreen Troubleshooting To avoid accidental screen touches, resetting the Device you can lock the touchscreen. If the keys or screen stop responding, you may need to reset the device. 1. Press . The status page appears. Press and hold for 10 seconds. 2. Select Lock. This does not erase any of your data or settings. Training with Power Meters • See the Edge 800 Owner’s Manual, Clearing User Data for more information. NOTE: This deletes all user-entered information, but it d
Resumen del contenido incluido en la página 15
3. Open the Garmin\Documents Contacting Garmin Product folder or volume. Support You can contact Garmin Product 4. Double-click the START HERE Support if you have any questions .html file. about this product. Getting the Manuals from the w eb • In the USA, go to www.garmin 1. Go to www.garmin.com/intosports. .com/support, or contact Garmin 2. Select your product. USA by phone at (913) 397.8200 or 3. Click Manuals. (800) 800.1020. Buying Optional accessories • In the UK, contact Garmin (Eu
Resumen del contenido incluido en la página 16
For the latest free software updates (excluding map data) throughout the life of your Garmin products, visit the Garmin w eb site at www.garmin.com. © 2010 Garmin Ltd. or its subsidiaries Garmin International, Inc. st Street, Olathe, Kansas 66062, USA 1200 East 151 Garmin (Europe) Ltd. Liberty House, Hounsdown Business Park, Southampton, Hampshire, SO40 9LR UK Garmin Corporation nd No. 68, Jangshu 2 Road, Sijhih, Taipei County, Taiwan September 2010 Part Number 190-01267-01 Rev. A Printed i
